Hostname: page-component-78c5997874-94fs2 Total loading time: 0 Render date: 2024-11-10T07:31:24.448Z Has data issue: false hasContentIssue false

Pressure and force distributions on a sharp-nosed circular cylinder at large angles of inclination to a uniform subsonic stream

Published online by Cambridge University Press:  11 April 2006

P. J. Lamont
Affiliation:
Department of Aeronautical Engineering, University of Bristol, England
B. L. Hunt
Affiliation:
Department of Aeronautical Engineering, University of Bristol, England

Abstract

This paper reports an experimental investigation of pressure and force distributions on a sharp-nosed circular cylinder inclined to a uniform low-speed air flow under conditions of laminar separation of the boundary layer. The main concern is with the out-of-plane force (i.e. the side force if the body is at incidence). The experimental model consisted of an extensively pressure-tapped cylinder to which four different noses were fitted. The results show that there is an oscillatory distribution of out-of-plane force along the cylinder for most of the inclination range 0-90°. The amplitude of this distribution is strongly affected by nose shape in conditions where the out-of-plane force extends onto the nose. At very high angles of inclination the oscillatory distribution disappears and is replaced by a vortex pattern like that found on an infinite yawed cylinder. The general nature of the out-of-plane force is found to be consistent with the impulsively started flow analogy. Unsteadiness in the flow was found to cause a serious reduction in many of the time-averaged values. The unsteadiness is ascribed to the switching of the flow pattern due to free-stream turbulence. Measurements of the time histories of certain pressures enabled values of the force in the unswitched state to be calculated. The Reynolds number was found to have an important influence at inclinations above 55°. However, it was also found that the range of Reynolds numbers over which this effect occurs can depend on the scale of the model.

Type
Research Article
Copyright
© 1976 Cambridge University Press

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

Allen, H. J. & Perkins, E. W. 1951 N.A.C.A. Rep. no. 1048.
Atraghji, E. G. 1967 Nat. Res. Counc. Can. NAE Data Rep. no. 5 $5/0020.
Bostock, B. R. 1972 Slender bodies of revolution at incidence. Ph.D. thesis, University of Cambridge.
Bursnal, W. J. & Loftin, L. K. 1951 N.A.C.A. Tech. Note, no. 2463.
Coe, P. L., Chambers, J. R. & Letko, W. 1972 N.A.S.A. Tech. Note, no. D-7095.
Drescher, H. 1956 Z. Flugwiss. 4, 17.
Gerrard, J. H. 1961 J. Fluid Mech. 11, 244.
Jorgensen, L. H. & Nelson, E. R. 1975 N.A.S.A. Tech. Memo. no. X-3128.
Lamont, P. J. 1973 The out-of-plane force on an ogive nosed cylinder at large angles of inclination to a uniform stream. Ph.D. thesis, University of Bristol.
Lamont, P. J. & Hunt, B. L. 1973 J. Roy. Aero. Soc. 77, 41.
Munk, M. M. 1924 N.A.C.A. Rep. no. 184.
Pick, G. S. 1971 A.I.A.A. Paper, no. 71–570.
Sarpkaya, T. 1966 A.I.A.A. J. 4, 414.
Surry, J. & Surry, D. 1967 U.T.I.A. Tech. Note, no. 116.
Thomson, K. D. 1972 Austr. W.R.E. Rep. no. 782.
Thomson, K. D. & Morrison, D. F. 1969 Australian WRE Rep. no. HSA 25.
Thomson, K. D. & Morrison, D. F. 1971 J. Fluid Mech. 50, 751.
Townsend, A. A. 1956 The Structure of Turbulent Shear Flow. Cambridge University Press.
Tunstall, M. J. & Harvey, J. K. 1968 J. Fluid Mech. 34, 595.
Wardlaw, A. B. 1974 A.I.A.A. J. 12, 1142.