Hostname: page-component-78c5997874-fbnjt Total loading time: 0 Render date: 2024-11-10T16:49:23.030Z Has data issue: false hasContentIssue false
  • English
  • Français

Study of the scale behaviour in the finishing mill to improvethe strip surface quality*

Published online by Cambridge University Press:  15 October 2010

D. Espinosa ,
G. Lannoo ,
J. Malbrancke ,
G. Moreas  and
M. Picard
D. Espinosa
Affiliation:
CRM (Centre for Research in Metallurgy), Technologiepark 903, 9052 Zwijnaarde, Belgium
G. Lannoo
Affiliation:
CRM (Centre for Research in Metallurgy), Technologiepark 903, 9052 Zwijnaarde, Belgium
J. Malbrancke
Affiliation:
CRM (Centre for Research in Metallurgy), Technologiepark 903, 9052 Zwijnaarde, Belgium
G. Moreas
Affiliation:
CRM (Centre for Research in Metallurgy), Technologiepark 903, 9052 Zwijnaarde, Belgium
M. Picard
Affiliation:
ArcelorMittal R&D Maizières, BP 30320, 57283 Maizières-lès-Metz Cedex, France
Get access

Abstract

The cracking behaviour of the oxide layer formed during hot rolling was studied togetherwith different combinations of process parameters in order to find their single influenceon the surface quality and formation of oxide defects. Several trials were performed onthe CRM pilot line to study in detail the impact of strip reduction, strip temperature,entry scale thickness, roll degradation, lubrication, skin cooling, chemical compositionand humidity on the scale behaviour. In general, the degree of deformation, entry scalethickness and rolling temperatures are the most important parameters and the importancedecreases in that order.

Keywords

Scale behaviourSurface qualityOxide scaleHot rollingScale failure.Le comportement de couchela qualité de surfacela calaminele laminage à chaud.
Type
Research Article
Information
Metallurgical Research & Technology , Volume 107 , Issue 6 , June 2010 , pp. 225 - 235
Copyright
© EDP Sciences

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

F. Freidel, H. Bolt, X. Cornet, G. Bourdon, X. Vanden Eynde, E. Zeimetz, S. Ehlers, F. Steinert, Investigation of the formation, constitution and properties of scale formed during the finishing, rolling, cooling and coiling of thin hot strips, ECSC steel RTD project 7210. PR/153, Final report, December 2002
D. Filatov, O. Pawelski, W. Rasp, Hot-Rolling experiments on deformation behaviour of oxide scale, Max-Planck-Institut für Eisenforschung GmbH, Düsseldorf, Germany, 2004
H. Blaas, Methods of determination of strength of scale adhesion, Wire Wold International, vol 23, November/December 1981
M.B. Picque, Experimental study and numerical simulation of iron oxide scale mechanical behaviour in hot rolling, l’École des Mines de Paris
J. Malbrancke, H. Uijtdebroeks, G. Walmag, A new procedure to asses the hot rolling work roll materials, Revue de Métallurgie 10 (2007), p. 512
Shirizly, A., Lenard, J.G., The effect of lubrication on mill loads during hot rolling of low carbon steel strips, J. Mat. Processing Techn. 97 (2000) 61-68 Google Scholar