Hostname: page-component-78c5997874-v9fdk Total loading time: 0 Render date: 2024-11-10T06:39:25.940Z Has data issue: false hasContentIssue false
  • English
  • Français

Deformation Mechanisms in a Rolled Magnesium Alloy Under Tension Along the Rolling Direction

Published online by Cambridge University Press:  28 June 2018

Dewen Hou ,
Tianmo Liu ,
Meng Shi ,
Haiming Wen  and
Haiyan Zhao
Dewen Hou
Affiliation:
School of Materials Science and Engineering, Chongqing University, Chongqing 400044, China Center for Advanced Energy Studies, Idaho Falls, ID 83401, USA
Tianmo Liu*
Affiliation:
School of Materials Science and Engineering, Chongqing University, Chongqing 400044, China
Meng Shi
Affiliation:
Center for Advanced Energy Studies, Idaho Falls, ID 83401, USA Department of Chemical and Materials Engineering, University of Idaho, Idaho Falls, ID 83402, USA
Haiming Wen*
Affiliation:
Department of Materials Science and Engineering, Missouri University of Science and Technology, Rolla, MO 65409, USA
Haiyan Zhao
Affiliation:
Center for Advanced Energy Studies, Idaho Falls, ID 83401, USA Department of Chemical and Materials Engineering, University of Idaho, Idaho Falls, ID 83402, USA
*
*Authors for correspondence: Tianmo Liu, E-mail: tmliu@cqu.edu.cn; Haiming Wen, E-mail: wenha@mst.edu
*Authors for correspondence: Tianmo Liu, E-mail: tmliu@cqu.edu.cn; Haiming Wen, E-mail: wenha@mst.edu
Get access

Abstract

The twinning and slip modes of a rolled magnesium alloy sheet were investigated through quasi-in-situ tensile tests that were carried out along the rolling direction at room temperature with a constant strain rate. Scanning electron microscopy and electron backscattered diffraction observations were used to identify activated twinning and slip systems. Schmid factors were calculated to analyze different deformation modes. The analyses show that a small number of {10-12} tensile twins were present during deformation, and these twins resulted from the accommodation of compression along the tensile direction. Post-deformation examination revealed the dominance of prismatic <a> slip.

Keywords

magnesiumtensiletwinningslip
Type
Materials Science Applications
Information
Microscopy and Microanalysis , Volume 24 , Issue 3 , June 2018 , pp. 207 - 213
Copyright
© Microscopy Society of America 2018 

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Footnotes

Cite this article: Hou D, Liu T, Shi M, Wen H, Zhao H (2018). Deformation Mechanisms in a Rolled Magnesium Alloy Under Tension Along the Rolling Direction. Microsc Microanal24(3): 207–213. doi: 10.1017/S1431927618000284

References

Agnew, SR, Brown, DW and Tomé, CN (2006) Validating a polycrystal model for the elastoplastic response of magnesium alloy AZ31 using in situ neutron diffraction. Acta Mater 54, 4841–4852.CrossRefGoogle Scholar
Agnew, SR and Duygulu, Ö (2005) Plastic anisotropy and the role of non-basal slip in magnesium alloy AZ31B. Int J Plast 21, 1161–1193.CrossRefGoogle Scholar
Atwell, DL, Barnett, MR and Hutchinson, WB (2012) The effect of initial grain size and temperature on the tensile properties of magnesium alloy AZ31 sheet. Mater Sci Eng A 549, 1–6.CrossRefGoogle Scholar
Boehlert, CJ, Chen, Z, Chakkedath, A, Gutiérrez-Urrutia, I, Llorca, J, Bohlen, J, Yi, S, Letzig, D and Pérez-Prado, MT (2013) In situ analysis of the tensile deformation mechanisms in extruded Mg-1Mn-1Nd (wt%). Philos Mag 93, 598–617.CrossRefGoogle Scholar
Boehlert, CJ, Chen, Z, Gutiérrez-Urrutia, I, Llorca, J and Pérez-Prado, MT (2012) In situ analysis of the tensile-creep deformation mechanism in rolled AZ31. Acta Mater 60, 1889–1904.CrossRefGoogle Scholar
Cepeda-Jiménez, CM, Molina-Aldareguia, JM and Pérez-Prado, MT (2015) Effect of grain size on slip activity in pure magnesium polycrystals. Acta Mater 84, 443–456.CrossRefGoogle Scholar
Chapuis, A and Driver, JH (2011) Temperature dependency of slip and twinning in plane strain compressed magnesium single crystals. Acta Mater 59, 1986–1994.CrossRefGoogle Scholar
Chen, HC, Liu, TM, Hou, DW and Shi, DF (2016) Improving the mechanical properties of a hot-extruded AZ31 alloy by {10-12} twinning lamella. J Alloys Compd 680, 191–197.CrossRefGoogle Scholar
Godet, S, Jiang, L, Luo, AA and Jonas, JJ (2006) Use of Schmid factors to select extension twin variants in extruded magnesium alloy tubes. Scr Mater 55, 1055–1058.CrossRefGoogle Scholar
Herrera-Solaz, V, Hidalgo-Manrique, P, Pérez-Prado, MT, Letzig, D, Llorca, J and Segurado, J (2014) Effect of rare earth additions on the critical resolved shear stress of magnesium alloys. Mater Lett 128, 199–203.CrossRefGoogle Scholar
Hong, SG, Park, SH and Lee, CS (2010) Role of {10-12} twinning characteristics in the deformation behavior of a polycrystalline magnesium alloy. Acta Mater 58, 5873–5885.CrossRefGoogle Scholar
Hou, DW, Liu, TM, Chen, HC, Shi, DF, Ran, CH and Pan, FS (2016) Analysis of microstructure and deformation mechanisms by compression along normal direction in a rolled AZ31 magnesium alloy. Mater Sci Eng A 660, 102–107.CrossRefGoogle Scholar
Hutchinson, WB and Barnett, MR (2010) Effective values of critical resolved shear stress for slip in polycrystalline magnesium and other hcp metals. Scr Mater. 63, 737–740.CrossRefGoogle Scholar
Jiang, J, Godfrey, A, Liu, W and Liu, Q (2008) Identification and analysis of twinning variants during compression of a Mg-Al-Zn alloy. Scr Mater 58, 122–125.CrossRefGoogle Scholar
Jiang, L, Jonas, JJ, Mishra, RK, Luo, AA, Sachdev, AK and Godet, S (2007) Twinning and texture development in two Mg alloys subjected to loading along three different strain paths. Acta Mater 55, 3899–3910.CrossRefGoogle Scholar
Koike, J and Ohyama, R (2005) Geometrical criterion for the activation of prismatic slip in AZ61 Mg alloy sheets deformed at room temperature. Acta Mater 53, 1963–1972.CrossRefGoogle Scholar
Pei, Y, Godfrey, A, Jiang, J, Zhang, YB, Liu, W and Liu, Q (2012) Extension twin variant selection during uniaxial compression of a magnesium alloy. Mater Sci Eng A 550, 138–145.CrossRefGoogle Scholar
Prasad, KE, Rajesh, K and Ramamurty, U (2014) Micropillar and macropillar compression response of magnesium single crystals oriented for single slip or extension twinning. Acta Mater 65, 316–325.CrossRefGoogle Scholar
Razavi, SM, Foley, DC, Karaman, I, Hartwig, KT, Duygulu, O, Kecskes, LJ, Mathaudhu, SN and Hammond, VH (2012) Effect of grain size on prismatic slip in Mg-3Al-1Zn alloy. Scr Mater 67, 439–442.CrossRefGoogle Scholar
Reed-Hill, RE and Robertson, WD (1957) Deformation of magnesium single crystal by nonbasal slip. J Metals 9, 496.Google Scholar
Shi, DF, Liu, TM, Hou, DW, Chen, HC, Pan, FS and Chen, HB (2016) The effect of twin-twin interaction in Mg-3Al-1Zn alloy during compression. J Alloys Compd 685, 428–435.CrossRefGoogle Scholar
Shi, DF, Liu, TM, Wang, TY, Hou, DW, Zhao, SQ and Hussain, S (2016) {10-12} twins across twin boundaries traced by in situ EBSD. J Alloys Compd 690, 699–706.CrossRefGoogle Scholar
Song, GS, Chen, QQ, Zhang, SH and Xu, Y (2015) Deformation micro-mechanism for compression of magnesium alloys at room temperature analyzed by electron backscatter diffraction. Mater Des 65, 534–542.CrossRefGoogle Scholar
Stanford, N and Barnett, MR (2013) Solute strengthening of prismatic slip, basal slip and {10-12} twinning in Mg and Mg-Zn binary alloys. Inter J Plast 47, 165–181.CrossRefGoogle Scholar
Syed, B, Geng, J, Mishra, RK and Kuman, KS (2012) [0001] compression response at room temperature of single-crystal magnesium. Scr Mater 67, 700–703.CrossRefGoogle Scholar
Ulacia, I, Dudamell, NV, Gálvez, F, Yi, S, Pérez-Prado, MT and Hurtado, I (2010) Mechanical behavior and microstructural evolution of a Mg AZ31 sheet at dynamic strain rates. Acta Mater 58, 2988–2998.CrossRefGoogle Scholar
Valle, JA del and Ruano, OA (2009) Effect of annealing treatments on the anisotropy of a magnesium alloy sheet proceed by sever rolling. Mater Lett 63, 1551–1554.CrossRefGoogle Scholar
Wang, J, Beyerlein, IJ and Tomé, CN (2010) An atomic and probabilistic perspective on twin nucleation in Mg. Scr Mater 63, 741–746.CrossRefGoogle Scholar
Wu, L, Jain, A, Brown, DW, Stoicam, GM, Agnew, SR, Clausen, B, Fielden, DE and Liaw, PK (2008) Twinning-detwinning behavior during the strain-controlled low-cycle fatigue testing of a wrought magnesium alloy, ZK60A. Acta Mater 56, 688–695.CrossRefGoogle Scholar
Zheng, SJ, Beyerlein, IJ, Carpenter, JS, Kang, K, Wang, J, Han, WZ and Mara, NA (2013) High-strength and thermally stable bulk nanolayered composites due to twin-induced interfaces. Nat Commun 4, 1696.CrossRefGoogle ScholarPubMed