Hostname: page-component-78c5997874-v9fdk Total loading time: 0 Render date: 2024-11-10T07:00:41.361Z Has data issue: false hasContentIssue false
  • English
  • Français

Mask Charging Phenomena during Electron Beam Exposure in the EPL System

Published online by Cambridge University Press:  01 December 2004

Masatoshi Kotera  and
Yoshihisa Ishida
Masatoshi Kotera
Affiliation:
Department of Electronic Engineering, Osaka Institute of Technology, Omiya, Asahi-ku, Osaka, 535-8585, Japan
Yoshihisa Ishida
Affiliation:
Department of Electronic Engineering, Osaka Institute of Technology, Omiya, Asahi-ku, Osaka, 535-8585, Japan
Get access

Abstract

Charging phenomena of a mask material during electron beam exposure are analyzed in an electron beam projection lithography system. First, the three-dimensional charge deposition distribution by the electron beam irradiation is obtained. Next, in every time step, the distributions of the accumulated charge and the potential are obtained considering the current flow due to the diffusion and the drift. As a narrow bridge pattern defined in a 5 μm × 5 μm area is assumed to lay out all over the field of 1 mm × 1 mm and the potential is grounded at the circumference of the field (1 mm × 1 mm × 1 mm), the saturated potential distribution is obtained at the central 5 μm × 5 μm area in the field. The maximum potential attained is around 4.23 μV at the center of the bridge, if the accelerating voltage of the electron beam is 100 kV, the current density is 10 A/cm2, and the material of the mask is the intrinsic Si. The contribution of the charging may be negligible to the electron beam with such a high accelerating voltage, which is going through the opening beside the bridge pattern in the projection lithography.

Keywords

charging at a mask patternelectron beam exposureEPL systemcurrent continuity equationPoisson equation
Type
Research Article
Information
Microscopy and Microanalysis , Volume 10 , Issue 6 , December 2004 , pp. 771 - 775
Copyright
© 2004 Microscopy Society of America

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

Bai, M., Pease, R.F., Tanasa, C., McCord, M.A., Pickard, D.S., & Meisburger, D. (1999). Charging and discharging of electron beam resist films. J Vac Sci Technol B 17, 2893–2896.Google Scholar
Ko, Y.U., Kim, S.W., & Chung, M.S. (1998). Monte Carlo simulation of charging effects on linewidth metrology. Scanning 20, 447–455.Google Scholar
Kotera, M. (1998). Simulation of charging-up of insulating materials under electron beam irradiation. Electron Microsc 33, 166–172 (in Japanese).Google Scholar
Kotera, M., Ijichi, R., Fujiwara, T., Suga, H., & Wittry, D.B. (1990). A simulation of electron scattering in metals. Jpn J Appl Phys 29, 2277–2282.Google Scholar
Kotera, M. & Suga, H. (1988). A simulation of keV electron scatterings in a charged-up specimen. J Appl Phys 63, 261–268.Google Scholar
Kotera, M., Yamaguchi, K., & Suga, H. (1999). Dynamic simulation of electron-beam-induced charging up of insulators. Jpn J Appl Phys 38, 12B, 7176–7179.Google Scholar
Kotera, M., Yamaguchi, S., Umegaki, S., & Suga, H. (1994). Analysis of charging effect during observation of trench structures by scanning electron microscope. Jpn J Appl Phys 33, 12B, 7144–7149.Google Scholar
Lee, Y., Lee, W., & Chun, K. (2000). Calculation of surface potential and beam deflection due to charging effects in electron beam lithography. J Vac Sci Technol B 18, 3095–3098.Google Scholar
Liu, W., Ingino, J., & Pease, R.F. (1995). Resist charging in electron beam lithography. J Vac Sci Technol B13, 1979–1983.Google Scholar
Mkrtchyan, M.M. (2000). Electron scattering and related phenomena in scattering with angular limitation projection electron lithography (SCALPEL*). Jpn J Appl Phys 39, 6881–6898.Google Scholar