Hostname: page-component-745bb68f8f-g4j75 Total loading time: 0 Render date: 2025-01-15T07:00:48.358Z Has data issue: false hasContentIssue false
  • English
  • Français

Growth of Ge/Si Amorphous Superlattices by Dual-Target DC Magnetron Sputtering

Published online by Cambridge University Press:  21 February 2011

K. Järrendahl ,
J. Birch ,
L. Hultman ,
L.R. Wallenberg ,
G. Radnoczi ,
H. Arwin  and
J-E. Sundgren
K. Järrendahl
Affiliation:
Dept. of Physics, Thin Film Division, Linköping University, S-581 83 Linköping, Sweden
J. Birch
Affiliation:
Dept. of Physics, Thin Film Division, Linköping University, S-581 83 Linköping, Sweden
L. Hultman
Affiliation:
Dept. of Physics, Thin Film Division, Linköping University, S-581 83 Linköping, Sweden
L.R. Wallenberg
Affiliation:
Dept. of Physics, Thin Film Division, Linköping University, S-581 83 Linköping, Sweden
G. Radnoczi
Affiliation:
Dept. of Physics, Thin Film Division, Linköping University, S-581 83 Linköping, Sweden
H. Arwin
Affiliation:
Dept. of Physics, Thin Film Division, Linköping University, S-581 83 Linköping, Sweden
J-E. Sundgren
Affiliation:
Dept. of Physics, Thin Film Division, Linköping University, S-581 83 Linköping, Sweden
Get access

Abstract

Amorphous Ge/Si superlattices have been grown by dual-target dc magnetron sputtering at ambient temperature under different negative substrate bias voltages Vs. The films were studied with cross-sectional transmission electron microscopy (XTEM). All films were amorphous, but for Vs ≤ 110 V the superlattices exhibited a columnar structure. Within each column, the compositional modulation was clearly resolved except in the vicinity of the column boundaries. For 110<VS≤250V, dense films with homogeneous and well-defined layers were obtained. High-resolution XTEM studies showed that superlattices with individual layer thicknesses less than 1.5 nm and smooth interfaces could be fabricated. Increasing Vs > 250 V resulted in ion induced intermixing such that at Vs ≥ 450 no compositional modulation was observed. The obtained structural results are discussed in terms of available models for ion-irradiation effects during low-temperature ballistic growth.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 258: Symposium A – Amorphous Silicon Technology – 1992 , 1992 , 571
Copyright
Copyright © Materials Research Society 1992

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1 Esakl, L. and Tsu, R., IBM J. Res. Develop. 14, 61 (1970).CrossRefGoogle Scholar
2 Wallenberg, L.R., Hultman, L., Jonsson-Järrendahl, K., Johansson, P. and Birch, J., Micron and Microscopica Acta, 22, 189 (1991).CrossRefGoogle Scholar
3 Abeles, B., Tiedje, T., Liang, K.S., Deckman, H.W., Stasiewski, H.C., Scanlon, J.C. and Eisenberger, P.M., J. Non-Cryst. Solids 66, 351 (1884).CrossRefGoogle Scholar
4 Håkansson, G., Birch, J., Hultman, L., Ivanov, I. P., Sundgren, J. E., and Wallenberg, R., submitted to Journal of crystal growth 1992.Google Scholar
5 Greene, J.E., Barnett, S.A., Sundgren, J. -E., and Rockett, A. in Beam Modification of Materials 3. Ion Beam Assisted Film Growth edited by Itoh, Tadatsugu (Elsvier, 1989), p. 101.CrossRefGoogle Scholar