Development of preferred orientations of illite-smectite (I-S) has been studied using X-ray diffraction (XRD) texture goniometry to produce pole figures for clay minerals of a suite of 16 mudstone samples from a core from the Gulf Coast. Samples represent a compaction-loading environment in which the smectite-to-illite (S-I) transition occurs. In five shallow, pre-transition samples, there is no significant preferred orientation for smectite-rich I-S. Development of preferred orientation of I-S, although weak, was first detected at depths slightly less than that of the S-I transition. The degree of preferred orientation, which is always bedding-parallel, increases rather abruptly, but continuously, over a narrow interval corresponding to the onset of the S-I transition, then continues to strengthen only slightly with increasing depth. The degree of post-transition preferred orientation is also dependent on lithology, where the preferred orientation is less well-defined for quartz-rich samples.

Previously obtained transmission electron microscope (TEM) data define textures consistent with the change in orientation over many crystallites. The smectite in pre-transition rocks consists largely of anastomosing, “wavy” layers with variable orientation and whose mean orientation is parallel to bedding, but which deviate continuously from that orientation. This results in broad, poorly defined peaks in pole figures. Post-transition illite, by contrast, consists of thin, straight packets, with most individual crystallites being parallel or nearly parallel to bedding. This results in pole figures with sharply defined maxima. By analogy with development of slaty cleavage in response to tectonic stress during metamorphism, the S-I transition is marked by dissolution of smectite and neocrystallization of illite or I-S locally within the continuous “megacrystals” of smectite. The transition is inferred to have some component of mechanical rotation of coherent illite crystals within a pliant matrix of smectite. The data suggest that change in orientation and coalescence of clay packets plays an important role in the formation of the hydraulic seal required for overpressure generation.

This study assesses the distribution of Al and Fe in mixed-layer illite/smectites (I/S) in shales undergoing burial diagenetic changes, using evidence from 27Al NMR, XRD, and chemical analyses. Samples studied include a sequence of mixed-layer I/S (ranging from 40% to 68% illite layers) in shales from a well located in the Caillou Island Oil Field, Terrebonne Parish, Louisiana, as well as synthetic mica-montmorillonite (Syn-1), Silver Hill illite (IMt-1), K-benonite (ISMt-1), an Fe-bearing muscovite, phengitic muscovite, and a randomly interstratified mixed-layer I/S with 50% illite layers. Using a simplified model, where Fe3+ isomorphously substitutes randomly for [6]Al in the dioctahedral 2:1 structure, the 27Al NMR signal intensities are examined with regard to the paramagnetic deshielding effect of the Fe3+. The rapid decrease in paramagnetic deshielding with distance allows for a spherical “wipeout” model with a radius of 6 Å, over which there is complete effective paramagnetic line broadening (i.e., Al within the sphere is not “seen”). Using the average dimensions of a dioctahedral mica, the expected relative intensities of the octahedral and tetrahedral Al signal are determined as a function of Fe2O3 content.

Observed 27Al signals, normalized per unit weight of Al2O3 and relative to the lowest Fe-bearing phase, show a clear trend of decreasing intensity with increasing Fe2O3 content. Normative fitting of oxide data to structural formulae reveals a similar trend of decreasing 27Al intensity with increasing fraction of dioctahedral site occupied by Fe3+. Agreement between the observed 27Al intensities of low Fe-bearing 2:1 phyllosilicates and 27Al intensities predicted using the wipeout model indicate regular ordering of Fe and Al within the low Fe-bearing phases. However, observed 27Al intensities for the I/S specimens fall into a region where the amount of Al seen is in excess for the given XFe, thus indicating segregation of Al and Fe domains.

The second order quadrupole effect for the [6]Al site in the I/S fraction of shales decreases very slightly with increasing depth and percent of illite in the I/S, but not enough to effect site quantitation. Quantitative apportionment of elements into the I/S phase of the <0.2 µm fraction using NMR constraints shows directly a trend of increasing number of [4]Al sites and no change in the number of [6]Al sites with increasing degree of illitization for samples from the Gulf Coast diagenetic environment. Stoichiometry indicates an approximate 1:1 substitution of tetrahedral Al for Si over the 40–68% range of illite in I/S examined.

Samples from different depths in the Oligocene Frio formation (offshore Gulf of Mexico) were studied by X-ray diffraction (XRD), thermal analyses, and scanning electron microscopy. The experimental XRD patterns recorded from oriented and ethylene glycol (EG) solvated clay fractions of the samples were similar to those typical of random, mixed-layered illite-smectite (R0 I-S). The experimental XRD patterns recorded in air-dried (AD) and EG states were simulated using three different models. One of them corresponds to R0 I-S for which thickness and content of the interstratified layers were determined by the Środoń technique. The second model is represented by a single homogeneous I-S in which illite and smectite layers are interstratified with a tendency to segregation. The expandability of the segregated I-S model varies from 48% to 75% without any rational relationship between the smectite layer content and depth.

The third model assumes that the clay fraction is a physical mixture of smectite and an R0 I-S. In this model the I-S contains 65% illite and 35% smectite layers independent of depth, whereas the smectite content varies from 28% to 63%. This model has consistently smaller profile factors, Rp, for both EG and AD XRD scans compared with the Rp values determined for the other two models.

The mineralogical association, volcanic origin, narrow stratigraphic interval (427 m), and low maximum temperature (42°C) of the studied Frio Formation are considered. These features are completely consistent with the two-phase model and so the segregation model must be rejected. An authigenic origin of the pure smectite and an alternative detrital or authigenic origin of the R0 I-S are discussed.

Torpedograss infestation in centipedegrass has reduced centipedegrass quality in home lawns along the Gulf Coast. This study was conducted to evaluate three selective postemergence herbicides. Field trials were conducted at two sites in Louisiana to evaluate quinclorac, sethoxydim, and clethodim applied once or sequentially every 4 wk for selective torpedograss control in centipedegrass turf. Herbicides were applied to mixed stands of torpedograss/centipedegrass at two locations in Louisiana and evaluated for changes in torpedograss coverage and centipedegrass injury every 2 wk for 16 wk. All herbicides controlled torpedograss more with each sequential application. Sethoxydim and clethodim applied three times reduced torpedograss cover 84 and 87%, respectively, and more than quinclorac 12 wk after initial treatment (WAIT). Increasing clethodim or sethoxydim rates did not improve torpedograss control. Torpedograss regrowth occurred within weeks after final herbicide applications regardless of herbicide. Only multiple clethodim applied at twice manufacturer's labeled rate or quinclorac applications resulted in commercially unacceptable (> 25%) injury to centipedegrass. Multiple sethoxydim or clethodim applications at 0.32 kg ha−1 or 0.30 kg ha−1 every 4 wk reduced torpedograss competitiveness in centipedegrass; however, multiple applications for more than 1 yr might be necessary to achieve torpedograss control.