Constant strain rate nanoindentation hardness measurements at high sustained strain rates cannot be made in conventional nanoindentation testing systems using the commonly employed continuous stiffness measurement technique (CSM) because of the “plasticity error” recently reported by Merle et al. [Acta Mater.134, 167 (2017)]. To circumvent this problem, here we explore an alternative testing and analysis procedure based on quasi-static loading and an independent knowledge of the Young's modulus, which is easily obtained by standard nanoindentation testing. In theory, the method applies to any indentation strain rate, but in practice, an upper limit on the rate arises from hardware limitations in the testing system. The new methodology is developed and applied to measurements made with an iMicro nanoindenter (KLA, Inc.), in which strain rates up to 100 s−1 were successfully achieved. The origins of the hardware limitations are documented and discussed.

In this paper, the influence of strain rate on the mechanical behavior of high-strength low-alloy (HC420LA) steel were studied. Quasi-static and dynamic tensile experiments were performed with strain rates ranging from 0.001 to 500 s−1 at room temperature. The digital image correlation technique was used to obtain the full-field strain. The experimental results showed that HC420LA steel exhibited positive strain rate sensitivity. Based on experimental results, the modified Johnson–Cook (J–C) model was used to model the constitutive behavior of HC420LA steel. Predictions of the standard and modified J–C models were compared using standard statistical parameters. The modified J–C model showed better agreement with the experimental data. Then, numerical simulation of the representative tensile test at a strain rate of 100 s−1 was performed using the finite element code LS-DYNA. Good correlation between the experimental and numerical simulation results was achieved.