A field study was conducted in 2015 and 2016 to compare particle drift of glyphosate using a fluorescent tracer dye applied with hooded and open sprayers at four spray qualities (Fine [F], Medium [M], Very-Coarse [VC], and Ultra-Coarse [UC]). F and M spray qualities exhibited up to 86% and 56% less drift, respectively, out to 31 m downwind with the hooded sprayer than with the open sprayer. Conversely, VC and UC spray qualities were not affected by sprayer type out to 31 m downwind. From 43 to 104 m downwind, hooded sprayer applications exhibited approximately 50% less drift than open sprayer applications, regardless of spray quality. From 43 to 89 m downwind, F spray qualities, regardless of sprayer type, exhibited higher drift than all other spray qualities. These data indicate that hooded sprayers considerably reduce drift of all spray qualities at short distances downwind. Additionally, at longer distances downwind, both larger spray qualities and sprayer hoods reduced drift independently.

With the release of dicamba-resistant crops, it is necessary to understand how technical and environmental conditions affect the application of dicamba. This study sought to evaluate drift from dicamba applications through flat-fan nozzles, under several wind speeds in a wind tunnel. Dicamba applications were performed through two standard (XR and TT) and two air induction (AIXR and TTI) 110015 nozzles at 0.9, 2.2, 3.6 and 4.9 ms−1 wind speeds. The applications were made at 276 kPa pressure and the dicamba rate was 561 g ae ha-1. The droplet spectrum was measured using a laser diffraction system. Artificial targets were used as drift collectors, positioned in a wind tunnel from 2 to 12 m downwind from the nozzles. Drift potential was determined using a fluorescent tracer added to solutions, quantified by fluorimetry. The air induction TTI nozzle produced the lowest percentage of dicamba drift at 2.2, 3.6 and 4.9 ms−1 wind speeds at all distances. Dicamba spray drift from XR, TT and AIXR nozzles increased exponentially as wind speed increased, whereas from TTI nozzle drift increased linearly as wind speed increased. Drift did not increase linearly as the volume percentage of droplets smaller than 100 µm and wind speed increased.

Field research was conducted to test a method of herbicide application in which chemical is placed directly onto cut surfaces of plants during a mowing operation. Specially designed mowers equipped with a fluid application system allow for low-volume herbicide application from the cutting blades during the mowing process (wet blade). Two prototype wet-blade machines, including a sickle bar cutter and a Burch Wet-Blade rotary mower, were used to apply triclopyr, clopyralid, and 2,4-D at various rates and combinations using a total carrier volume of 25 L/ha. Weed management studies were conducted on dogfennel, annual lespedeza, and clovers during a 2-yr period. Wet-blade herbicide applications were effective and performed as well as or better than comparative rates applied using a foliar spray technique. Triclopyr at 2.24 kg ae/ha controlled dogfennel when applied with either the rotary mower or the sickle bar cutter (94 and 77%, respectively). Rotary mower applications of 0.20 kg ae triclopyr + 0.07 kg ae clopyralid per hectare in rough turf achieved 90% control of annual lespedeza and 95% control of red and white clovers.