An orthochlorite (sheridanite) was heated to 610°C to dehydroxylate the hydroxide sheet and to oxidize ferrous iron. The heated sample was shaken for 20 min in a mixed solution of 0·2 N HCl and 0·2 N NaCl to dissolve the dehydroxylated hydroxide sheet. X-ray diffraction, thermal, infrared absorption and chemical analyses showed that the resulting product was similar to Kenya vermiculite. The procedure shows promise for the individual determination of the composition of the hydroxide sheet and of the mica layer in the chlorite structure. The experiments indicate that the hydroxide sheet in orthochlorites must be structurally disturbed before it can be selectively removed. In nature, structural disorganization of the hydroxide sheet of chlorite by dehydroxylation and oxidation of ferrous iron might occur during meta-morphic processes, and chlorite to vermiculite transformation could take place during subsequent acid weathering. In pedogenic weathering conditions it is likely that oxidation of ferrous iron plays a major role in initiation of the structural disorder required for the selective removal of the hydroxide sheet in the weathering of chlorite to vermiculite.

Lattice spacings of layer silicates, particularly clay minerals, may exceed 20 Å. The errors in measuring lattice spacings increase rapidly for spacings greater than about 10 Å and diffraction angles 2θ less than about 10°. Long-chain organic compounds, such as normal alcohols, C14–C20, and normal alkanes (paraffins), C26–C30, provide useful calibrations for lattice spacings in the range 10–50Å. The basal spacings of the calibrating substances are determined from their higher order reflections in the angular range where reflections from quartz and silicon are used as standards.

To examine the effects of clay swelling and dispersion on electrolyte concentration-permeability relationships of low clay content soils, flow experiments were conducted on a silt of fixed particle size distribution containing 0, 5, 7·5, 10 and 15 per cent clay (sodium illite, 2 μm fraction). Flocculated specimens were sedimented using both slow and rapid procedures. After compression each specimen was permeated successively with electrolyte solutions which caused (1) swelling of the clay fraction (0·10 N), and (2) dispersion (0·05 N). Absolute permeabilities varied with clay content, sedimentation procedure, compression rate, and electrolyte concentration; however, the form of this variation plotted against through-put volume was similar for all specimens containing electrolyte solutions causing only swelling of the clay. Increasing the hydraulic gradient above a critical value apparently increased the swelling slightly as evidenced by further reductions in permeability. The permeability of mixtures permeated with electrolyte solution causing dispersion of the clay was more complex and depended on clay content, the hydraulic gradients used to introduce the dispersing electrolyte solution and the pre-dispersion gradients to which the specimens had been subjected. Permeability decreases were attributed to the last stages of swelling prior to dispersion and to pore plugging. Increases in permeability were the result of erosion of dispersed particles. Specimens previously subjected to the highest gradients while swelling dispersed more rapidly and had a greater tendency to erode. The effects of predispersion gradients diminished with increasing clay contents. It is concluded that both compositional and mechanical factors play an important role in determining electrolyte concentration-permeability relationships for soils containing active clay minerals.

Gravitational settling and centrifuge techniques have been criticized in the preparation of X-ray specimen mounts for quantitative clay petrology because of the marked mineral segregations that can occur. Although the same factors can operate to produce error in the separation of the traditional less-than-2-μm fraction, this potentially more important source of bias is seldom taken into consideration. A fair representation of the bulk sample deserves at least as much attention as a representative X-ray mount. The most accurate and precise X-ray analyses may be geologically misleading or meaningless otherwise and translate as exercises in precision for its own sake.

Other layer silicates are consistently present as impurities in natural montmorillonite samples. They have a distinctly different morphology from the common montmorillonite particles. The selected area electron diffraction (SAD) of these impurities display unusually sharp spot patterns with triclinic, monoclinic and hexagonal symmetries. These impurities are most likely micas, which are easily detectable with X-rays in the coarser fractions (> 10 μm) of the samples.

The crystal structure model with the space group C2 for montmorillonite single layer has an unusual configuration of OH’s and vacancies for a dioctahedral layer silicate. Our intensity calculations do not bring a conclusive evidence for distinguishing the two possible space groups C2 and C2/m on the observed SAD patterns of montmorillonite.

The SAD of the thin montmorillonite flakes in Cheto, Camp-Berteaux and Wyoming samples display uniform ring, circular arcs and spotty ring patterns, respectively. These patterns indicate different modes of association of crystallites or different arrangements of elementary layers within them.

It is shown that order-disorder relations in the distribution of the isomorphous substitutions are important in the characterization of different 2/1 phyllosilicates and in the determination of their behavior. These order-disorder relations are shown by selected area diffraction patterns obtained from single crystals. The range of layer charges corresponding to smectites (charge per half-cell <0.6) is that for which phyllosilicates are stable with disordered substitutions. Phyllites with charge >0.6 show anomalous diffusions which indicate that the distributions of exchangeable Ba ions are partially ordered; this result is taken as evidence that the isomorphous substitutions also are partially ordered.

An electro-optic birefringence technique was employed to study the orientation mechanism of montmorillonite in an electric field. The instantaneous reversal of the field polarity produced evidence of a low voltage permanent dipole and a high voltage induced dipole. This technique was used to study theeffect ofelectrolyte concentration on the rotational diffusion coefficient, a measure of the rate at which the particles rotate or relax, within the solution, from a preferred orientation. Thus, a measure of the immediate environment of the particles was obtained that is not an average effect for the whole system, yet allows for the full development of the clay-cation-water interactions under the experimental conditions. It was found that particle rotation could be accounted for using the measured particle size and normal water viscosity only when the double layer was fully developed, with no free ions or other perturbations. As soon as perturbations were applied, either by adding salts or applying an electric field, the measured particle size and normal viscosity would not account for the data. Either the rotating moiety has to be larger, that is, be a particle plus a water hull, or the viscosity greater, or in some cases both.

Clay minerals from shale outcrops of the Lower Cretaceous Buckinghorse Formation (4250 ft thick) were investigated in order to assess their degree of diagenesis and their oil-generating potential. Crystallinity index, sharpness ratio, per cent of illite which is the 2M polymorph and presence of discrete minerals have been studied in the whole clay fraction, while the very fine clay fraction has been subjected to X-ray diffraction, differential thermal, thermogravimetric, differential thermogravimetric, i.r. spectroscopy, surface area and chemical analyses. With information derived from these studies and from published data, a classification scheme was devised which relates variation of clay mineralogy to diagenetic stages and burial depth.

Data on the < 2 μm size fraction show that the crystallinity index decreases while the sharpness ratio and per cent of illite which is the 2M polymorph increase with burial depth. Results on the <0·08 μm fraction reveal that a three-component interstratified clay mineral exists. In addition, Fourier transform calculations and chemical and physicochemical analyses indicate that both the ratio of the amounts of non-hydrated clays (illite) to hydrated clays and the K2O content of clays increase with burial depth; cation exchange capacity and surface area decrease with burial depth.

Based upon a classification scheme, which was devised by combining criteria and data derived from the studies of Weaver (1961a), Kubier (1966), Burst (1969) and Dunoyer de Seconzac (1970), the upper and middle parts of the formation (upper 3250 ft) fall within the middle stage of diagenesis whereas the lower part (1000 ft) is allocated to the beginning of late diagenesis. In terms of Burst’s (1969) work, the upper 3250 ft are transitional between the stability and dehydration zones indicating that, prior to uplift, hydrocarbons may have been in the process of migration. The lower 10000 ft of the formation are in the restricted dehydration zone, indicating that hydrocarbon migration should have been completed.

Surface properties of reduced charge montmorillonites (RCM) whose exchange capacities were saturated with tetra-alkylammonium cations, were studied with X-ray diffraction, nitrogen, and water adsorption. Methods were utilized for preparing montmorillonite of varying charge and of swelling reduced-charge clay with ethanol. As charge reduction proceeds, all layers retain some exchangeable cations until about half the original charge is reached at which point collapsed layers begin to appear and increase to about 60 per cent at maximum charge reduction. Charge reduction thus appears to proceed in a non-homogeneous fashion. When saturating exchange sites with tetra-alkylammonium ions in ethanol solvent, intercalation of salt in uncharged layers was noted if the samples were not completely washed. Nitrogen adsorption isotherms at liquid nitrogen temperatures showed considerable interlamellar penetration of tetramethylammonium (TMA+) clays, resulting in high calculated surface areas. Much less adsorption on the tetra-n-propylammonium (TPA+) clays was observed. Surface areas were increased upon reduction of charge up to the point where collapsed layers began to be appreciable, whereupon measured areas decreased. Water adsorption isotherms reflected the hydration properties of the exchangeable cation as well as the surface available for adsorption.

Steamboat Springs, Nevada, an area of present-day hot springs, clearly illustrates the genetic dependence of some kaolin deposits on hot-spring activity. Andesite, granodiorite and arkosic sediments are locally altered at the land surface to siliceous residues consisting of primary quartz and anatase, plus opal from primary silicates. These siliceous residues commonly exhibit the textural and structural features of their unaltered equivalents. Beneath the siliceous residues, kaolin and alunite replace primary silicates and fill open spaces, forming a blanketlike deposit. Beneath the kaolin-alunite zone, montmorillonite, commonly accompanied by pyrite, replaces the primary silicates. On the ground surface, the same alteration mineral zones can be traced outward from the siliceous residue; however, hematite rather than pyrite accompanies montmorillonite.

Chemical analysis indicates that sulfuric acid is the active altering agent. The acid forms from hydrogen sulfide that exsolves from deep thermal water, rises above the water table and is oxidized by sulfur-oxidizing bacteria living near the ground surface. This acid dissolves in precipitation or condensed water vapor and percolates downward destroying most of the primary minerals producing a siliceous residue. Coincidence of the water table with the downward transition from siliceous residue to kaolin-alunite signifies decreasing hydrogen metasomatism because of dilution of descending acid by ground water.

In hot-spring areas, beds of siliceous sinter deposited at the surface by hypogene thermal water look, superficially, like areas of surficial acid alteration. Features diagnostic of a surficial alteration are the relict rock structures of a siliceous residue and a kaolin-alunite zone immediately beneath.

The conditions were studied under which consolidation loading caused the release of phosphate from a saturated illite clay. P32 tracer techniques were employed to follow the movement of phosphate in composite samples composed of tagged and untagged portions. The samples, initially consolidated to 1·0 kgcm−2 stress were reconsolidated to 0·1, 0·5, 2, 4 and 8 kg cm−2 stress and the transport of phosphate was monitored by counting the radioactivity of 0·01-in. thick sections sliced parallel to the major principal plane. Corrections were applied for P32-P31 self-diffusion. It was found that: (1) for low phosphate concentrations there was no observable transport due to consolidation type flow: (2) for high phosphate concentrations and for stresses less than or equal to the preconsolidation load there was no observable transport due to consolidation type flow; and (3) for high phosphate concentrations and for loads above the preconsolidation load there was detectable transport of phosphate, presumably due to the consolidation flow. A mechanism based on self-diffusion plus uniform flow was able to semi-quantatively explain the test results.

Transmission electron images of fine-grained micas in bentonites exhibit lath-shaped units. These units seem to be associated along the (110) planes—referred to 2M1 mica cell—with perfect registry of their individual lattices. In doing so, they seem to provide lateral growth in the (001) plane. These lath-shaped units are arranged in the [001] direction in modes similar to the stacking of layers in mica polymorphs. Aggregations of lath-shaped units with polycrystalline montmorillonite particles are also observed in several bentonites. From the SAD pattern these laths are inferred to be dioctahedral layer silicates. However, they cannot be exactly identified any further. It is an open question whether these laths have grown from the montmorillonite or are simply entangled with it.

The implication by Murthy and Ferrell (1972) that interstitial water studies are in a confused state is criticized on the basis that the authors have not drawn on a considerable body of data, especially Soviet studies since the 1950’s, and results of the Deep Sea Drilling Project. Pressure filtration systems for extracting interstitial waters are currently the methods of choice for marine studies and have achieved substantial reliability and reproducibility. Although gaps and problems remain, many aspects of interstitial composition of marine sediments have been clarified; these include the substantial constancy of composition of interstitial waters in deep sea pelagic deposits, depletion of interstitial cations owing to authigenic mineral formation in more rapidly accumulated (especially terrigenous) sediments, and special phenomena in sediments overlying salt deposits.