Hostname: page-component-cd9895bd7-fscjk Total loading time: 0 Render date: 2024-12-27T12:39:39.682Z Has data issue: false hasContentIssue false

Using a Microcomputer-Controlled Robot Arm as a General Purpose Sample Changer

Published online by Cambridge University Press:  06 March 2019

John C. Russ
Affiliation:
North Carolina State Univ., Raleigh, NC
J. Christian Russ
Affiliation:
University of Michigan, Ann Arbor, MI
Donald E. Leyden
Affiliation:
Colorado State Univ., Fort Collins, CO
Get access

Extract

We have previously reported in these proceedings on the automation of Wavelength-Dispersive X-ray Fluorescence arid X-ray Diffraction Spectrometers using stepping motors, either installed in place of existing synchronous drive motors, or attached to existing gear or belt drive mechanisms that control the theta/two-theta positioning of the spectrometer. This technique is applicable to most types of instruments (successful adaptations to Philips, Siemens, GE/Diano, and Rigaku systems are working routinely at this writing).

Type
VI. J. Gilfrich Honorary Session on Trends in XRF Instrumentation
Copyright
Copyright © International Centre for Diffraction Data 1983

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

1. Jablonski, B. B., Leyden, D. E., “A Microcomputer Based Wavelength Control and Data Acquisition System for Early Model WDXRF Spectrometers,” Proc. Denver X-ray Conf., 1980Google Scholar
2. Hare, T. M., Russ, J. C., Lanzo, M. J., “ X-ray Diffraction Phase Analysis Using Microcomputers, “ Advances in X-ray Analysis, Vol. 25, Plenum, 1982, p. 237244 Google Scholar
3. Colne Robotics, 207 NE 33rd St., Port Lauderdale FL 33334Google Scholar