Hostname: page-component-cd9895bd7-q99xh Total loading time: 0 Render date: 2024-12-28T04:11:01.868Z Has data issue: false hasContentIssue false
  • English
  • Français

Heat transfer and flow behind a step in high enthalpy superorbital flow

Published online by Cambridge University Press:  04 July 2016

M. J. Hayne ,
D. J. Mee ,
R. G. Morgan ,
S. L. Gai  and
T. J. Mclntyre
M. J. Hayne
Affiliation:
Centre for Hypersonics, Department of Mechanical Engineering, University of Queensland, Brisbane, Australia
D. J. Mee
Affiliation:
Centre for Hypersonics, Department of Mechanical Engineering, University of Queensland, Brisbane, Australia
R. G. Morgan
Affiliation:
Centre for Hypersonics, Department of Mechanical Engineering, University of Queensland, Brisbane, Australia
S. L. Gai
Affiliation:
School of Aerospace and Mechanical Engineering, University College, UNSW@ADFA, Canberra, Australia
T. J. Mclntyre
Affiliation:
Centre for Hypersonics, Department of Physics, University of Queensland, Brisbane, Australia
Get access Rights & Permissions [Opens in a new window]

Abstract

Heat transfer levels have been investigated behind a rearward-facing step in a superorbital expansion tube. The heat transfer was measured along a flat plate and behind 2 and 3mm steps with the same length to step height ratio. Results were obtained with air as the test gas at speeds of 6·76kms-1 and 9·60kms-1 corresponding to stagnation enthalpies of 26MJ/kg and 48MJ/kg respectively. A laminar boundary layer was established on the flat plate and measured heat transfer levels were consistent with classical empirical correlations. In the case of flow behind a step, the measurements showed a gradual rise in heat transfer from the rear of the step to a plateau several step heights downstream for both flow conditions. Reattachment distance was estimated to be approximately 1·6 step heights downstream of the 2mm step at the low enthalpy condition through the use of flow visualisation.

Type
Research Article
Information
The Aeronautical Journal , Volume 107 , Issue 1073 , July 2003 , pp. 435 - 442
Copyright
Copyright © Royal Aeronautical Society 2003 

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

1. Chapman, D.R., Kuehn, D.M. and Larson, H.K. Investigation of separated flows in supersonic and subsonic streams with emphasis on the effect of transition, 1957, NACA Report 1356.Google Scholar
2. Rom, J. and Seginer, A. Laminar heat transfer to a two-dimensional backward facing step from the high-enthalpy supersonic flow in the shock tube, 1964, AIAA J, 2, (2), pp 251–255.Google Scholar
3. Rom, J. and Victor, M. A theoretical and experimental determination of the base pressure behind a two dimensional backward facing step in a laminar supersonic flow, 1963, proceedings of the fifth Israeli conference on aeronautics and astronautics, Academic Press, Tel Aviv and Haifa, Jerusalem, pp 77–81.Google Scholar
4. Sandford, J. and Ginoux, J. Laminar, transitional and turbulent heat transfer behind a backward facing step in supersonic flow, October 1968, Technical Note 38, von Karman Institute for Fluid Dynamics.Google Scholar
5. Smith, H.E. Experimental and Theoretical Investigation of the Near Wake behind a Rearward Facing Step in Supersonic Flow, 1969, PhD thesis, University of Cincinnati.Google Scholar
6. Wada, I. and Inoue, Y. Heat transfer behind the backward facing step in the hypersonic flow, proceedings of the tenth international symposium on space technology and science, 1973, Tokyo, pp 425–432.Google Scholar
7. Jessen, C, Vetter, M. and Gronig, H. Experimental studies in the Aachen hypersonic shock tunnel, Zeitschrift fur Flugwissenschaften und Weltraumforschung, 1993,17, (2), pp 73-81.Google Scholar
8. Gai, S.L., Reynolds, N.T., Ross, C. and Baird, J.P. Measurements of heat transfer in separated high-enthalpy dissociated laminar hypersonic flow behind a step, J Fluid Mech, 1989 , 199, pp 541–561.Google Scholar
9. Mallinson, S.G., Gai, S.L. and Mudford, N.R. The interaction of a shock wave with a laminar boundary layer at a compression corner in high-enthalpy flows including real gas effects, J Fluid Mech, 1997, 342, pp 1–35.Google Scholar
10. East, R.A., Stalker, R.J. and Baird, J.P. Measurements of heat transfer to a flat plate in a dissociated high-enthalpy laminar air flow, J Fluid Mech, 1980, 97, (4), pp 673–699.Google Scholar
11. Neely, A.J., and Morgan, R.G. The superorbital expansion tube concept, experiment and analysis, Aeronaut J, 1994, 175, pp 97–105.Google Scholar
12. Morgan, R.G. Free-piston driven expansion tubes, 2001, Shock Tubes and Tunnels: Facilities, Instrumentation, and Techniques, Ben-Dor, G., Igra, O. and Elperin, T. (Eds), Academic Press, pp 603–622.Google Scholar
13. Macrossan, M.N., Chiu, H-H. and Mee, D.J. A test facility for hypervelocity rarefied flows, 2001, American Institute of Physics Conference Proceedings, 585, pp 772-779.Google Scholar
14. Palmer, R.A. Measurement of Heat Transfer in Superorbital Flows, 1999, PhD Thesis, Department of Mechanical Engineering, University of Queensland, Brisbane, Australia.Google Scholar
15. Stewart, B., Hayne, M., Jacobs, P. and Morgan, R.G. Flow establishment in large-scale high-performance expansion tubes, 2002, AIAA paper 2002-5239, AIAA/AAAF 11th international space planes and technologies conference, Orleans, France, 29 Sept-4 Oct 2002.Google Scholar
16. Schultz, D.L. and Jones, T.V. Heat-transfer measurements in shortduration hypersonic facilities, 1973, AGARDograph 165.Google Scholar
17. Bishop, A.I., Littleton, B.N., McIntyre, T.J. and Rubinszteindunlop, H., Near-resonant holographic interferometry of hypersonic flow, Shock Waves, 2001, 11, pp 23–29.Google Scholar
18. Rom, J. Measurements of heat transfer rates in separated regions in a shock tube and in a shock tunnel, AIAA J, 1963, 1, (9), pp 2193–2194.Google Scholar
19. Mallinson, S.G., Gai, S.L. and Mudford, N.R. Establishment of steady separated flow over a compression-corner in a free-piston shock tunnel, Shock Waves, 1997, 7, pp 249–253.Google Scholar
20. Trucco, R.E. and Tamagno, J. Elimination of an external noise spike on thin-film temperature traces, June 1990, GASL Technical Memorandum TM 240.Google Scholar
21. Hung, CM., and McCormack, R.W. Numerical solutions of supersonic and hypersonic laminar compression corner flows, AIAA J, 1976, 14, (4), pp 475–481.Google Scholar
22. Walberg, G.D. Hypersonic flight experience, Philosophical Transactions of the Royal Society of London, A, 1991, 335, pp. 91–119.Google Scholar
23. Mallinson, S.G., Gai, S.L. and Mudford, N.R., The boundary layer on a flat plate in hypervelocity flow, Aeronaut J, May 1996, 100, (995), pp 135–141.Google Scholar
24. Weiss, R.F. and Nelson, W. Upstream influence of the base pressure, AIAA J, 1968, 6, (3), pp 466–471.Google Scholar
25. Weiss, R.F. Base pressure of slender bodies in laminar, hypersonic flow, AIAA J, 4, (9), 1966, pp 1557–1559.Google Scholar
26. Weiss, R.F., and Weinbaum, S. Hypersonic boundary-layer separation and the base flow problem, AIAA J, 1966, 4, (8), pp 1321–1330.Google Scholar
27. Jackson, A.P., Hillier, R. and Soltani, S. Experimental and computational study of laminar cavity flows at hypersonic speeds, J Fluid Mech, 2001, 427, pp 329–358.Google Scholar
28. Hayne, M.J., Gai, S.L., Hillier, R., Morgan, R.G., Mee, D.J. and McIntyre, T.J. Heat transfer and flow behind a rearward facing step in a super-orbital expansion tube, 2001, Proceedings of the 23rd International symposium on shock waves, Lu, F.K. (ED), published by The University of Texas, Arlington, US, 2002, pp 1574–1580.Google Scholar
29. Charwat, A.F., Dewey, C.F., Roos, J.N., and Hrrz, J.A. An investigation of separated flows — part I: the pressure field, J Aerospace Set, 28, 1961, pp 513–527.Google Scholar