Hostname: page-component-cd9895bd7-q99xh Total loading time: 0 Render date: 2024-12-28T21:59:59.023Z Has data issue: false hasContentIssue false
  • English
  • Français

Blockage Corrections for Blunt-Based Bodies of Revolution

Published online by Cambridge University Press:  04 July 2016

W. A. Mair
W. A. Mair*
Affiliation:
Engineering Department, Cambridge University
Get access Rights & Permissions [Opens in a new window]

Extract

Calvert has considered alternative methods of estimating the blockage corrections for blunt-based bodies of revolution in closed wind tunnels at low Mach numbers. His models were all of maximum diameter 152 mm, with an ellipsoidal nose section 203 mm long followed by a cylindrical afterbody. The ratio of overall length L to maximum diameter d varied from about 1.5 to 5.5. For each model the base pressure was measured in wind tunnels of two different sizes, so that the blockage correction factor e for the smaller tunnel could be derived for each model from the experimental results. These experimental values of e were compared with alternative theoretical estimates, using the methods given by Evans, Maskell and Pank-hurst and Holder.

Type
Technical Notes
Information
The Aeronautical Journal , Volume 72 , Issue 696 , December 1968 , pp. 1058
Copyright
Copyright © Royal Aeronautical Society 1968 

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

1. Calvert, J. R. Blockage corrections for blunt-based bodies of revolution. J Roy Aero Soc, Vol 70, pp 532–533, April 1966.Google Scholar
2. Evans, J. Y. G. Corrections to velocity for wall constraint in any 10x7 rectangular subsonic wind tunnel. ARC R and M 2662, 1953.Google Scholar
3. Maskell, E. C. A theory of the blockage effects on bluff bodies and stalled wings in a closed wind tunnel. ARC R and M 3400, 1965.Google Scholar
4. Pankhurst, R. C. and Holder, D. W. Wind-Tunnel Technique, pp 340–348. Pitman, 1952.Google Scholar