Flow Studies of the Leading Edge Stall on a Swept-Back Wing at High Incidence

Summary

The flow separation on a swept-back wing with 44 degrees leading edge sweep at 18 degrees incidence has been investigated by means of detailed pressure distribution measurements over the leading edge, boundary layer flow determination with liquid film technique, and yawmeter traverses. A wool-tuft grid was also used, and a spin detector was developed to search for regions of vorticity. These tests established that the flow separates on the leading edge; over the inboard sections it re-attaches behind a “ short” separation bubble, while outboard it only re-attaches near the trailing edge, thus forming a “ long ” separation bubble, or else fails to attach. The separated flow in what has been commonly called the tip stall does in fact take the form of a “ ram's horn “ vortex with the origin, or “ tip,” located at the junction of the two bubbles on the leading edge. The vortex lies outwards across the wing surface at approximately 20 to 25 degrees to the line-of-flight before curving aft to be shed into the wake, where it extends almost from mid semi-span to the wing tip. This vortex induces considerable changes in flow direction, both on and over the wing, and also in the wake. Thus in the wake a maximum downwash of 23 degrees is induced aft of the mid semi-span, and there is an upwash of 17 degrees at the outer edge of the vortex, almost aft of the tip. A good correlation between yawmeter results and the boundary layer flow direction indications from the liquid film technique was obtained.