Hostname: page-component-cd9895bd7-7cvxr Total loading time: 0 Render date: 2024-12-28T04:29:15.157Z Has data issue: false hasContentIssue false
  • English
  • Français

Compression Tests on Thin-Walled Cylinders

Published online by Cambridge University Press:  07 June 2016

M. Holmes
M. Holmes*
Affiliation:
Department of Civil Engineering, University of Bristol
Get access

Summary

The paper describes compression tests on eight thin-walled cylinders of 3 ft. diameter and 0·035 in. wall thickness made of aluminium alloy plate. The lengths of the cylinders were either 6 ft. or 9 ft. Three of the cylinders were tested under axial compression up to buckling failure, and the initial buckling load, failing load and mode of buckling were observed. A further three cylinders were similarly tested, but these cylinders were subjected to internal pressure before applying the compressive load. The internal pressure had a twofold strengthening effect on these cylinders. Firstly, it induced a tensile pre-stress along the axis of the cylinder and, secondly, it resulted in the value of the compressive stress at which buckling occurred being greater than the buckling stress value for the unpressurised cylinders. The six cylinders were tested in a manner which allowed the end face of each cylinder to rotate about a diametral axis. A parallel platen device was used in testing the last two cylinders (in an unpressurised condition) which restrained rotation of the end faces of the cylinders. These tests enabled the effect of end restraint to be studied, and also enabled measurements of load-carrying capacity at large axial deflections to be made. The initial buckling loads, failing loads and modes of buckling observed in the tests were compared with existing large deflection theory.

Type
Research Article
Information
Aeronautical Quarterly , Volume 12 , Issue 2 , May 1961 , pp. 150 - 164
Copyright
Copyright © Royal Aeronautical Society. 1961

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

1. Southwell, R. V. On the General Theory of Elastic Stability. Phil. Trans. Roy. Soc. A, Vol. 213, 1914.Google Scholar
2. Leggett, D. M. A. and Jones, R. P. N. The Behaviour of a Cylindrical Shell under Axial Compression when the Buckling Load has been Exceeded. R. & M. 2190, 1942.Google Scholar
3. Lo, H., Crate, H. and Schwartz, E. B. Buckling of Thin-Walled Cylinder under Axial Compression and Internal Pressure. N.A.C.A. Report 1027, 1951.Google Scholar
4. Fung, Y. C. and Sechler, E. E. Buckling of Thin-Walled Circular Cylinders under Axial Compression and Internal Pressure. Journal of the Aeronautical Sciences, Vol. 24, 1957.Google Scholar
5. Kanemusu, S. and Nojima, H. Axial Compression Tests of Thin Circular Cylinders. M.S. Thesis, Guggenheim Aeronautical Laboratory, California Institute of Technology, 1939.Google Scholar
6. Robertson, A. The Strength of Tubular Struts. Proc. Roy. Soc, A, Vol. 121, p. 558, 1928.Google Scholar