A homodyne transceiver MMIC using SiGe:C technology for 60 GHz wireless applications
Published online by Cambridge University Press: 19 April 2011
Abstract
A highly integrated transceiver microwave monolithic integrated circuit (MMIC) manufactured in a 200-GHz SiGe:C production technology is presented, applicable for sensing- and broadband communication applications. To simplify the analog frontend, the fully differential design is based on a homodyne architecture. It comprises an LO signal generation unit based on a wideband 60 GHz fundamental Voltage Controlled Oscillator (VCO) and an on-chip prescaler, covering the full operational frequency band of 57–64 GHz. Within this bandwidth, the upconverter exhibits an upconversion gain of 23.6–26.4 dB and a maximum output-referred 1-dB compression point of 14 dBm. The downconverter provides a Double Sideband (DSB) noise figure of 9–12 dB with a downconversion gain of 37–71 dB. On chip AC-coupling of the receiver IF-output with a lower −3 dB cut-off frequency as low as 16 kHz eliminates mixer DC-offsets and enables on-chip Intermediate Frequency (IF) amplification. The whole transceiver MMIC draws a current of 415 mA from a single 3.3 V supply and requires few components externally to the chip.
Keywords
- Type
- Research Article
- Information
- International Journal of Microwave and Wireless Technologies , Volume 3 , Special Issue 2: 60 GHz Wireless Communication Circuits and Systems , April 2011 , pp. 147 - 155
- Copyright
- Copyright © Cambridge University Press and the European Microwave Association 2011
References
REFERENCES
- 5
- Cited by