Hostname: page-component-cd9895bd7-gbm5v Total loading time: 0 Render date: 2024-12-26T07:37:04.332Z Has data issue: false hasContentIssue false

Direct numerical simulation of a confined three-dimensional gas mixing layer with one evaporating hydrocarbon-droplet-laden stream

Published online by Cambridge University Press:  10 April 1999

R. S. MILLER
Affiliation:
Jet Propulsion Laboratory, MS 125-121, California Institute of Technology, Pasadena, CA 91109-8099, USA Present address: Department of Mechanical Engineering, Clenson University, Clenson, SC 29634-0921, USA, e-mail: richard.miller@ces.clenson.edu.
J. BELLAN
Affiliation:
Jet Propulsion Laboratory, MS 125-121, California Institute of Technology, Pasadena, CA 91109-8099, USA

Abstract

Direct numerical simulations are performed of a confined three-dimensional, temporally developing, initially isothermal gas mixing layer with one stream laden with as many as 7.3×105 evaporating hydrocarbon droplets, at moderate gas temperature and subsonic Mach number. Complete two-way phase couplings of mass, momentum and energy are incorporated which are based on a thermodynamically self-consistent specification of the vapour enthalpy, internal energy and latent heat of vaporization. Effects of the initial liquid mass loading ratio (ML), initial Stokes number (St0), initial droplet temperature and flow three-dimensionality on the mixing layer growth and development are discussed. The dominant parameter governing flow modulation is found to be the liquid mass loading ratio. Variations in the initial Stokes number over the range 0.5[les ]St0[les ]2.0 do not cause significant modulations of either first- or second-order gas phase statistics. The mixing layer growth rate and kinetic energy are increasingly attenuated for increasing liquid loadings in the range 0[les ]ML[les ]0.35. The laden stream becomes saturated before evaporation is completed for all but the smallest liquid loadings owing to: (i) latent heat effects which reduce the gas temperature, and (ii) build up of the evaporated vapour mass fraction. However, droplets continue to be entrained into the layer where they evaporate owing to contact with the relatively higher-temperature vapour-free gas stream. The droplets within the layer are observed to be centrifuged out of high-vorticity regions and to migrate towards high-strain regions of the flow. This results in the formation of concentration streaks in spanwise braid regions which are wrapped around the periphery of secondary streamwise vortices. Persistent regions of positive and negative slip velocity and slip temperature are identified. The velocity component variances in both the streamwise and spanwise directions are found to be larger for the droplets than for the gas phase on the unladen stream side of the layer; however, the cross-stream velocity and temperature variances are larger for the gas. Finally, both the mean streamwise gas velocity and droplet number density profiles are observed to coincide for all ML when the cross-stream coordinate is normalized by the instantaneous vorticity thickness; however, first-order thermodynamic profiles do not coincide.

Type
Research Article
Copyright
© 1999 Cambridge University Press

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)