Hostname: page-component-cd9895bd7-gvvz8 Total loading time: 0 Render date: 2024-12-29T03:59:22.710Z Has data issue: false hasContentIssue false
  • English
  • Français

Unsteady flow structures around a high-drag Ahmed body

Published online by Cambridge University Press:  16 July 2015

B. F. Zhang ,
Y. Zhou  and
S. To
B. F. Zhang
Affiliation:
Institute for Turbulence–Noise–Vibration Interactions and Control, Shenzhen Graduate School, Harbin Institute of Technology, Shenzhen 518055, China Department of Mechanical Engineering, The Hong Kong Polytechnic University, Hung Hom, Kowloon, Hong Kong, China
Y. Zhou*
Affiliation:
Institute for Turbulence–Noise–Vibration Interactions and Control, Shenzhen Graduate School, Harbin Institute of Technology, Shenzhen 518055, China
S. To
Affiliation:
State Key Laboratory of Ultra-precision Machining Technology, Department of Industrial and System Engineering, The Hong Kong Polytechnic University, Hung Hom, Kowloon, Hong Kong, China
*
†Email address for correspondence: zhouyu@hitsz.edu.cn
Get access Rights & Permissions [Opens in a new window]

Abstract

This work aims to gain a relatively thorough understanding of unsteady predominant coherent structures around an Ahmed body with a slant angle of $25^{\circ }$, corresponding to the high-drag regime. Extensive hot-wire, flow visualization and particle image velocimetry measurements were conducted in a wind tunnel at $\mathit{Re}=(0.45{-}2.4)\times 10^{5}$ around the Ahmed body. A number of distinct Strouhal numbers (St) have been found, two over the rear window, three behind the vertical base and two above the roof. The origin of every St has been identified. The two detected above the roof are ascribed to the hairpin vortices that emanate from the recirculation bubble formed near the leading edge and to the oscillation of the core of longitudinal vortices that originate from bubble pulsation, respectively. The two captured over the window originate from the hairpin vortices and the shear layers over the roof and side surface, respectively. One measured in the wake results from the structures emanating alternately from the upper and lower recirculation bubbles. The remaining two detected behind the lower edge of the base are connected to the cylindrical struts, respectively, which simulate wheels. These unsteady structures and corresponding St reconcile the widely scattered St data in the literature. The dependence on Re of these Strouhal numbers is also addressed, along with the effect of the turbulent intensity of oncoming flow on the flow structures. A conceptual model is proposed for the first time, which embraces both steady and unsteady coherent structures around the body.

JFM classification

Wakes/Jets: Separated flows Vortex Flows: Vortex interactions Wakes/Jets: Wakes
Type
Papers
Information
Journal of Fluid Mechanics , Volume 777 , 25 August 2015 , pp. 291 - 326
Check for updates
Copyright
© 2015 Cambridge University Press 

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

Ahmed, S. R., Ramm, G. & Faltin, G.1984 Some salient features of the time-averaged ground vehicle wake. SAE Technical paper 840300, 1–30, Society of Automotive Engineers, Inc., Warrendale, PA.Google Scholar
Alam, M. M., Zhou, Y. & Wang, X. W. 2011 The wake of two side-by-side square cylinders. J. Fluid Mech. 669, 432–471.Google Scholar
Angelis, W., Drikakis, D., Durst, F. & Khier, W. 1996 Numerical and experimental study of the flow over a two-dimensional car model. J. Wind Engng Ind. Aerodyn. 62, 57–79.CrossRefGoogle Scholar
Antonia, R. A., Zhou, Y. & Matsumara, M. 1993 Spectral characteristics of momentum and heat transfer in the turbulent wake of a circular cylinder. Exp. Therm. Fluid Sci. 6, 371–375.Google Scholar
Aubrun, S., Mcnally, J., Alvi, F. & Kourta, A. 2011 Separation flow control on a generic ground vehicle using steady microjet arrays. Exp. Fluids 51, 1177–1187.Google Scholar
Beaudoin, J. F. & Aider, J. L. 2008 Drag and lift reduction of a 3D bluff body using flaps. Exp. Fluids 44, 491–501.CrossRefGoogle Scholar
Boucinha, V., Weber, R. & Kourta, A. 2011 Drag reduction of a 3D bluff body using plasma actuators. Intl J. Aerodyn. 1, 262–280.Google Scholar
Bruneau, C., Creuse, E., Delphine, D., Gillieron, P. & Mortazavi, I. 2011 Active procedures to control the flow past the Ahmed body with a 25° rear window. Intl J. Aerodyn. 1, 299–317.CrossRefGoogle Scholar
Brunn, A., Wassen, E., Sperber, D., Nitsche, W. & Thiele, F. 2007 Active drag control for a generic car model. In Active Flow Control, NNFM, vol. 95, pp. 247–259. Springer.CrossRefGoogle Scholar
Conan, B., Anthoine, J. & Planquart, P. 2011 Experimental aerodynamics study of a car-type bluff body. Exp. Fluids 50, 1273–1284.Google Scholar
Franck, G., Nigro, N., Storti, M. & D’elia, J. 2009 Numerical simulation of the flow around the Ahmed vehicle model. Latin Am. Appl. Res. 39, 295–306.Google Scholar
Grandemange, M., Gohlke, M. & Cadot, O. 2013 Turbulent wake past a three-dimensional blunt body. Part 1. Global modes and bi-stability. J. Fluid Mech. 722, 51–84.Google Scholar
Heft, A. I., Indinger, T. & Adams, N. A.2011 Investigations of unsteady flow structures in the wake of a realistic generic car model. AIAA Paper 2011-3669.Google Scholar
Huang, J. F., Zhou, Y. & Zhou, T. M. 2006 Three-dimensional wake structure measurement using a modified PIV technique. Exp. Fluids 40, 884–896.CrossRefGoogle Scholar
Hucho, W. H. & Sovran, G. 1993 Aerodynamics of road vehicles. Annu. Rev. Fluid Mech. 25, 485–537.Google Scholar
Joseph, P., Amandolese, X. & Aider, J. L. 2012 Drag reduction on the $25^{\circ }$ slant angle Ahmed reference body using pulsed jets. Exp. Fluids 52, 1169–1185.CrossRefGoogle Scholar
Kaiser, E., Noack, B. R., Cordier, L., Spohn, A., Segond, M., Abel, M., Daviller, G., Östh, J., Krajnović, S. & Niven, R. K. 2014 Cluster-based reduced-order modelling of a mixing layer. J. Fluid Mech. 754, 365–414.Google Scholar
Kiya, M. & Sasaki, K. 1985 Structure of large-scale vortices and unsteady reverse flow in the reattaching zone of a turbulent separation bubble. J. Fluid Mech. 154, 463–491.Google Scholar
Kourta, A. & Leclerc, C. 2013 Characterization of synthetic jet actuation with application to Ahmed body wake. Sensors Actuators A 192, 13–26.CrossRefGoogle Scholar
Krajnović, S. 2014 Large eddy simulation exploration of passive flow control around an Ahmed body. Trans. ASME: J. Fluids Engng 136, 121103.Google Scholar
Krajnović, S. & Davidson, L. 2005a Flow around a simplified car. Part 2: understanding the flow. Trans. ASME: J. Fluids Engng 127, 919–928.Google Scholar
Krajnović, S. & Davidson, L. 2005b Influence of floor motions in wind tunnels on the aerodynamics of road vehicles. J. Wind Engng 93, 677–696.Google Scholar
Krentel, D., Muminovic, R., Brunn, A., Nitsche, W. & King, R. 2010 Application of active flow control on generic 3D car models. In Active Flow Control, NNFM, vol. 108, pp. 223–239. Springer.Google Scholar
Lienhart, H. & Becker, S.2003 Flow and turbulence structures in the wake of a simplified car model. SAE Technical Paper 2003-01-0656, Society of Automotive Engineers, Inc., Warrendale, PA.Google Scholar
Logdberg, O., Fransson, J. H. M. & Alfredsson, P. H. 2009 Streamwise evolution of longitudinal vortices in a turbulent boundary layer. J. Fluid Mech. 623, 27–58.CrossRefGoogle Scholar
Minguez, M., Pasquetti, R. & Serre, E. 2008 High-order large-eddy simulation of flow over the Ahmed body car model. Phys. Fluids 20, 095101.Google Scholar
ÖSth, J., Noack, B. R., Krajnović, S., Barros, D. & Borée, J. 2014 On the need for a nonlinear subscale turbulence term in POD models as exemplified for a high-Reynolds-number flow over an Ahmed body. J. Fluid Mech. 747, 518–544.Google Scholar
Schlichting, H. & Gersten, K. 2000 Boundary Layer Theory, 8th revised. p. 22. Springer.Google Scholar
Shabaka, I. M. M. A., Mehta, R. D. & Bradshaw, P. 1985 Longitudinal vortices imbedded in turbulent boundary layers. Part 1. Single vortex. J. Fluid Mech. 155, 37–57.Google Scholar
Spohn, A. & Gillieron, P. 2002 Flow separations generated by a simplified geometry of an automotive vehicle. In IUTAM Symposium: Unsteady Separated Flows. Kluwer Academic.Google Scholar
Tafti, D. K. & Vanka, S. P. 1991 A three-dimensional numerical study of flow separation and reattachment on a blunt plate. Phys. Fluids A 3, 2887–2909.Google Scholar
Thacker, A., Aubrun, S., Leroy, A. & Devinant, P.2010 Unsteady analyses of the flow separation on the rear window of a simplified ground vehicle model. AIAA Paper 2010-4569.Google Scholar
Thacker, A., Aubrun, S., Leroy, A. & Devinant, P. 2013 Experimental characterization of flow unsteadiness in the centerline plane of an Ahmed body rear slant. Exp. Fluids 54, 1479,1–16.Google Scholar
Vino, G., Watkins, S., Mousley, P., Watmuff, J. & Prasad, S. 2005 Flow structures in the near-wake of the Ahmed model. J. Fluids Struct. 20, 673–695.Google Scholar
Wang, S., Zhou, Y., Alam, M. M. & Yang, H. 2014 Turbulent intensity and Reynolds number effects on an airfoil at low Reynolds numbers. Phys. Fluids 26, 115107.Google Scholar
Wang, H. F., Zhou, Y. & Mi, J. 2012 Effects of aspect ratio on the drag of a wall-mounted finite-length cylinder wake in subcritical and critical regimes. Exp. Fluids 53, 423–436.CrossRefGoogle Scholar
Wang, X. W., Zhou, Y., Pin, Y. F. & Chan, T. L. 2013 Turbulent near wake of an Ahmed vehicle model. Exp. Fluids 54, 1490,1–19.CrossRefGoogle Scholar
Wassen, E. & Thiele, F.2008 Drag reduction for a generic car model using steady blowing. AIAA Paper 2008-3771.Google Scholar
Wassen, E. & Thiele, F.2010 Simulation of active separation control on a generic vehicle. AIAA Paper 2010-4702.CrossRefGoogle Scholar
Zhang, B. F., To, S. & Zhou, Y. 2013 Strouhal numbers of unsteady flow structures around a simplified car model. In Fluid-Structure-Sound Interactions and Control, Proceedings of the 2nd Symposium on Fluid-Structure-Sound Interactions and Control (ed. Zhou, Y., Liu, Y., Huang, L. & Hodges, D.), pp. 179–184. Springer.Google Scholar
Zhou, Y. & Antonia, R. 1994 Critical points in a turbulent near-wake. J. Fluid Mech. 275, 59–81.Google Scholar
Zhou, Y., Du, C., Mi, J. & Wang, X. W. 2012 Turbulent round jet control using two steady mini-jets. AIAA J. 50, 736–740.Google Scholar