Hostname: page-component-cd9895bd7-mkpzs Total loading time: 0 Render date: 2024-12-27T23:43:48.618Z Has data issue: false hasContentIssue false
  • English
  • Français

Y2BaCuO5 addition and its effects on critical currents in large grains of YBa2Cu3O7–δ: A quantitative microstructural study

Published online by Cambridge University Press:  31 January 2011

Manoj Chopra ,
Siu-Wai Chan ,
R. L. Meng  and
C. W. Chu
Manoj Chopra
Affiliation:
Henry Krumb School of Mines, Columbia University, New York, New York 10027
Siu-Wai Chan
Affiliation:
Henry Krumb School of Mines, Columbia University, New York, New York 10027
R. L. Meng
Affiliation:
Texas Center of Superconducting Research Houston, Texas 77204
C. W. Chu
Affiliation:
Texas Center of Superconducting Research Houston, Texas 77204
Get access

Abstract

The addition of Y2BaCuO5 (211) particles to large grain melt textured YBa2Cu3O7–δ(Y123) has significantly improved the critical current density (Jc) of this material. Here, a systematic quantitative analysis on the effects of the 211 addition was performed on a microscopic scale with a systematic variation of the initial volume percent of 211. From the correlation between critical current measurements and quantitative microscopy of both (001) and (110) sections, a maximum value of Jc is observed, corresponding to a measured Y123 volume percent of 20% ± 3%. Accounting for the loss of liquid phase for the present processing, the corresponding optimum initial volume of 211 for the highest measured Jc is 40%. Further comparison between the weighted Jc and the true flux pinning force (Fp) also shows a maximum pinning force for an initial 211 addition of 40%. Although the weighted Jc starts to decrease with an initial 211 volume of above 40%, the pinning efficiency at higher magnetic fields (2–4 T) of the superconducting Y123 matrix was actually improved with an ever increasing 211 addition to at least 50%. Though an increasing addition of 211 is effective in producing efficient flux pinning sites in the Y123 matrix, percolation paths in the Y123 matrix become limited for supercurrent. Hence, a measured 211 volume corresponding to 80% 211 is proved to give the best possible critical current density. Furthermore, crack opening and crack spacing of the superficial cracks are found to decrease with an increasing 211 addition and with a decreasing 211 interparticle spacing. The penetration and surface length of each of these superficial cracks are hence reduced, which leads to a better electrical connectivity in the Y123 matrix.

Type
Articles
Information
Journal of Materials Research , Volume 11 , Issue 7 , July 1996 , pp. 1616 - 1626
Copyright
Copyright © Materials Research Society 1996

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1.Jin, S., Tiefel, T. H., Sherwood, R. C., Davis, M. E., van Dover, R. B., Kammlott, G. W., Fastnacht, R. A., and Keith, H. D., Appl. Phys. Lett. 52, 2074 (1988).CrossRefGoogle Scholar
2.Varanasi, C. and Ginn, P. J., Physica C 207, 79–84 (1993).CrossRefGoogle Scholar
3.Hor, P. H., Huang, Z. J., Gao, L., Meng, R. L., Xue, Y. Y., Chu, C. W., Jean, Y. C., and Farmer, J., Mod. Phys. Lett. B 4, 703 (1990).CrossRefGoogle Scholar
4.Murakami, M., Gotoh, S., Fujimoto, H., Yamaguchi, K., Koshizuka, N., and Tanaka, S., Supercond. Sci. Technol. 4, S43 (1991).CrossRefGoogle Scholar
5.Lee, D. F., Chaud, X., and Salama, K., Jpn. J. Appl. Phys. 31, 2411 (1992).CrossRefGoogle Scholar
6.Lee, D. F., Selvamanickam, V., and Salama, K., Physica C 202, 83–96 (1992).CrossRefGoogle Scholar
7.McGinn, P., Zhu, N., Chen, W., Sengupta, S., and Li, T., Physica C 176, 203–208 (1991).CrossRefGoogle Scholar
8.Jin, S., Kamlott, G. W., Tiefel, T. H., Kodas, T., Ward, T. L., and Kroeger, D. M., Physica C 181, 57–62 (1991).CrossRefGoogle Scholar
9.Meng, R. L., Gao, L., Gautier, P., Ramirez, D., Sun, Y. Y., and Chu, C. W., Physica C 232, 337 (1994).CrossRefGoogle Scholar
10.Bean, C. P., Phys. Rev. Lett. 8, 250 (1962).CrossRefGoogle Scholar
11.Voort, Vander, Metallography, Principles and Practice (McGraw-Hill Book Company, New York, 1984), pp. 426, 480.CrossRefGoogle Scholar
12.Chopra, Manoj, Boyko, V.S., Meng, R.L., Chu, C. W., and Chan, S.W., unpublished.Google Scholar
13.Cardwell, D. A. and Campbell, A. M., Interdisciplinary Research Center (University of Cambridge, 1995), p. 146.Google Scholar
14.Zallen, R., The Physics of Amorphous Solids (John Wiley and Sons Inc., New York), p. 170.Google Scholar
15.Meng, R. L., Sun, Y. Y., Hor, P. H., and Chu, C. W., Physica C 179, 149 (1991).CrossRefGoogle Scholar