Hostname: page-component-cd9895bd7-dzt6s Total loading time: 0 Render date: 2024-12-28T06:11:51.415Z Has data issue: false hasContentIssue false
  • English
  • Français

The effect of dynamic strain aging on fatigue property for 316L stainless steel

Published online by Cambridge University Press:  11 March 2016

Dan Jin ,
Jianghua Li  and
Ning Shao
Dan Jin*
Affiliation:
School of Energy and Power Engineering, Shenyang University of Chemical Technology, Shenyang 110142, Liaoning, China
Jianghua Li
Affiliation:
School of Energy and Power Engineering, Shenyang University of Chemical Technology, Shenyang 110142, Liaoning, China
Ning Shao
Affiliation:
School of Energy and Power Engineering, Shenyang University of Chemical Technology, Shenyang 110142, Liaoning, China
*
a) Address all correspondence to this author. e-mail: jindan76@163.com
Get access

Abstract

The effect of strain range on dynamic strain aging (DSA) is discussed based on the low cycle fatigue tests for different strain ranges conducted for 316L stainless steel at strain rate of 1 × 10−3 s−1. The variations of stress drop and hardening ratio are both compared for different strain ranges. The variations of stress drop are attributed to the dependence of vacancy concentration on strain range. The hardening ratio is higher at 600 °C than those at 20 °C and secondary hardening behavior occurs for larger strain range. The dependence of DSA on the number of cycles and the wave type for different stages are analyzed. Obvious DSA is observed in first few cycles, followed by weakening serrated yielding. However, the serrated yielding occurs again before fatigue failure. The difference of serrated yielding can be explained by the types of atom atmospheres at different cycles. A serrated wave is observed for smaller strain ranges, however, A, B, A + B, C, and B + C serrated waves can be found at different cycles for larger strain range. Finally, the crack nucleation and propagation on fracture surfaces are characterized by scanning electron microscope (SEM).

Keywords

fatiguemetal
Type
Articles
Information
Journal of Materials Research , Volume 31 , Issue 5 , 14 March 2016 , pp. 627 - 634
Copyright
Copyright © Materials Research Society 2016 

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

Hong, S.G., Lee, S.B., and Byun, T.S.: Temperature effect on the low-cycle fatigue behavior of type 316L stainless steel: Cyclic non-stabilization and an invariable fatigue parameter. Mater. Sci. Eng., A 457, 139–147 (2007).CrossRefGoogle Scholar
Jiang, H.F., Chen, X.D., Fan, Z.C., Dong, J., Jiang, H., and Lu, S.X.: Dynamic strain aging in stress controlled creep–fatigue tests of 316L stainless steel under different loading conditions. J. Nucl. Mater. 392, 494–497 (2009).CrossRefGoogle Scholar
Portevin, A. and Le Chatelier, F.: Sur un phénomène observé lors de l'essai detraction d'alliages encours de transformation. Comptes Rendus de l'Académiedes Science 176, 507–510 (1923).Google Scholar
Cottrell, A.H.: A note on the Portevin-Le Chatelier effect. Philos. Mag. 44, 829–832 (1953).CrossRefGoogle Scholar
McCormick, P.G.: A model for the Portevin-Le Chatelier effect in substitutional alloys. Acta Metall. 20, 351–354 (1972).CrossRefGoogle Scholar
Van den Beukel, A.: Theory of the effect of dynamic strain aging on mechanical properties. Phys. Status Solidi. 30, 197–206 (1975).CrossRefGoogle Scholar
Schoeck, G.: The Portevin-Le Chatelier. A kinetic theory. Acta Metall. 32, 1229–1234 (1984).CrossRefGoogle Scholar
Xiao, L.G., Li, X.Q., and Qian, K.W.: A model for the occurrence of serrated yielding in substitutional alloys. Sci. China, Ser. A: Math., Phys., Astron. Technol. Sci. 11, 1386–1396 (1990).Google Scholar
Kanazawa, K., Yamaguchi, K., and Nishijima, S.: Mapping of low cycle fatigue mechanism at elevated temperatures for an austenitic steel. Low Cycle Fatigue. ASTM-STP942 (1988); pp. 519–530.CrossRefGoogle Scholar
Srinivasan, V.S., Sandhya, R., Bhanu Sankara Rao, K., Mannan, S.L., and Raghavan, K.S.: Effects of temperature on the low cycle fatigue behaviour of nitrogen alloyed type 316L stainless steel. Int. J. Fatigue 13, 471–478 (1991).CrossRefGoogle Scholar
Srinivasan, V.S., Valsan, M., Sandhya, R., Bhanu Sankara Rao, K., Mannan, S.L., and Sastry, D.H.: High temperature time-dependent low cycle fatigue behaviour of a type 316L(N) stainless steel. Int. J. Fatigue 21, 11–21 (1999).CrossRefGoogle Scholar
Hong, S.G., Lee, K.O., and Lee, S.B.: Dynamic strain aging effect on the fatigue resistance of type 316L stainless steel. Int. J. Fatigue 27, 1420–1424 (2005).CrossRefGoogle Scholar
Jiang, H.F., Chen, X.D., Fan, Z.C., Dong, J., Jiang, H., and Lu, S.X.: Influence of dynamic strain aging pre-treatment on creep-fatigue behavior in 316L stainless steel. Mater. Sci. Eng., A 500, 98–103 (2009).CrossRefGoogle Scholar
Sarkar, A., Nagesha, A., Sandhya, R., and Mathew, M.D.: On the dynamic strain aging effects during elevated temperature ratcheting of type 316LN stainless steel. High Temp. Mater. Processes 32, 475–484 (2013).CrossRefGoogle Scholar
Choudhary, B.K.: Activation energy for serrated flow in type 316L(N) austenitic stainless steel. Mater. Sci. Eng., A 603, 160–168 (2014).CrossRefGoogle Scholar
Gupta, A.K., Singh, S.K., Reddy, S., and Hariharan, G.: Prediction of flow stress in dynamic strain aging regime of austenitic stainless steel 316 using artificial neural network. Mater. Des. 35, 589–595 (2012).CrossRefGoogle Scholar
Pham, M.S. and Holdsworth, S.R.: Dynamic strain ageing of AISI 316L during cyclic loading at 300 °C: Mechanism, evolution, and its effects. Mater. Sci. Eng., A 556, 122–133 (2012).CrossRefGoogle Scholar
Chen, L.J., Wang, C.Y., Wu, W., Liu, Z., Stoica, G.M., Wu, L., and Liaw, P.K.: Low-cycle fatigue behavior of an as-extruded AM50 magnesium alloy. Metall. Mater. Trans. A 38, 2235–2241 (2007).CrossRefGoogle Scholar
Chai, G.C. and Andersson, M.: Secondary hardening behavior in super duplex stainless steels during LCF in dynamic strain ageing regime. Protein Eng. 55, 123–127 (2013).Google Scholar
Hong, S.G., Samson, Y., and Lee, S.B.: The effect of temperature on low-cycle fatigue behavior of prior cold worked 316L stainless steel. Int. J. Fatigue 25, 1293–1300 (2003).CrossRefGoogle Scholar
Prasad Reddy, G.V., Sandhya, R., Mathew, M.D., and Sankaran, S.: Influence of secondary cyclic hardening on the low cycle fatigue behavior of nitrogen alloyed 316LN stainless steel. Metall. Mater. Trans. A 44, 5625–5629 (2013).CrossRefGoogle Scholar
Yu, D.J., Yu, W.W., Chen, G., Jin, F.M., and Chen, X.: Role of dynamic strain aging in the tensile property, cyclic deformation and fatigue behavior of Z2CND18.12N stainless steel between 293 K and 723 K. Mater. Sci. Eng., A 558, 731–736 (2012).CrossRefGoogle Scholar
Rodriguez, P.: Serrated plastic flow. Bull. Mater. Sci. 6, 653–663 (1984).CrossRefGoogle Scholar
Sudhakar Rao, G., Chakravartty, J.K., Nudurupati, S., Mahobia, G.S., Chattopadhyay, K., SanthiSrinivas, N.C., and Singh, V.: Low cycle fatigue behavior of Zircaloy-2 at room temperature. J. Nucl. Mater. 441, 455–467 (2013).CrossRefGoogle Scholar