Hostname: page-component-78c5997874-94fs2 Total loading time: 0 Render date: 2024-11-15T04:50:15.019Z Has data issue: false hasContentIssue false
  • English
  • Français

Influence of surface roughness on the wetting angle

Published online by Cambridge University Press:  03 March 2011

X.B. Zhou  and
J.Th.M. De Hosson
X.B. Zhou
Affiliation:
Department of Applied Physics, Materials Science Centre, University of Groningen, Nijenborgh 4, 9747 AG Groningen, The Netherlands
J.Th.M. De Hosson
Affiliation:
Department of Applied Physics, Materials Science Centre, University of Groningen, Nijenborgh 4, 9747 AG Groningen, The Netherlands
Get access

Abstract

A this paper the influence of surface roughness on contact angles in the system of liquid Al wetting solid surfaces of Al2O3 has been studied. It was observed that contact angles of liquid Al vary significantly on different rough surfaces of Al2O3. A model is proposed to correlate contact angles with conventional roughness measurements and wavelengths by assuming a cosine profile of rough grooves with a Gaussian distribution of amplitudes. In comparison with the experimental results, the model provides a good estimate for describing the influence of surface roughness on contact angles of liquid Al on Al2O3.

Type
Articles
Information
Journal of Materials Research , Volume 10 , Issue 8 , August 1995 , pp. 1984 - 1992
Copyright
Copyright © Materials Research Society 1995

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1Zhou, X. B. and De Hosson, J. Th.M., Acta Metall. Mater. 42, 1155 (1994).CrossRefGoogle Scholar
2Ip, S. W., Kucharski, M., and Toguri, J. M., J. Mater. Sci. Lett. 12, 1699 (1993).CrossRefGoogle Scholar
3Wenzel, R. N., Ind. Eng. Chem. 28, 988 (1936).CrossRefGoogle Scholar
4Oliver, J. F., Huh, C., and Mason, S. G., Colloids and Surfaces 1, 79 (1980).CrossRefGoogle Scholar
5Johnson, R. E. and Dettre, R. H., Surface and Colloid Science, edited by Matijević, E. (Wiley-Interscience, New York, 1969), Vol. 2, p. 85.Google Scholar
6Cassie, A.B.D. and Baxter, S., Trans. Faraday Soc. 40, 546 (1994).CrossRefGoogle Scholar
7Lin, F.Y.H., Li, D., and Neumann, A. W., J. Colloid Interface Sci. 159, 86 (1993).CrossRefGoogle Scholar
8Drelich, J. and Miller, J. D., J. Colloid Interface Sci. 164, 252 (1994).CrossRefGoogle Scholar
9De Coninck, J., Colloids and Surfaces A 89, 109 (1994).CrossRefGoogle Scholar
10Tretinnikov, O. N. and Ikada, Y., Langmuir 10, 1606 (1994).CrossRefGoogle Scholar
11Nadkarni, G. D. and Garoff, S., Europhysics Lett. 20, 523 (1992).CrossRefGoogle Scholar
12Collet, P., De Coninck, J., and Dunlop, F., Europhysics Lett. 22, 645 (1993).CrossRefGoogle Scholar
13Israelachvili, J. N., Intermolecular and Surface Force (Academic Press, San Diego, CA, 1992), p. 322.Google Scholar
14Thomas, T. R., Rough Surfaces (Longman, London, 1982), pp. 91, 96.Google Scholar
15Busscher, H. J., van Pelt, A.W.J., De Boer, P., De Jong, H.P., and Arends, J., Colloids and Surfaces 9, 319 (1984).CrossRefGoogle Scholar
16Kingery, W. D., Introduction to Ceramics (John Wiley & Sons, New York, 1960), p. 212.Google Scholar