Hostname: page-component-cd9895bd7-lnqnp Total loading time: 0 Render date: 2024-12-28T21:21:22.986Z Has data issue: false hasContentIssue false
  • English
  • Français

Resistivity–temperature behavior of dilute Cu(Ir) and Cu(W) alloy films

Published online by Cambridge University Press:  01 December 2005

K. Barmak ,
C. Cabral Jr. ,
A.J. Kellock  and
J.M.E. Harper
K. Barmak*
Affiliation:
Department of Materials Science and Engineering, Carnegie Mellon University, Pittsburgh, Pennsylvania 15213
C. Cabral Jr.
Affiliation:
IBM T. J. Watson Research Center, Yorktown Heights, New York 10598
A.J. Kellock
Affiliation:
IBM Almaden Research Center, San Jose, California 95120
J.M.E. Harper
Affiliation:
Department of Physics, University of New Hampshire, Durham, New Hampshire 03824
*
a)Address all correspondence to this author.e-mail: katayun@andrew.cmu.edu
Get access

Abstract

The resistivities of as-deposited Cu(4.2Ir), Cu(2.0W), and Cu(2.2W) films are 32.2, 25.4, and 28.0 μΩcm, respectively. These resistivities are significantly higher thanthat for pure Cu films. After annealing the Cu(4.2Ir) film at constant heating rate to 800 °C and the two Cu(W) films to 950 °C, the resistivities reduce to 28.4, 4.3, and 5.2 μΩcm, respectively. The smaller reduction in resistivity for Cu(4.2Ir) compared with that for Cu(W) is partly a consequence of solute redissolution following precipitation. The variation of resistivity with temperature for the films and the Cu-rich end of the binary phase diagrams are used to categorize the decomposition behavior of the Cu(Ir) and Cu(W). These categories were defined by K. Barmak et al., J. Appl. Phys.87, 2204 (2000). W is placed in category III along with V, Nb, Ta, Cr, Mo, Re, Ru, Os, B, and C. Ir most suitably belongs to Category II together with Fe and Co.

Keywords

AlloyMicroelectronicsThin film
Type
Articles
Information
Journal of Materials Research , Volume 20 , Issue 12 , December 2005 , pp. 3391 - 3396
Copyright
Copyright © Materials Research Society 2005

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1.Barmak, K., Lucadamo, G.A., Cabral, C. Jr., Lavoie, C. and Harper, J.M.E.: Dissociation of dilute immiscible copper alloy thin films. J. Appl. Phys. 87, 2204 (2000).CrossRefGoogle Scholar
2.Harper, J.M.E., Gupta, J., Smith, D.A., Chang, J.W., Holloway, K.L., Cabral, C. Jr., Tracy, D.P. and Knorr, D.B.: Crystallographic texture change during abnormal grain growth in Cu–Co thin films. Appl. Phys. Lett. 65, 177 (1994).CrossRefGoogle Scholar
3.Zhang, S-L., Harper, J.M.E., Cabral, C. Jr., and d’Heurle, F.M.: In situ resistivity study of copper-cobalt films: precipitation, dissolution and phase transformation. Thin Solid Films 401, 298 (2001).CrossRefGoogle Scholar
4.Zhang, S-L., Harper, J.M.E. and d’Heurle, F.M.: High conductivity copper-boron alloys obtained by low temperature annealing. J. Electron. Mater. 30, L1 (2001).CrossRefGoogle Scholar
5.Barmak, K., Gungor, A., Cabral, C. Jr., and Harper, J.M.E.: Annealing behavior of Cu and dilute Cu-alloy thin films: Precipitation, grain growth and resistivity. J. Appl. Phys. 94, 1605 (2003).CrossRefGoogle Scholar
6.Binary Alloy Phase Diagrams, edited by Massalski, T.B., Okamoto, H., Subramanian, P.R., and Kacprzak, L., (ASM International, Metals Park, OH, 1990).Google Scholar
7.Barmak, K., Gungor, A., Rollett, A.D., Cabral, C. Jr., and Harper, J.M.E.: Texture of Cu and dilute binary Cu-alloy films: Impact of annealing and solute content. Mater. Sci. Semicond. Proc. 6, 175 (2003).CrossRefGoogle Scholar
8.Gungor, A., Barmak, K., Rollett, A.D., Cabral, C. Jr., and Harper, J.M.E.: Texture and resistivity of dilute binary Cu(Al), Cu(In), Cu(Ti), Cu(Nb), Cu(Ir) and Cu(W) alloy thin films. J. Vac. Sci. Technol. B 20, 2314 (2002).CrossRefGoogle Scholar
9.Gungor, A.: Cu and Cu-alloy thin films: Evolution of resistivity and microstructure. Ph.D. Thesis, Carnegie Mellon University, Pittsburgh, PA (2002).Google Scholar
10.Kissinger, H.E.: Reaction kinetics in differential thermal analysis. Anal. Chem. 29, 17021706(1957).CrossRefGoogle Scholar
11.Butrymowicz, D.B., Manning, J.R. and Read, M.E.: International Copper Research Association Monograph V. The Metallurgy of Copper. Diffusion Rate Data and Mass Transport Phenomena for Copper Systems (National Bureau of Standards, Washington, DC, 1977).Google Scholar
12.Butrymowicz, D.B., Manning, J.R. and Read, M.E.: International Copper Research Association Monograph VIII. The Metallurgy of Copper. Diffusion Rate Data and Mass Transport Phenomena for Copper Systems (National Bureau of Standards, Washington, DC, 1981).Google Scholar