Hostname: page-component-78c5997874-4rdpn Total loading time: 0 Render date: 2024-11-10T10:58:45.999Z Has data issue: false hasContentIssue false
  • English
  • Français

Some Nonlinear Features of the Squeeze-Film Problem

Published online by Cambridge University Press:  05 May 2011

U. Lei  and
Chia-Han Chen
U. Lei*
Affiliation:
Institute of Applied Mechanics, National Taiwan University, Taipei, Taiwan 10617, R.O.C.
Chia-Han Chen*
Affiliation:
Institute of Applied Mechanics, National Taiwan University, Taipei, Taiwan 10617, R.O.C.
*
*Professor
**Graduate student
Get access

Abstract

The nonlinear features of the squeeze-film problem between two parallel long strips driven by the relative harmonic oscillation of the strips is studied via the regular perturbation and numerical calculation for ∈ < 1 and σ = O(1)- O(103), where ∈ is the dimensionless amplitude of the oscillation, and σ is the squeeze number. The fluid film behaves as a (nonlinear) spring for large σ and as a (nonlinear) damper for small σ, which are qualitatively similar to the linear analysis. However, a steady state force is generated even though the driving mechanism is purely oscillatory due to the nonlinear effect. Furthermore, the dimensionless quasi-steady rate of energy dissipation within one cycle of the plate oscillation, E, is not zero (zero for linear analysis), and is maximized at σ ≈ 10. Also the rate of increase of E with ∈ is greater than ∈2. The present study may be helpful for the design of some accelerometers and vibration absorbers.

Keywords

Squeeze-filmNonlinear effectsForceDissipated energy.
Type
Articles
Information
Journal of Mechanics , Volume 15 , Issue 4 , December 1999 , pp. 137 - 147
Copyright
Copyright © The Society of Theoretical and Applied Mechanics, R.O.C. 1999

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1.Griffin, W. S., Richardson, H. H. and Yamanami, S., “A Study of Fluid Squeeze-Film Damping,” ASME J. Basic Eng., Vol. 88, pp. 451–456 (1966).CrossRefGoogle Scholar
2.Blech, J. J., “On Isothermal Squeeze Films,” ASME J. Lubrication Tech., Vol. 105, pp. 615–620 (1983):CrossRefGoogle Scholar
3.Andrews, M., Harris, I. and Turner, G., “A Comparison of Squeeze-Film Theory with Measurements on a Microstructure,” Sensors and Actuators A, Vol. 36, pp. 79–87 (1993).CrossRefGoogle Scholar
4.Gross, W. A., Gas Film Lubrication, John Wiley & Sons, New York (1962).Google Scholar
5.Batchelor, G. K., “An Introduction to Fluid Dynamics,” Cambridge Univ. Press, Cambridge, pp. 353–364 (1967).Google Scholar
6.Chen, Chia-Han, “Study of the Squeeze-Film Problem,” Master Thesis, National Taiwan University (1999).Google Scholar