Hostname: page-component-78c5997874-xbtfd Total loading time: 0 Render date: 2024-11-10T06:06:02.015Z Has data issue: false hasContentIssue false
  • English
  • Français

Crack formation in soda-lime glass after high-power ion beam irradiation

Published online by Cambridge University Press:  12 October 2018

Vladimir S. Kovivchak  and
Tatyana V. Panova
Vladimir S. Kovivchak*
Affiliation:
Physics Department, Dostoevsky Omsk State University, Mira Avenue 55a, Omsk, 644077, Russia
Tatyana V. Panova
Affiliation:
Physics Department, Dostoevsky Omsk State University, Mira Avenue 55a, Omsk, 644077, Russia
*
Author for correspondence: Vladimir S. Kovivchak, Physics Department, Dostoevsky Omsk State University, Mira Avenue 55a, Omsk, 644077, Russia, E-mail: kvs_docent@mail.ru
Get access Rights & Permissions [Opens in a new window]

Abstract

The fractures of a soda-lime glass surface layer were investigated under irradiation by a high-power ion beam of nanosecond duration with different current densities. Two kinds of cracks (perpendicular and approximately parallel irradiated surfaces) have been identified. It is defined that cracks approximately parallel to the surface are localized at a depth of 10 ± 2 µm from the irradiated glass surface after one-time irradiation with a current density of 100 A/cm2. The formation of these cracks was detected within ~170 h after the end of irradiation when irradiated samples were under an air atmosphere. In a vacuum, the growth of these cracks was insignificant. It is shown that irradiation of heated glass or heating of glass started no later than 2–3 min after irradiation can suppress or substantially reduce surface fracture of glass. The possible mechanisms of glass fracture were discussed.

Keywords

Crack formationfracture delayhigh-power ion beamsoda-lime glass
Type
Research Article
Information
Laser and Particle Beams , Volume 36 , Issue 3 , September 2018 , pp. 359 - 362
Copyright
Copyright © Cambridge University Press 2018 

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

Gogoll, S, Stenzel, E, Reichling, M, Johansen, H and Matthias, E (1996) Laser damage of CaF2(111) surfaces at 248 nm. Applied Surface Science 96–98, 332–340.Google Scholar
Kanemitsu, Y and Tanaka, Y (1987) Mechanism of crack formation in glass after high power laser pulse irradiation. Journal of Applied Physics 62, 1208–1211.Google Scholar
Korotaev, AD, Tyumentsev, AN, Pinzhin, YuP and Remnev, GE (2004) Features of the morphology, defect substructure, and phase composition of metal and alloy surfaces upon high-power ion beam irradiation. Surface & Coatings Technology 185, 38–49.Google Scholar
Kovivchak, VS and Panova, TV (2017) Fracture of the surface layers of soda-lime glass under high-power ion beam irradiation. Journal of Surface Investigation: X-ray, Synchrotron and Neutron Techniques 11, 840–843.Google Scholar
Kovivchak, VS, Panova, TV and Burlakov, RB (2008) Damage in lithium niobate induced by a high- power proton-carbon beam. Journal of Surface Investigation: X-ray, Synchrotron and Neutron Techniques 2, 200–202.Google Scholar
Kovivchak, VS, Panova, TV, Krivozubov, OV, Davletkil'deev, NA and Knyazev, EV (2012) Surface damages on single-crystal silicon during irradiation by a powerful ion beam. Journal of Surface Investigation: X-ray, Synchrotron and Neutron Techniques 6, 244–247.Google Scholar
Liang, G, Shen, J, Zhang, J, Zhong, H, Cui, X, Yan, S, Zhang, X, Yu, X and Le, X (2017) The tensile effect on crack formation in single crystal silicon irradiated by intense pulsed ion beam. Nuclear Instruments and Methods in Physics Research Section B 409, 277–281.Google Scholar
Rastogi, V, Chaurasia, S and Munda, DS (2017) Laser induced damage studies in borosilicate glass using nanosecond and sub nanosecond pulses. Journal of Non-Crystalline Solids 463, 138–147.Google Scholar
Remnev, GE, Isakov, IF, Opekounov, MS, Matvienko, VM, Ryzhkov, VA, Struts, VK, Grushin, II, Zakoutayev, AN, Potyomkin, AV, Tarbokov, VA, Pushkaryov, AN, Kutuzov, VL and Ovsyannikov, MYu (1999) High intensity pulsed ion beam sources and their industrial applications. Surface & Coatings Technology 114, 206–212.Google Scholar
Shen, J, Shahid, I, Yu, X, Zhang, J, Zhong, H, Cui, X, Liang, G, Yu, Xiang, Huang, W, Yan, S, Zhang, G, Zhang, X and Le, X (2017) Fracture analysis of surface exfoliation on single crystal silicon irradiated by intense pulsed ion beam. Nuclear Instruments and Methods in Physics Research Section B 413, 6–12.Google Scholar
Uglov, VV, Remnev, GE, Kuleshov, AK, Astashinski, VM and Saltymakov, MS (2010) Formation of hardened layer in WC–TiC–Co alloy by treatment of high intensity pulse ion beam and compression plasma flows. Surface & Coatings Technology 204, 1952–1956.Google Scholar
Wang, X and Fang, X (2015) Study on damage of K9 glass under 248 nm ultraviolet pulsed laser irradiation. Proc. SPIE 9522, Selected Papers from Conferences of the Photoelectronic Technology Committee of the Chinese Society of Astronautics 2014, Part II, 95221U.Google Scholar
Wang, PW, Kimberlin, KR, Chengyu, W, Ying, T, Lin, GQ, Aimin, W and Jun, XJ (2005) Surface cracking of soda lime glass under pulsed high-current electron radiation. Materials Chemistry and Physics 94, 252–256.Google Scholar