Hostname: page-component-cd9895bd7-mkpzs Total loading time: 0 Render date: 2024-12-28T03:37:52.081Z Has data issue: false hasContentIssue false

On the UV-light-induced Desorption/Adsorption Mechanism of Atmospheric Species in Solution-processed Zinc Oxide Thin Films

Published online by Cambridge University Press:  25 January 2019

José Bruno Cantuária
Affiliation:
Physics Department, Institute of Biosciences, Language and Exact Sciences, São Paulo State University – UNESP, São José do Rio Preto15054-000, Brazil
Giovani Gozzi*
Affiliation:
Physics Department, Institute of Geosciences and Exact Sciences, São Paulo State University – UNESP, Rio Claro13506-900, Brazil
Lucas Fugikawa Santos
Affiliation:
Physics Department, Institute of Biosciences, Language and Exact Sciences, São Paulo State University – UNESP, São José do Rio Preto15054-000, Brazil Physics Department, Institute of Geosciences and Exact Sciences, São Paulo State University – UNESP, Rio Claro13506-900, Brazil
Get access

Abstract

Zinc oxide (ZnO) is a n-type transparent semiconductor which can be processed by low cost techniques (such as spray-pyrolysis and spin-coating) and can be applied as the active layer of thin-films transistors (TFTs). The electrical properties of ZnO films are strongly affected when the device is exposed to room conditions and/or UV-light, suggesting possible applications as UV or/and gas sensors. Atmospheric oxygen molecules adsorbed on ZnO surface act as charge traps, decreasing the material conductivity. The incidence of UV-light causes an increase of the material conductivity due to the photogeneration of electron-hole pairs via direct band-to-band transitions (classic photoconductivity process) and due to the desorption of oxygen molecules, which presents a relatively slower response and is a less understood mechanism. In the current paper, we study the influence of environmental parameters, such as temperature, humidity and UV-light intensity, on the electrical properties of spin-coated ZnO thin films to understand the role of the desorption mechanism on the photoconductivity process. The analysis of the device current vs. time curves shows the existence of two light-induced desorption mechanisms: i) one which increases the electrical conductivity of the ZnO film (desorption-like process) and ii) a second one which decreases the conductivity (adsorption-like process). A Plackett-Burman design of experiment (DOE) was used to study the influence of characterization factors like UV intensity, temperature and humidity on electrical parameters obtained from the experimental curves. We observed that the desorption-like process is a first order mechanism, exhibiting desorption rate proportional to n(t), where n(t) represents the adsorbate concentration as a function of the time, whereas the adsorption-like mechanism exhibits a desorption rate proportional to the forth power of n(t).

Type
Articles
Copyright
Copyright © Materials Research Society 2019 

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES:

Kwack, Y.J. and Choi, W.S., Electron. Mater. Lett. 8, 341-344 (2012).CrossRefGoogle Scholar
Adamopoulos, G., Bashir, A., Wöbkenberg, P.H., Bradley, D.D.C. and Anthopoulos, T.D., Appl. Phys. Lett. 95, 133507 (2009).CrossRefGoogle Scholar
Li, C.S., Li, Y.N., Wu, Y.L., Ong, B.S. and Loutfy, R.O., J. Phys. D Appl. Phys. 41, 125102 (2008).CrossRefGoogle Scholar
Braga, J.P., De Lima, G.R., Gozzi, G. and Santos, L.F., in Design, Simulation and Construction of Field Effect Transistors, edited by Dhanasekaran Vikraman and Hyun-Seok Kim (IntechOpen, London, 2018) p. 135-155.Google Scholar
Ružić, I., Croat. Chem. Acta 60, 457-475 (1987).Google Scholar