Hostname: page-component-6bf8c574d5-t27h7 Total loading time: 0 Render date: 2025-02-22T17:08:26.704Z Has data issue: false hasContentIssue false
  • English
  • Français

Extended Solubility and Stability in Vapor Quenched Ni3al-X Intermetallics.

Published online by Cambridge University Press:  26 February 2011

Rong Wang
Rong Wang*
Affiliation:
Failure Analysis Associates, Redmond, Washington 98052
Get access

Abstract

A series of fine-grain and amorphous Ni3Al-X alloys, where X is a solute of 1 to 45 at.% Hf, C or Hf+C in continuously graded compositions, was formed simultaneously into a 0.2 mm-thick disk by high-rate sputter co-deposition. The as-deposited Ni3Al-X alloys exhibited a disordered Ll2 structure and extended solid solubility limits beyond which amorphous phases were formed. Heat-treatment of the alloys at 900°C resulted in fine grain size of 0.5 to 1.5 μm. Ultra-fine dispersoids less than 500 Å in size were observed and they seemed resistant to coarsening.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 133: Symposium H – High-Temperature Ordered Intermetallic Alloys III , 1988 , 505
Copyright
Copyright © Materials Research Society 1989

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1. Barbee, T.W. Jr., Holmes, W.H., Keith, D.L., Tyzyna, M.K. and Ilonca, G., Thin Solid Films 45, 591 (1977).Google Scholar
2. Rizzo, H.F., Massalski, T.B. and McClanahan, E.D., Met. Trans. 19A, 5 (1988).Google Scholar
3. Jena, A.K. and Chaturvedi, M.C., J. Mat. Sci., 19 3121 (1984).Google Scholar
4. Liu, C.T. and Stiegler, J.O., Science, 226, 636 (1984).Google Scholar
5. Sikka, V.K. and Loria, E.A., presented at the Annual Conf. of Metallurgists, Toronto, Canada, August 17, (1986).Google Scholar
6. Huang, S.C., Briant, C.L., Chang, K.M., Taub, A.I., and Hall, E.L., J. Mater. Res., 1, (1), 60 (1986).Google Scholar
7. Huang, S. C., Chang, K.M., and Taub, A.I., in Mechanical Behavior of RS Materials, (The Metallurgical Society of AIME, 1985), p. 544.Google Scholar
8. Wang, R., “Nonequilibrium Chemistry of Structural Alloys,” NASA SBIR Phase I Report, (1987).Google Scholar
9. Baker, I., Ichishita, F.S., Surprenant, V.A., and Schulson, E.M., Metallography, 17, 299 (1984).Google Scholar
10. Liu, C.T. and White, C.L., in Mat. Res. Soc. Symp. Proc. On Ordered Intermetallic Alloys, edited by Koch, C.C., Liu, C.T., Stoloff, N.S., (Mater. Res. Soc. Proc. 39, Pittsburgh, PA 1985), pp. 365–380.Google Scholar
11. Han, K.H. and Choo, W. K., Scripta Metall. 17, 281 (1983).CrossRefGoogle Scholar
12. Tadasugi, T., Izumi, O., and Masahashi, N., Acta Metall. 33, 1259 (1985).Google Scholar