Hostname: page-component-78c5997874-g7gxr Total loading time: 0 Render date: 2024-11-15T00:13:34.387Z Has data issue: false hasContentIssue false
  • English
  • Français

Fabrication of Porous Nanostructured Thin Films For Microfluidic and Microarray Applications

Published online by Cambridge University Press:  01 February 2011

Louis Wentzel Bezuidenhout  and
Michael J. Brett
Louis Wentzel Bezuidenhout
Affiliation:
louisb@ualberta.ca, University of Alberta, Electrical and Computer Engineering, 1102 10035 114 Street, Edmonton, T5K 1R6, Canada
Michael J. Brett
Affiliation:
brett@ece.ualberta.ca, University of Alberta, Electrical and Computer Engineering, Edmonton, T6G 2V4, Canada
Get access

Abstract

The functionality of microfluidic and microassay devices could be enhanced through further development of porous engineered microstructures. New structural elements fabricated with porous nanostructured thin films deposited by the glancing angle deposition (GLAD) technique have been developed for these devices, and are reviewed here. With the GLAD technique, engineered structures such as vertical posts, slanted posts, helices, and square spirals can be directly grown inside microfluidic channels. A high surface area channel (517cm2/cm2) was made by depositing a silicon oxide porous film in glass microchannels (up to 4.5μm deep and 50μm wide). Similar channels were also fabricated by patterning channels in a photoresist-coated porous film. Self-sealed microchambers and channels were made by growing a SiO2 porous film on 14μm high silicon mesas (2.5×2.5μm, 7×7μm, and 25×25μm) and lines (2.5 to 50μm wide). Devices with channels containing periodic arrays of Si pillars with controllable porosity and architecture were fabricated with only one lithography and deposition cycle. The entire device was made by depositing a single GLAD porous film with areas of different porosity defining the channels. The channels, 200μm wide and 10.5μm deep, contained helical pillars with pore sizes ranging from 100nm-2μm, while a more dense nanofibrous helical film made up the remainder of the device. Fluid flow activated by negative pressure was demonstrated in this device, using both a dye solution and a 50nm microsphere solution. Material selection is not limited to silicon or silicon oxide, but may include a wide range of semiconductors, insulators and metals. A GLAD film was used to separate a test dye solution, demonstrating its potential for use in thin layer chromatography. The reported elements are suitable for a range of applications, including – but not limited to – chromatography, nano-assays and capillary electrophoresis.

Keywords

nanostructurefluidicsporosity
Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 951: Symposium E – Nanofunctional Materials, Nanostructures and Novel Devices for Biological and Chemical Detection , 2006 , 0951-E11-06
Copyright
Copyright © Materials Research Society 2007

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1. Nguyen, N. and Wereley, S. T., Fundamentals and Applications of Microfluidics, Artech House, Inc., Norwood, MA, 2002.Google Scholar
2. Goodrich, T. T., Lee, H. J. and Corn, R. M., Analytical Chemistry 76, 6173 (2004).Google Scholar
3. Baba, M. et al., Applied Physics Letters 83, 1468 (2003).Google Scholar
4. Kaji, N. et al., Analytical Chemistry 76, 15 (2004).Google Scholar
5. Turner, S., Perez, A. M., Lopez, A., and Craighead, H. G., J. Vac. Sci. Technol. B 16, 3835 (1998).Google Scholar
6. Han, J. and Craighead, H., Science 288, 1026 (2000).Google Scholar
7. He, N. T. Bing and Regnier, F., Analytical Chemistry 70, 3790 (1998).Google Scholar
8. Sano, T. et al., Applied Physics Letters 83, 4438 (2003).Google Scholar
9. Robbie, K., Brett, M. J., and Lakhtakia, A., Nature 384, 616 (1996).Google Scholar
10. Robbie, K. and Brett, M., J. Vac. Sci. Technol. A 15, 1460 (1997).Google Scholar
11. Hrudey, P., van Popta, A. C., Sit, J. C., and Brett, M. J., Nanoengineering: Fabrication, Properties, Optics, and Devices II, volume 5931, Bellingham, WA, 2005, SPIE.Google Scholar
12. Tait, R., Smy, T., and Brett, M. J., Thin Solid Films 226, 196 (1993).Google Scholar
13. Jensen, M. O. and Brett, M., Applied Physics A 80, 763 (2005).Google Scholar
14. Fan, J.-G., Dyer, D., Zhang, G., and Zhao, Y.-P, Nano Letters 4, 2133 (2004).Google Scholar
15. Harris, K. D., Brett, M. J., Smy, T. J., and Backhouse, C., J. Electrochem. Soc. 147, 2002 (2000).Google Scholar
16. Seto, M., Westra, K., and Brett, M., Journal of Materials Chemistry 12, 2348 (2002).Google Scholar
17. Kiema, G. K., Jensen, M. O., and Brett, M. J., Chemistry of Materials 17, 4046 (2005).Google Scholar