Hostname: page-component-6bf8c574d5-rwnhh Total loading time: 0 Render date: 2025-02-22T17:14:43.102Z Has data issue: false hasContentIssue false
  • English
  • Français

Notch Effects on Room Temperature Tensile and Bend Properties of Ni3Al and Ni3Al+B

Published online by Cambridge University Press:  26 February 2011

P. S. Khadkikar ,
J. D. Rigney ,
J. J. Lewandowski  and
K. Vedula
P. S. Khadkikar
Affiliation:
Department of Materials Science and Engineering Case Western Reserve University Cleveland, Ohio 44106
J. D. Rigney
Affiliation:
Department of Materials Science and Engineering Case Western Reserve University Cleveland, Ohio 44106
J. J. Lewandowski
Affiliation:
Department of Materials Science and Engineering Case Western Reserve University Cleveland, Ohio 44106
K. Vedula
Affiliation:
Department of Materials Science and Engineering Case Western Reserve University Cleveland, Ohio 44106
Get access

Abstract

The notched mechanical properties of Ni3AI and Ni3Al+B prepared by powder metallurgy techniques have been determined in both tension and bending at room temperature. Ten- sile tests performed using double notched specimens containing relatively blunt notches produced intergranular fracture in both Ni3Al and Ni3AI+B, with evidence of fracture initiating in an intergranular manner ahead of the blunt notch in both cases. Estimates of notched fracture toughness from bend tests and of local grain boundary fracture stress from the notched tensile tests suggest an increase in these values with boron addition.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 133: Symposium H – High-Temperature Ordered Intermetallic Alloys III , 1988 , 523
Copyright
Copyright © Materials Research Society 1989

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1. Aoki, K. and Izumi, O., Nippon Kinzaku Gakkaishi, 43, 1190 (1979).Google Scholar
2. Liu, C. T., White, C. L. and Horton, J. A., Acta Metall., 33, 213 (1985).Google Scholar
3. Fuchs, G. E. and Stoloff, N. S., Scripta Metall., 21, 863 (1987).Google Scholar
4. Khadkikar, P. S., Lewandowski, J. J. and Vedula, K., accepted in Metall. Trans. A (1988).Google Scholar
5. Lewandowski, J. J. and Thompson, A. W., Metall. Trans. A, 17A, 1769 (1986).CrossRefGoogle Scholar
6. Moran, B. and Norris, D. M., Metall. Trans. A, 9A, 1685 (1978).Google Scholar
7. Tada, H., Paris, P., and Irwin, G., The Stress Analysis of Cracks Handbook, DEL Research Corporation (1978).Google Scholar
8. Khadkikar, P. S., Ph. D. Dissertation, Case Western Reserve University (1988).Google Scholar