Hostname: page-component-78c5997874-v9fdk Total loading time: 0 Render date: 2024-11-14T05:16:04.903Z Has data issue: false hasContentIssue false

Adjusting the Defect Profile in a-Si:H Solar Cells with Energy Resolved Electron or Laser Beams: Experiment and Modeling

Published online by Cambridge University Press:  16 February 2011

K. Vasanth
Affiliation:
Department of Electrical Engineering, Princeton University, Princeton NJ 08544
D. Caputo
Affiliation:
Department of Electrical Engineering, Princeton University, Princeton NJ 08544
S. Wagner
Affiliation:
Department of Electrical Engineering, Princeton University, Princeton NJ 08544
M. Bennett
Affiliation:
Solarex Thin Film Division, Newtown PA 18940
S. Bae
Affiliation:
Penn State University, University Park, PA 16802
S. Fonash
Affiliation:
Penn State University, University Park, PA 16802
Get access

Abstract

We light-soaked a-Si:H pin solar cells with blue laser light through the front glass substrate or electron irradiated them through the back Al layer. By using short wavelength light and energy resolved electron beams we localize the damage preferentially near the p/i or n/i interface and thus study their effect on cell performance. I-V characteristics and quantum efficiency spectra were measured before and after the damage was introduced. We Modeled the changes in the quantum efficiency using the numerical device Model AMPS. Comparing changes in the measured and modeled quantum efficiencies (QE) we find that cells light-soaked with the blue laser have damage localized near the front of the device, and localized near the back for cells irradiated with electrons. This indicates that quantum efficiency measurements are sensitive to the location Of defects in the i-layer of the solar cell. However after long light-soaking and electron irradiation times the difference between the two types of damage becomes less visible in the QE Measurements.

Type
Research Article
Copyright
Copyright © Materials Research Society 1994

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

1. Xu, X., Yang, J. and Guha, S., Appl. Phys. Lett. 62, 1399 (1993)Google Scholar
2. Vasanth, K., Nakata, M., Wagner, S. and Bennett, M., Mat. Res. Soc. Symp. Proc. 297. 827 (1993)Google Scholar
3. Dietrich, K., Karg, F.H. and Kruhler, W., Solar Energy Materials 23, 282 (1991)Google Scholar
4. Herbst, W., Scholz, A., Schroder, B. and Oechsner, H., Proc. 23rd IEEE Photovoltaic Specialists Conference. Louisville. 913 (1993)Google Scholar
5. Arch, J.K., Rubinelli, F.A., Hou, J.Y. and Fonash, S.J., J. Appl Phys., 69, 7057 (1991)Google Scholar
6. Wagner, S., Vasanth, K., Nakata, M., Yang, J. and Guha, S., Proc. PVSEC-7. 986 (1993)Google Scholar
7. Fonash, S.J., Nicque, J.-L, Arch, J.K., Nag, S.S. and Wronski, C.R., AIP Conf. Proc. 234. 114 (1991)Google Scholar