Article contents
Chemical Etching and Post-Annealing for High Performance CdZnTe Strip Detectors
Published online by Cambridge University Press: 10 February 2011
Abstract
One of the critical issues in CdZnTe detector fabrication is the surface treatment. This will not only affect the electrical properties, such as leakage current, but also influence the physical properties, such as smoothness and adhesion between the metal and the semiconductor. The latter will determine the wire bonding yield. Historically, there has been a problem in achieving both low leakage current and excellent wire bonding yield. In this paper, we report our new approach to fabricate high performance doubled sided CdZnTe strip detectors. The new surface treatments involve chemical etching and post-annealing. The leakage current, interstrip resistance and energy resolution were studied as a function of different etchants/time and post-annealing temperature. It was found that a chemical etch with bromine in ethylene glycol (Br/EG) is suitable for the double sided strip detector process. Keeping a relatively smooth surface is critical for achieving a high yield of good strips. To improve the adhesion of the metal to CdZnTe for wire bonding, the detectors were annealed from 100 to 175°C for 10 hours. It has been observed that after annealing, not only has the strip leakage current decreased, but the interstrip resistance is increased for a temperature less than 150°C.
- Type
- Research Article
- Information
- Copyright
- Copyright © Materials Research Society 1998
References
- 4
- Cited by