Hostname: page-component-78c5997874-94fs2 Total loading time: 0 Render date: 2024-11-10T10:02:33.819Z Has data issue: false hasContentIssue false

The Composition and Stability of Nicu Surface Alloys Grown by Ni(CO), Decomposition on Cu

Published online by Cambridge University Press:  28 February 2011

Paul F.A. Alkemade
Affiliation:
Department of Atomic and Interface Physics, State University of Utrecht, P.O. Box 80,000, 3508 TA Utrecht, The Netherlands
H. Fortuin
Affiliation:
Department of Atomic and Interface Physics, State University of Utrecht, P.O. Box 80,000, 3508 TA Utrecht, The Netherlands
R. Balkenende
Affiliation:
Department of Atomic and Interface Physics, State University of Utrecht, P.O. Box 80,000, 3508 TA Utrecht, The Netherlands
F. H. P. M. Habraken
Affiliation:
Department of Atomic and Interface Physics, State University of Utrecht, P.O. Box 80,000, 3508 TA Utrecht, The Netherlands
W. F. Van Der Weg
Affiliation:
Department of Atomic and Interface Physics, State University of Utrecht, P.O. Box 80,000, 3508 TA Utrecht, The Netherlands
Get access

Abstract

The composition of NiCu surface alloys, prepared by decomposition of nickel carbonyl on a Cu(100) surface, has been studied before as well as after annealing using MeV Rutherford Backscattering Spectroscopy.

NiCu films with a thickness of 2 nm and of 10 nm, respectively, having a sharp interface with the copper substrate, were grown. The nickel fraction is found to be 65% and 93% respectively. The outermost monolayer is slightly enriched in copper. During annealing interdiffusion between the film and the interface occurs and the enrichment of the surface increases. In case of the 10 nm film the observed diffusion rate is much higher than is expected on the basis of diffusion coefficients published in the literature. This is ascribed to the presence of defects and/or grain boundaries in the grown surface alloy.

Type
Research Article
Copyright
Copyright © Materials Research Society 1988

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

1. Morán-López, J.L. and Benneman, K.H., Surf. Sci. 75, 167 (1978).Google Scholar
2. Chelikowsky, J.R., Surf. Sci. 139, L197 (1984).Google Scholar
3. Matthews, J.W. and Crawford, J.L., Thin Solid Films 5, 187 (1970).Google Scholar
4. Brongersma, H.H., Sparnaay, M.J. and Buck, T.M., Surf. Sci. 71, 657 (1978).CrossRefGoogle Scholar
5. Tear, S.P. and Roll, K., J. Phys. C: Solid State Phys. 15, 5521 (1982).CrossRefGoogle Scholar
6. Abu-Joudeh, M.A., Davies, B.M. and Montano, P.A., Surf. Sci. 171, 331 (1986).CrossRefGoogle Scholar
7. Alkemade, P.F.A., Turkenburg, W.C. and van der Weg, W.F., Nucl. Instr. and Meth. B15, 129 (1986).CrossRefGoogle Scholar
8. Pietersen, C.A., Mesters, C.M.A.M., Habraken, F.H.P.M., Gijzeman, O.L.J., Geus, J.W. and Bootsma, G.A., Surf. Sci. 107, 353 (1981).Google Scholar
9. Mesters, C.M.A.M., Wermer, G., Gijzeman, O.L.J. and Geus, J.W., Surf. Sci. 135, 396 (1983)Google Scholar
10. Gijzeman, O.L.J. and Lekkerkerker, H.N.M., Chem. Phys. Lett. 95, 152 (1983).Google Scholar
11. van Dijk, T. and Mittemeijer, E.J., Thin Solid Films 41, 173 (1977).Google Scholar
12. Alkemade, P.F.A., Fortuin, H., Balkenende, R., Habraken, F.H.P.M. and van der Weg, W.F., in Proceedings of the 2nd Int. Conf. on the Structure of Surfaces, Amsterdam 1987, edited by Veen, J.F. van der and Van Hove, M.A., (Springer-Verlag, Berlin).Google Scholar
13. Alkemade, P.F.A., to be published.Google Scholar
14. Alkemade, P.F.A., PhD thesis, Utrecht, 1987.Google Scholar
15. Since the exact composition of the Ni(CO)4-CO gas mixture is not known - Ni(CO)4 decomposes at the filament of a mass spectrometer - stated values of the exposures do not relate to the Ni(CO)4 pressure alone, but to the total pressure of Ni(CO)4 and CO.Google Scholar
16. The diffusion distance Δz has been defined as half the distance for which the nickel fraction decreases from 84% to 16% of its maximal value.Google Scholar
17. Shikata, M. and Shimizu, R., Surf. Sci. 97, L363 (1980).Google Scholar
18. Gradmann, U., Ann. Phys. Lpz. 17, 91 (1966).Google Scholar
19. Brunel, G., Cizeron, C. and Lacombe, P., C.R. Acad. Sci. Ser. C 270 (4), 393 (1970).Google Scholar