Hostname: page-component-78c5997874-fbnjt Total loading time: 0 Render date: 2024-11-10T09:03:25.510Z Has data issue: false hasContentIssue false
  • English
  • Français

Dislocation patterning in fatigued silicon single crystals

Published online by Cambridge University Press:  15 February 2011

M. Legros ,
O. Ferry ,
J.-P. Feiereisen ,
A. Jacques  and
A. George
M. Legros
Affiliation:
CEMES-CNRS, 29 rue J. Marvig, 31055 Toulouse, France
O. Ferry
Affiliation:
LPM, Ecole des Mines, Parc de Saurupt, 54042 Nancy, France
J.-P. Feiereisen
Affiliation:
LPM, Ecole des Mines, Parc de Saurupt, 54042 Nancy, France
A. Jacques
Affiliation:
LPM, Ecole des Mines, Parc de Saurupt, 54042 Nancy, France
A. George
Affiliation:
LPM, Ecole des Mines, Parc de Saurupt, 54042 Nancy, France
Get access

Abstract

Tension compression fatigue tests and subsequent TEM observations were conducted on single crystalline silicon in a temperature and strain rate domain where lattice friction is still effective: 800-900°C and 1.5 to 6x10-4s-1. Samples oriented for single slip conditions were cyclically loaded under plastic strain amplitude control. For amplitudes ranging from 6x10-4 to 10-2, cyclic stress-strain curves exhibit two different stages of hardening and pass through a maximum before saturation is reached. TEM observations suggest that strain localization takes place near the maximum cyclic stress and beyond. Before mechanical saturation, edge dislocation dipoles sit mainly in thick rectilinear walls. Once the maximum stress is reached, these thick walls “condense” in much thinner walls that seem to carry out the imposed deformation while other regions become inactive. In this case, the dislocation structure anneals out and a loop structure is created from the dipolar walls.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 779: Symposium W – Multiscale Phenomena in Materials - Experiments and Modeling Related to Mechanical Behavior , 2003 , W5.32
Copyright
Copyright © Materials Research Society 2003

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

1. Grosskreutz, J.C. and Mughrabi, H., “Description of the work-hardened structure at low temperature in cyclic deformation”, Constitutive equations in plasticity, ed. Argon, A.S.., (The MIT Press, 1975). 251–326.Google Scholar
2. Laird, C., in Treatise on Materials Science and Technology, Arsenault, R.J., Editor. 1975, Academic Press: New York. p. 101.Google Scholar
3. Magnin, T., Mem. Etud. Sci. Rev. Metall. 88 33–48 (1991).Google Scholar
4. Pedersen, O.B., Acta Metall. Mater. 38 1221–1239 (1990).Google Scholar
5. Pedersen, O.B., Phil. Mag. A 73 829–858 (1996).Google Scholar
6. Brown, L.M., Mat. Sci. Eng. A 285 35–42 (2000).Google Scholar
7. Inui, H., Hong, S.I., and Laird, C., Acta Metall Mater 38 2261–2274 (1990).Google Scholar
8. Laird, C. in Deformation-Induced Microstructures: Analysis and Relation to Properties. Proceeding of the 20th Risöe International Symposium on Materials Science, 1999.Google Scholar
9. George, A., Mat. Sci. Eng. A 233 88–102 (1997).Google Scholar
10. Louchet, F., “Plasticité des métaux de structure cubique centrée”, Dislocations et déformation plastique-Yravals 1979, ed. Groh, P., Kubin, L., and Martin, J.-L.., (Editions de Physique, 1980). 149–159.Google Scholar
11. Scoble, W.R.J. and Weissmann, S., Crystal Lattice Defects 4 123–136 (1973).Google Scholar
12. Legros, M., Jacques, A., and George, A., Mat. Sci. Eng. A 309-310 233–236 (2001).Google Scholar
13. Legros, M., Jacques, A., and George, A., Phil. Mag. A 82 3275–3288 (2002).Google Scholar
14. Legros, M., Ferry, O., Feiereisen, J.-P., Jacques, A., and George, A., J. Phys.: Condens. Matter 14 12871–12882 (2002).Google Scholar
15. Mughrabi, H., Mat. Sci. Eng. 33 207–223 (1978).Google Scholar
16. Mecke, K. and Blochwitz, C., Crystal Res. & Technol. 17 743–758 (1982).Google Scholar