Hostname: page-component-78c5997874-4rdpn Total loading time: 0 Render date: 2024-11-14T06:14:50.665Z Has data issue: false hasContentIssue false
  • English
  • Français

Effect of cooling rate on the formation and distribution of carbides in nodular iron alloyed with Cr

Published online by Cambridge University Press:  04 March 2013

Ramses Zenil ,
Jose A. García ,
Gerardo A. Ruiz ,
Alejandro D. Basso  and
Jorge. Sicora
Ramses Zenil
Affiliation:
Departamento de Ingeniería Metalúrgica, Facultad de Química, Universidad Nacional Autónoma de México.
Jose A. García
Affiliation:
Departamento de Ingeniería Metalúrgica, Facultad de Química, Universidad Nacional Autónoma de México.
Gerardo A. Ruiz
Affiliation:
Departamento de Ingeniería Metalúrgica, Facultad de Química, Universidad Nacional Autónoma de México.
Alejandro D. Basso
Affiliation:
INTEMA-Universidad Nacional de Mar del Plata, Argentina
Jorge. Sicora
Affiliation:
INTEMA-Universidad Nacional de Mar del Plata, Argentina
Get access

Abstract

This investigation deals with the effect of cooling rate on the formation of carbide nodular iron alloyed with 2.2 % Cr and equivalent carbon near 4.3%. In the experimental stage three Y-blocks of 1.5, 3 and 5.5 cm in thickness are poured in green sand molds. Castings are sectioned in two positions (wall and center samples) in order to determine the characteristics of the precipitated carbides (fraction, distribution and relative size) from surface to center and from the bottom to the top of the castings applying quantitative analysis of images. The obtained results show the presence of carbides in all of the castings. Finer carbides are obtained in the thinnest casting but with a high variation between the samples located in the wall and center. All castings present massive carbides in the last freezing zone (LFZ). Therefore the cooling rate associated with casting thick has an important effect on the fraction and distribution of carbides.

Keywords

kineticsmicrostructueFe
Type
Articles
Information
MRS Online Proceedings Library (OPL) , Volume 1485: Symposium 7D – Advanced Structural Materials—2012 , 2012 , pp. 125 - 129
Copyright
Copyright © Materials Research Society 2013 

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCIAS.

Binsczki, F., Kowalsky, A., Furmanec, J., Vol. 7, Issue 2, 2007, pp. 115–118.Google Scholar
Goodrich, G.M, Cast Iron Microstructures Anomalies and their causes, AFS Transaction 1997-30, pp. 669.Google Scholar
Jiyang, Z., Dalian University of Technology China, Serial Report February 2009 Google Scholar
Lagarde, M., Basso, A., Dommarco, R.C., Sikora, J., ISIJ International Vol. 51 (2011), No. 4, pp. 645–650.CrossRefGoogle Scholar
American Foundrymen´s Society (AFS), “Foundrymen´s guide to ductile iron microstructures” Des Plaines, Illinois, (1984).Google Scholar
Laino, S., Dommarco, R., Sikora, J.A., Desarrollo de fundiciones nodulares austemperadas con carburos CADI, Congreso SAM-CONAMET, Mar del Plata Arg. Octubre 2005.Google Scholar