Hostname: page-component-745bb68f8f-kw2vx Total loading time: 0 Render date: 2025-01-28T14:22:16.011Z Has data issue: false hasContentIssue false
  • English
  • Français

Effects of MeV Ion Beam on Polymers

Published online by Cambridge University Press:  03 September 2012

A. L. Evelyn ,
D. Ila ,
R. L. Zimmerman ,
K. Bhat ,
D. B. Poker  and
D. K. Hensley
A. L. Evelyn
Affiliation:
Department of Physical and Natural Sciences, Alabama A&M University, P.O. Box 1447, Normal, AL 35762-1447
D. Ila
Affiliation:
Department of Physical and Natural Sciences, Alabama A&M University, P.O. Box 1447, Normal, AL 35762-1447
R. L. Zimmerman
Affiliation:
Department of Physical and Natural Sciences, Alabama A&M University, P.O. Box 1447, Normal, AL 35762-1447
K. Bhat
Affiliation:
Department of Physical and Natural Sciences, Alabama A&M University, P.O. Box 1447, Normal, AL 35762-1447
D. B. Poker
Affiliation:
Solid State Division, Oak Ridge National Laboratory, Oak Ridge, TN
D. K. Hensley
Affiliation:
Solid State Division, Oak Ridge National Laboratory, Oak Ridge, TN
Get access

Abstract

The electronic (εe) and nuclear (εa) stopping effects produced by 3.5 MeV and 5.0 MeV ion bombardment in polyvinylidine chloride (PVDC), polyethylene (PE) and polyethylene sulfide were studied and compared. To separate these effects we chose two bombardment energies and a thin film polymer stacking technique developed in house. The resulting stacked layered system consisting of each polymer was bombarded with 3.5 MeV and 5.0 MeV alpha particles. The layered system was selected such that the first few layers experience most of the effects of the electronic energy deposited and the last layer receives the effects of the nuclear stopping. The electrical conductance and the changes in the chemical structure were measured by direct resistivity measurements, Raman microprobe analysis, RBS, and FTIR. The post-irradiation characterization resolved the effects of the stopping powers on the polymer films.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 438: Symposium A – Materials Modificaton and Synthesis by Ion Beam… , 1996 , 499
Copyright
Copyright © Materials Research Society 1997

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

1. Ziegler, I. J. F., Biersack, J. P. and Littmark, U., The Stopping and Range of Ions in Solids New York, Pergamon Press Inc., 1985.Google Scholar
2. Ila, D., Evelyn, A. L., and Jenkins, G. M., Nucl. Instr. & Meth. in Phys. Res. B91, p. 580 (1994).Google Scholar
3. Evelyn, A. L., Ila, D., and Jenkins, G. M., Nucl. Instr. & Meth. in Phys. Res. B85, p. 861 (1994).Google Scholar
4. Venkatesan, T., Levi, R., Banwell, T. C., Tombrello, T., Nicolet, M., Hamm, R., and Meixner, A. E. in Ion Beam Processes in Advanced Electronic Materials and Device Technology, edited by (Mater. Res. Soc. Proc. 45, Pittsburgh, PA 1985), p. 189.Google Scholar
5. Ila, D., Evelyn, A. L., and Jenkins, G. M. in Ion Beam Induced Graphitizationi of Phenolformaldehyde, edited by Libera, M., Haynes, T. E., Cebe, P. and Dickinson, J. E. Jr. (Mater. Res. Soc. Proc. 321, Pittsburgh, PA 1994), p. 441–446.Google Scholar
6. Ila, D., Evelyn, A. L., and Qian, Y. in Embedded Circuitry in Polymeric Films by Linear Energy Transfer (LET) of MeV Ions, edited by Borgesen, P., Coburn, J. C., Sanchez, J. E. Jr., Rodbell, K. P. and Filter, W. F. (Mater. Res. Soc. Proc. 338, Pittsburgh, PA 1994), p. 613.Google Scholar
7. Young, R. J. and Lovell, P. A., Introduction to Polymers, Chapman & Hall, 2nd ed. 1991.Google Scholar
8. Davenas, J., and Xu, X. L., Nucl. Instr. & Meth.in Phy. Res. B39 p. 754 (1989).Google Scholar
9. Sofield, C. J., Sugden, S., Bedell, C. J., Graves, P. R., and Bridwell, L. B., Nucl. Instr. & Meth. in Phy. Res. B67, p. 432 (1992).Google Scholar
10. Ila, D., Zimmerman, R. L., Jenkins, G. M., Evelyn, A. L., Maleki, H., Fisher, J. and Poker, D. B., Nucl. Instr. and Meth. in Phy. Res. B106, p. 1045 (1996).Google Scholar
11. Solomon, T. W. G., Organic Chemistry, Wiley 5th ed., 1992.Google Scholar