Hostname: page-component-78c5997874-94fs2 Total loading time: 0 Render date: 2024-11-11T07:21:20.097Z Has data issue: false hasContentIssue false
  • English
  • Français

Issues with Gold Electroplating for Microelectromechanical System Applications

Published online by Cambridge University Press:  15 March 2011

Caroline A. Kondoleon  and
Thomas F. Marinis
Caroline A. Kondoleon
Affiliation:
Electronics Packaging and Prototyping Division, The Charles Stark Draper Laboratory, Cambridge, MA 02139
Thomas F. Marinis
Affiliation:
Electronics Packaging and Prototyping Division, The Charles Stark Draper Laboratory, Cambridge, MA 02139
Get access

Abstract

Electro-plated gold films are used extensively in packaging of MEM sensors to make connections to signal conditioning electronics. Over the past two years, production lots of gold plated substrates, procured from various vendors, failed an accelerated aging qualification test. In this test, 0.0025 [mm] diameter aluminum wires were ultrasonically welded to the film, aged at 120°C for 48 hours, and then pulled to destruction. The criterion for passing this test was that the wires should break both before and after aging. In the defective lots, the wires lifted off of the gold film after aging. Analysis of these defective films by SEM, Auger, and TOF-SIMS suggested that residues, deposited from the plating bath, concentrated beneath the bond as the gold and aluminum reacted to form an inter-metallic compound during aging. A combination, etch and cleaning treatment was developed for defective substrates, which removed a sufficient amount of residues from the gold to pass the qualification test.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 687: Symposium B – Materials Science of Microelectromechanical Systems (MEMS) Devices IV , 2001 , B5.18
Copyright
Copyright © Materials Research Society 2002

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

1 Harman, G., Wire Bonding in Microelectronics, New York, McGraw-Hill, 1997 Google Scholar
2 Endicott, D. W. et al. , Plating and Surface Finishing, 68 (1981) 58 Google Scholar
3 Philosfsky, E., Solid State Electronics, 13 (1970) 1391 Google Scholar
4 Gerling, W., Proc. 34th Electronic Components Conf, (1984) 13 Google Scholar
5 Philosfsky, E., Proc. 8th Annual IEEE Reliability Physics Symp., (1970) 177 Google Scholar