Hostname: page-component-78c5997874-j824f Total loading time: 0 Render date: 2024-11-13T02:25:18.579Z Has data issue: false hasContentIssue false
  • English
  • Français

Leakage currents of large area InP/InGaAs heterostructures

Published online by Cambridge University Press:  27 January 2014

Anders Olsson ,
Abuduwayiti Aierken ,
Jani Oksanen ,
Harri Lipsanen  and
Jukka Tulkki
Anders Olsson
Affiliation:
Department of Biomedical Engineering and Computational Science, Aalto University Espoo, Finland Department of Micro- and Nanosciences, Aalto University Espoo, Finland
Abuduwayiti Aierken
Affiliation:
Department of Micro- and Nanosciences, Aalto University Espoo, Finland
Jani Oksanen
Affiliation:
Department of Biomedical Engineering and Computational Science, Aalto University Espoo, Finland
Harri Lipsanen
Affiliation:
Department of Micro- and Nanosciences, Aalto University Espoo, Finland
Jukka Tulkki
Affiliation:
Department of Biomedical Engineering and Computational Science, Aalto University Espoo, Finland
Get access

Abstract

Light-emitting diodes (LEDs) based on the conventional III-V compound semiconductors are known to exhibit internal quantum efficiencies (IQE) that are very close to unity. Ideally, the high IQE is expected to enable electroluminescent cooling with a cooling capacity of several Watts per cm2 of emitter area. One key requirement in enabling such cooling is the ability to fabricate high quality large area LEDs. However, detailed information on the performance of relevant large area devices and their yield is extremely scarce. In this report we present data on the yield and related large area scaling of InP/InGaAs LEDs by using current-voltage measurements performed on LED wafers fabricated at five different facilities. The samples were processed to contain square shaped mesas of sizes 0.25 mm2 and 16 mm2 operating as LEDs. While most of the smaller mesas showed relatively good electrical characteristics and low leakage current densities, some of them also exhibited very large leakage currents. In addition, in some cases the large area devices exhibited large, and even almost linearly behaving leakage currents. Such information on the scaling and unidealities of diodes fabricated using established fabrication technologies is crucial for the development of the optical cooling technologies relying on large area devices.

Keywords

electrical propertiessemiconductingoptoelectronic
Type
Articles
Information
MRS Online Proceedings Library (OPL) , Volume 1635: Symposium T – Compound Semiconductor Materials and Devices , 2014 , pp. 75 - 81
Copyright
Copyright © Materials Research Society 2014 

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

Schnitzer, I., Yablonovitch, E., Caneau, C., and Gmitter, T. J., “Ultrahigh spontaneous emission quantum efficiency, 99.7% internally and 72% externally, from AlGaAs/GaAs/AlGaAs double heterostructures,” Appl. Phys. Lett. vol. 62, pp. 131, 1993.CrossRefGoogle Scholar
Heikkila, O., Oksanen, J., Tulkki, J., ”Ultimate limit and temperature dependency of light-emitting diode efficiency,” Journal of Applied Physics, 10(9):093119, 2009.CrossRefGoogle Scholar
Oksanen, J. and Tulkki, J., “Thermophotonic heat pump - a theoretical model and numerical simulations,” Journal of Applied Physics, 107(9):093106, 2010.CrossRefGoogle Scholar
Santhanam, P., Gray, D., and Ram, R., “Thermoelectrically pumped light-emitting diodes operating above unity efficiency, ”Physical Review Letters, 108(9), February 2012.CrossRefGoogle ScholarPubMed
Gray, D., Santhanam, P. and Ram, R., “Design for enhanced thermo-electric pumping in light emitting diodes,” Appl. Phys. Lett. vol. 103, pp. 123503, 2013.CrossRefGoogle Scholar
Demeester, P., Pollentier, I., De Dobbelaere, P., Brys, C., and Van Daele, P., “Epitaxial lift-off and its applications,” Semiconductor Science and Technology, vol. 8, no. 6, pp. 1124–1135, 1993.CrossRefGoogle Scholar
Iles, P. A., Yeh, Y.-C. M., Ho, F. H., Chu, C.-L., and Cheng, C., “High-efficiency (>20% AM0) GaAs solar cells grown on inactive-Ge substrates,” IEEE Electron Device Letters, vol. 11, no. 4, pp. 140–142, 1990.CrossRefGoogle Scholar
Keavney, C. J., Haven, V. E., and Vernon, S. M., “Emitter structures in MOCVD InP solar cells,” in, Conference Record of the Twenty First IEEE Photovoltaic Specialists Conference, 1990, pp. 141–144 vol. 1, 1990.Google Scholar
Wanlass, M. W., Ward, J. S., Emery, K. A., Duda, A., and Coutts, T. J., “Improved large-area, two-terminal InP/Ga0.47In0.53 As tandem solar cells,” in IEEE Photovoltaic Specialists Conference - 1994, 1994 IEEE First World Conference on Photovoltaic Energy Conversion, 1994., Conference Record of the Twenty Fourth, vol. 2, pp. 1717–1720 vol. 2, 1994.Google Scholar
Green, M., Emery, K., Hishikawa, Y., Warta, W., Dunlop, E., “Solar cell efficiency tables (version 39),” Progress in Photovoltaics: Research and Applications, 20(1), pp. 12–20, 2012.CrossRefGoogle Scholar
List of suppliers available on request.Google Scholar
Breitenstein, O., et al. ., ”Understanding junction breakdown in multicrystalline solar cells,” Journal of Applied Physics, 109(7):071101, 2011.CrossRefGoogle Scholar