Hostname: page-component-78c5997874-mlc7c Total loading time: 0 Render date: 2024-11-14T06:58:23.675Z Has data issue: false hasContentIssue false
  • English
  • Français

Mesopore Size Dependence of Protonic and Lithium Ionic Conductivity of Porous Alumina

Published online by Cambridge University Press:  01 February 2011

Hideki Maekawa ,
HangYan Shen ,
Yutaka Fujimaki ,
Kotaro Kawata ,
Kaoru Shibata ,
Masayosi Kawai  and
Tsutomu Yamamura
Hideki Maekawa
Affiliation:
Department of Metallurgy, Tohoku Univ, 980–8579, Sendai, Japan PRESTO, Japan Science and Technology Corporation, Kawaguchi, 332–0012, Japan Center for Interdisciplinary Research, Tohoku Univ, 980–8578, Sendai, Japan
HangYan Shen
Affiliation:
Department of Metallurgy, Tohoku Univ, 980–8579, Sendai, Japan PRESTO, Japan Science and Technology Corporation, Kawaguchi, 332–0012, Japan
Yutaka Fujimaki
Affiliation:
Department of Metallurgy, Tohoku Univ, 980–8579, Sendai, Japan
Kotaro Kawata
Affiliation:
Department of Metallurgy, Tohoku Univ, 980–8579, Sendai, Japan
Kaoru Shibata
Affiliation:
Neutron Scattering Research, JAERI, Tokai-mura, 319–1195, Japan
Masayosi Kawai
Affiliation:
KENS, Institute of Materials Structure Science, Tsukuba, 305–0801, Japan e-mail: maekawa@material.tohoku.ac.jp
Tsutomu Yamamura
Affiliation:
Department of Metallurgy, Tohoku Univ, 980–8579, Sendai, Japan Center for Interdisciplinary Research, Tohoku Univ, 980–8578, Sendai, Japan
Get access

Abstract

Ordered-mesoporous-Al2O3 was synthesized by the sol-gel route using neutral copolymer surfactants as templates. The pore size was controlled over the range of 3∼22 nm by using different surfactant copolymers under different synthetic conditions. Protonic conductivity of hydrated mesoporous alumina was examined for CIP treated mesoporous alumina pellet. The highest protonic conductivity was obtained as 0.004 S· cm−1 at 25 °C under 80% RH for the pellet with 15 nm averaged pores. The conductivity increased monotonically with increasing pore size under constant humidity. Quantitative determination of the concentration and the mobility of protons in hydrated mesoporous alumina was performed by 1H NMR, quasi-elastic neutron scattering (QENS) and TG/DTA measurements. Both the mobility and the concentration increased with increasing pore size. On the other hand, composites composed of synthesized mesoporous-Al2O3 and lithium iodide (LiI) was prepared. Dc electrical conductivity of 50LiI.50(mesoporous-Al2O3) was 2.6×10−4 S cm−1 at room temperature, which was considerably higher than the previously reported LiI-alumina composites. A systematic dependence of conductivity upon pore size was observed, in which the conductivity increased with decreasing the pore size except for pore size=3 nm. The 7Li diffusion constant of the composite was investigated by QENS as well as pulsed field gradient nuclear magnetic resonance (PFG-NMR). The dc conductivities showed reasonable agreement with an Einstein equation using measured diffusion constants.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 835: Symposium K – Solid-State Ionics , 2004 , K3.8
Copyright
Copyright © Materials Research Society 2005

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1. Liang, C.C., J. Electrochem. Soc. 120, 1289 (1973).Google Scholar
2. Poulsen, F. W. et al., Solid State Ionics, 9/10, 119(1983)Google Scholar
3. Pack, S., Owens, B., and Wagner, J.B. Jr, J. Electrochem. Soc. 127, 2177 (1980).Google Scholar
4. Maier, J., Prog. Solid St. Chem. 23, 171 (1995).Google Scholar
5. Tuller, H. L., Solid State Ionics 131 143 (2000).Google Scholar
6. Maier, J., Solid State Ionics 23, 59 (1987).Google Scholar
7. Maekawa, H., Tanaka, R., Yamamura, T., MRS Symposium Proceedings, 756, EE6.18.1(2003)Google Scholar
8. Maekawa, H., Tanaka, R., Sato, T., Fujimaki, Y. and Yamamura, T., Solid State Ionics, 175, 281 (2004).Google Scholar
9. Barret, E.P., Joyner, L.G., and Halenda, P.P., J. Am. Chem. Soc. 73, 373 (1987).Google Scholar
10. Daiko, Y.; Kasuga, T. and Nogami, M., Chem. Mater, 14, 4624 (2000).Google Scholar
11. Hsu, W. Y. and Gierke, T. D., J. Membr. Sci., 13, 307 (1983)Google Scholar