Hostname: page-component-78c5997874-v9fdk Total loading time: 0 Render date: 2024-11-10T08:38:20.286Z Has data issue: false hasContentIssue false

Metal – polymer interfaces and their effect on the glass transition of thin polystyrene films

Published online by Cambridge University Press:  01 February 2011

J.S. Sharp
Affiliation:
School of Physics and Astronomy, University of Nottingham, Nottingham U.K. NG7 2RD
J.A. Forrest
Affiliation:
Department of Physics and Guelph - Waterloo Physics Institute, University of Waterloo, Waterloo, Ontario, Canada N2L 3G1
Get access

Abstract

We present a study of polystyrene-metal interfaces and discuss the relationship between the interfacial structure and anomalies in the measured glass transition temperature (Tg) of thin metal capped polystyrene (PS) films. The PS films used in these studies were coated with an evaporated metal layer of either Aluminum (Al) or gold (Au) and the Tg values were measured with ellipsometry. Uncoated PS films were also measured and these samples showed Tg values that were reduced relative to the bulk value for film thicknesses (h) less than 40 nm. Films coated with Au were shown to have measured Tg values that were the same as the bulk value (Tgbulk=370 K) for all the film thicknesses studied (h ≥ 8nm). The Al coated PS films had measured Tg values that were the same as the uncoated PS films. The observed differences are discussed in terms of the differences in the structure of the metal-polymer interfaces produced during thermal evaporation of the metal layers. A novel sample preparation procedure was developed to enable us to use Atomic Force Microscopy (AFM) to directly measure the structure of the buried polymer-metal interfaces. The measurements performed on these systems support the suggestion that the interfacial structure is different for the two metal-polymer interfaces studied and that these differences may be the cause of the anomalies in the measured Tgs of these samples.

Type
Research Article
Copyright
Copyright © Materials Research Society 2004

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

[1] Forrest, J.A. and Dalnoki-Veress, K., Advances in Colloid and Interface Science, 94, 167 (2001)Google Scholar
[2] Mattsson, J., Forrest, J.A., Borjesson, L, Phys. Rev. E, 62, 51875200, (2000).,Google Scholar
Forrest, J.A. and Mattsson, J., Phys. Rev. E., 61 R53, (2000).Google Scholar
[3] Herminghaus, S., Jacobs, K., Seeman, R., Eur., Phys. J. E., 5, 531, (2001).Google Scholar
[4] Long, D., Lequeux, F., Eur. Phys. J. E, 4, 371, (2001).Google Scholar
[5] Ngai, K.L., J. Phys. IV, 10, Pr7221 (2000).Google Scholar
[6] Forrest, J.A., Dalnoki-Veress, K., Stevens, J.R., and Dutcher, J.R., Phys. Rev. Lett. 77, 2002 (1996)Google Scholar
[7] Forrest, J.A., Dalnoki-Veress, K. and Dutcher, J.R., Phys. Rev. E, 56, 5705 (1997)Google Scholar
[8] Kerle, T., Lin, Z.Q., Kim, H.C., Russell, T.P., Macromolecules, 34, 3484 (2001).Google Scholar
[9] Teichroeb, J.H. and Forrest, J.A., Phys. Rev. Lett., 91, 016104 (2003).Google Scholar
[10] Hammerschmidt, J., Gladfelter, W., Haugstad, G., Macromolecules, 32, 3360 (1999).Google Scholar
[11] Forrest, J.A., Dalnoki-Veress, K. and Dutcher, J.R., Phys. Rev. E, 56, 5705 (1997)Google Scholar
[12] Fukao, K., Uno, S., Miyamoto, Y., Hoshino, A., Miyaji, H., Phys. Rev. E, 64, 051807, (2001)Google Scholar
[13] Sharp, J.S. and Forrest, J.A., Phys. Rev. Lett., (in press 2003)Google Scholar
[14] Sharp, J.S. and Forrest, J.A., Phys. Rev. E, 67, 031805, (2003)Google Scholar
[15] Strunskus, T., Zaporojtchenko, V., Behnke, K., Bechtolsheim, C.V. and Faupel, F.., Adv. Eng. Mat., 22, 489492, (2000).Google Scholar
[16] Faupel, F., Willecke, R. and Thran, A., Mat. Sci. Eng. R, 22, 155, (1998).Google Scholar
[17] Jones, R.A.L. and Richards, R.W., ‘Polymers at surfaces and interfaces’, pgs 293315, Cambridge University Press (1999)Google Scholar