Hostname: page-component-745bb68f8f-hvd4g Total loading time: 0 Render date: 2025-01-30T00:00:51.495Z Has data issue: false hasContentIssue false
  • English
  • Français

On Modeling Trivalent Dangling Bonds with Bivalent Levels

Published online by Cambridge University Press:  16 February 2011

Vyshnavi Suntharalingam  and
Howard M. Branz
Vyshnavi Suntharalingam
Affiliation:
Electronic Materials and Processing Research Laboratory, The Pennsylvania State University, University Park, PA, 16802
Howard M. Branz
Affiliation:
National Renewable Energy Laboratory, Golden, CO 80401
Get access

Abstract

We examine the treatment of the hydrogenated Amorphous silicon (a-Si:H) dangling-bond defect used in the Analysis of microelectronic and Photonic Structures (AMPS) computer model and in other models of a-Si:H semiconductor devices. The dangling bond defect (D) is trivalent, with two correlated electronic levels in the gap. However, Modelers typically employ two uncorrelated bivalent levels to represent D; this introduces fictitious neutral dangling bond (D°) levels whenever D is charged. We find that the bivalent (AMPS) representation captures the important aspects of D physics and introduces only small errors into simulations. To reach this conclusion, we examine charge density and recombination and compare the trivalent D defect and its bivalent representation in both thermal equilibrium and non-equilibrium (illuminated) cases. The charge density is identical, implying that band bending computed by the simulation is accurate. We find errors in the recombination rate for the bivalent representation are normally less than or equal to σ0/σch, where σ° is the capture cross section of D0 and σch is the capture cross section of a charged state of D. Typically Modelers use σ0/σch of 1:10 to 1:100 yielding insignificant errors in the recombination rate with the uncorrelated bivalent representation.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 336: Symposium A – Amorphous Silicon Technology - 1994 , 1994 , 153
Copyright
Copyright © Materials Research Society 1994

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

[1] Hack, M. and Shur, M., J. Appl. Phys. 58, 997 (1985);Google Scholar
Rubinelli, F.A., Fonash, S.J., Arch, J.K., 6th International PVSEC Proc., 851 (1992)Google Scholar
[2] Gray, J.L., IEEE Trans. Electron Devices 36, 906 (1989).Google Scholar
[3] Block, M., in Proceedings of the 15th International Conference on Amorphous Semiconductors, edited by Elliot, S. R., Davis, E. A., and Robertson, J. Cambridge, UK, 1993), in press.Google Scholar
[4] Hubin, J., Shah, A. V., and Sauvain, E., Phil. Mag. Lett. 66, 115 (1992).Google Scholar
[5] Okamoto, H. and Hamakawa, Y., Solid St. Comm. 24, 23 (1977).Google Scholar
[6] Simmons, J. G. and Taylor, G. W., Phys. Rev. B 4, 502 (1971).Google Scholar
[7] Bar-Yam, Y. and Joannopoulos, J.D., J. Non-Cryst. Solids 97&98, 467 (1987);Google Scholar
Powell, M.J. and Deane, S.C., Phys. Rev. B 48, 10815 (1993).Google Scholar