Hostname: page-component-78c5997874-s2hrs Total loading time: 0 Render date: 2024-11-10T10:32:59.239Z Has data issue: false hasContentIssue false
  • English
  • Français

Optimization of Blend Toughness by Simultaneous Measurement of Heat and Work of Deformation

Published online by Cambridge University Press:  10 February 2011

N. Agarwal  and
R. J. Farris
N. Agarwal
Affiliation:
Polymer Science and Engineering, Silvio O. Conte National Center for Polymer Research, University of Massachusetts, Amherst, Amherst, MA 01003
R. J. Farris
Affiliation:
Polymer Science and Engineering, Silvio O. Conte National Center for Polymer Research, University of Massachusetts, Amherst, Amherst, MA 01003
Get access

Abstract

The technique of differential gas pressure calorimtery is used to simultaneously measure heat and work of isothermal deformation of acrylic based latex blend coatings. These coatings comprise of phase separated hard and soft components resulting in a combination of stiffness and toughness. An overall energy balance approach is adopted to study the partition of energy between the two phases in their respective energy-dissipating and energy-absorbing mechanisms. The toughness is maximized by a simultaneous maximization of heat dissipation and energy absorption; a fact often overlooked in the design of commercial rubber toughened systems that focus almost entirely on increasing the energy absorbing capacity of the glassy matrix. It is observed that maximizing both the energy absorption as well as dissipation can result in much higher toughness without a large sacrifice in stiffness.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 505 , 1997 , 273
Copyright
Copyright © Materials Research Society 1998

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1.Gough, J., Proc. Lit. & phil. Soc., Manchester, 2nd Ser., 1, p. 288 (1805)Google Scholar
2.Joule, J. P., Trans. Roy. Soc. (London), A149, p. 91 (1859)Google Scholar
3.Duvdevani, I. J., Biesenberger, J. A. and Gogos, C. G., Polym. Eng. & Sci., 10(6), p. 320 (1970)Google Scholar
4.Muller, F. H. and Engelter, A., Rheol. Acta., 1, p. 39 (1958)Google Scholar
5.Lyon, R. E. and Farris, R. J., Rev. Sci. Instrum., 57(8), p. 1640 (1986)Google Scholar
6.Lyon, R. E. and Raboin, P. J., J. Therm. Anal., 44, p. 777 (1995)Google Scholar
7.Lyon, R. E. and Farris, R. J., Polym. Eng. & Sci., 24(11), p. 908 (1984)Google Scholar
8.Adams, G. W., Ph.D. Thesis, University of Massachusetts, Amherst (1987)Google Scholar
9.Adams, G. W. and Farris, R. J., Polymer, 30, p. 1824 (1989)Google Scholar
10.Hashin, Z. and Shtrikman, S., J. Mech. Phys. Solids, 11, p. 127 (1963)Google Scholar
11.Farber, J. N. and Farris, R. J., J. Appl. Polym. Sci., 34, p. 2093 (1987)Google Scholar