Hostname: page-component-78c5997874-4rdpn Total loading time: 0 Render date: 2024-11-10T10:18:44.983Z Has data issue: false hasContentIssue false

Stress-Strain Curves by Tensile Testing of Thin Metallic Films On Thin Polyimide Foils: Al, AlCu, CuNi(Mn)

Published online by Cambridge University Press:  10 February 2011

F. Macionczyk
Affiliation:
Institute of Solid State and Materials Research Dresden, P.O.Box 27 00 16, D-01171 Dresden, Germany.
W. Brückner
Affiliation:
Institute of Solid State and Materials Research Dresden, P.O.Box 27 00 16, D-01171 Dresden, Germany.
G. Reiss
Affiliation:
Institute of Solid State and Materials Research Dresden, P.O.Box 27 00 16, D-01171 Dresden, Germany.
Get access

Abstract

For better understanding the mechanical properties of thin films it is helpful to use the same experimental methods as for bulk material, like tensile tests, thereby being able to directly compare the results. However, tensile tests of free-standing metallic thin films are often difficult to perform for reasons of preparation, handling, and stresses in the films. By leaving the metallic film on an elastic substrate tensile tests were performed in a rather simple and precise manner, using a commercial tensile testing machine. Stress-strain curves were determined by separating the force working on the substrate from that working on the film-substrate compound. Those measurements were done at room temperature for Al, AlCu(0. 5 wt %) and Cuo0.57Ni0.42Mn0.01 thin (200–2000 nm) films prepared by magnetron sputtering on 8 μm and 13 μm thick polyimide (Kapton) foils. The film microstructure was characterized by scanning and transmission electron microscopy and X-ray diffraction. The tensile strength of the fine grained films was found to be up to one order of magnitude higher than for the corresponding coarse grained bulk material. Al and AlCu films showed little, CuNi(Mn) films showed no plastical behavior. Crack formation started between 0.3 % and 2 % strain depending on the material, the thermal history, and the grain size.

Type
Research Article
Copyright
Copyright © Materials Research Society 1998

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1.Hutchinson, J.W. and Suo, Z., Adv. Appl. Mech. 29, 63191 (1992).Google Scholar
2.Read, D.T. and Dally, J.W., SPIE Proc. 1986, 57 (1993).Google Scholar
3.Rosenmayer, C.T., Brotzen, F.R., and Gale, R.J., Mat. Res. Soc. Symp. Proc. 130, 77 (1989).Google Scholar
4.Griflfn, A.J., jr., Brotzen, F.R., Dunn, C.F., Thin Solid Films 150, 237 (1987).Google Scholar
5.Ho, P.S. and Faupel, F., Appl. Phys. Lett. 53, 1602 (1988).Google Scholar
6.Faupel, F., Yang, C.H., Chen, S.T., and Ho, P.S., J. Appl. Phys. 65(5), 1917 (1989).Google Scholar
7.Hu, M. S., Thouless, M. D. and Evans, A. G., Acta metall. 36, 1301 (1988).Google Scholar