Article contents
Surface Charge Properties Of Kaolinite
Published online by Cambridge University Press: 10 February 2011
Abstract
The surface charge components of two Georgia kaolinites of differing degree of crystallinity (KGa-1 and KGa-2) were measured using procedures based on charge balance concepts. Permanent structural charge density (Σ0) was determined by measuring the surface excess of Cs, which is highly selective to permanent charge sites. The values of Σ0 determined were -6.3 ± 0.1 and -13.6 ± 0.5 mmol kg-1 for kaolinites KGa-l and KGa-2, respectively. The net proton surface charge density (σH) was determined as a function of pH by potentiometric titration in 0.01 mol dm-3 LiC1. Correction from apparent to absolute values of ΣH was made by accounting for Al release during dissolution, background ion adsorption, and charge balance. Lithium and Cl adsorption accounted for the remainder of the surface charge components. Changes in surface charge properties with time were measured after mixing times of 1, 3, and 15 hours (the latter representing “equilibrium”). Time-dependent behavior is believed to be caused by mineral dissolution followed by readsorption or precipitation of Al on the mineral surface. Both the point of zero net charge (p.z.n.c.) and the point of zero net proton charge (p.z.n.p.c.) changed with mixing time, generally increasing. The “equilibrium” p.z.n.c. values were approximately 3.6 and 3.3 for KGa-1 and KGa-2, respectively, while the corresponding p.z.n.p.c. values were about 5.0 and 5.4. The p.z.n.c. results were in good agreement with previous studies, but the values of p.z.n.p.c. were higher than other values reported for specimen kaolinite.
- Type
- Research Article
- Information
- Copyright
- Copyright © Materials Research Society 1997
References
- 6
- Cited by