Hostname: page-component-78c5997874-fbnjt Total loading time: 0 Render date: 2024-11-13T02:57:40.657Z Has data issue: false hasContentIssue false
  • English
  • Français

Temperature Dependence of Stress Distribution in Depth for Cu Thin Films

Published online by Cambridge University Press:  01 February 2011

Tokuji Himuro  and
Shinji Takayama
Tokuji Himuro
Affiliation:
Dept. of Systems and Control Engineering, Hosei University, 3–7–2, Kajino-Cho, Koganei, Tokyo, 184–8584, Japan
Shinji Takayama
Affiliation:
Dept. of Systems and Control Engineering, Hosei University, 3–7–2, Kajino-Cho, Koganei, Tokyo, 184–8584, Japan
Get access

Abstract

The stress distribution of (111) textured Cu films with depth was measured by using a GIXS method. We derived the equation to correct a scattering diffraction angle with depth, measured in the GIXS Seemann-Bohlin geometry, to obtain the actual scattering angle. It was revealed after the correction of the measured scattering angles that the internal stresses of (111) grains, on the whole, tend to increase almost linearly with increasing film depth from the free surface toward the substrate. It was suggested that these results were opposite to the results of the elastic calculation reported, and hence that a large stress relaxation took place during and/or after deposition and annealing. After annealing at various temperatures, these stress distribution profiles are almost unchanged, and are simply shifted uniformly in magnitude.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 854: Symposium U – Stability of Thin Films and Nanostructures , 2004 , U11.11
Copyright
Copyright © Materials Research Society 2005

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1. Takayama, S., Oikawa, M., and Himuro, T., Mat. Res. Soc. Symp. Proc. 795, 235 (2003).Google Scholar
2. Toney, M. F. and Huang, T. C., J. Mater. Res. 3 (2), 351 (1988).Google Scholar
3. Doerner, M. F. and Brennan, S., J. Appl. Phys., 1, 126 (1988).Google Scholar
4. Nye, J. F.: Physical Properties of Crystals (Oxford University Press, London, 2001) p.131.Google Scholar
5. Brenner, A. and Senderoff, S., J. Res. of National Bureau of Standard, 42, Nos. 1–6, 105 (1949)Google Scholar
6. Pang, M., Ricoult, M. B., and Baker, S. P., Mat. Res. Soc. Symp. Vol. 795, 75 (2004).Google Scholar