Microscopic conformation, growth behaviour and freezing sensitivity of seven strains of Geotrichum candidum, a ripening starter, were studied and compared according to their macroscopic morphotypes. It has been shown that the thallus forming units (TFU)×ml−1/OD600nm ratio as a function of time is an interesting parameter to follow G. candidum sporulation through the growth behaviour. Microscopic conformation, growth behaviour and freezing sensitivity are clearly strain specific and mostly related to their corresponding morphotypes “yeast”, “mould” or “intermediate”. The two “mould” strains that sporulate weakly (UCMA103, UCMA499) showed a low survival rate to freezing stress whereas the “yeast” strains expressed a significant resistance owing to the arthrospore abundance. Interestingly, one strain (UCMA96) which appeared on solid medium in accord with the “mould” morphotype respond similarly to freezing stress.

PCR primers were developed for the specific detection of Clavispora lusitaniae, Debaryomyces hansenii var hansenii, Geotrichum candidum, Kluyveromyces lactis and K. marxianus and Yarrowia lipolytica, yeast species commonly found on the surface of smear cheese. Forty eight representative strains frequently found in smear cheeses or taxonomically related to the target yeasts were used as templates, to validate the designed primers. The specific and selective detection of these yeasts was effective in situ, in Livarot smear, without yeast isolation and culture and was comparable with data obtained with a conventional method. The primers described here have thus potential for PCR studies applied to cheese. It should also be possible to use some of these primers with other substrates.

Phenomena generating FFAs, important flavour precursors, are significant in cheese ripening. In Camembert-like cheeses, it was intended to establish the relationships between the dynamics of FFA concentrations changes and the succession of ripening microflora during ripening. Experimental Camembert-type cheeses were prepared in duplicate from pasteurised milk inoculated with Kluyveromyces lactis, Geotrichum candidum, Penicillium camemberti, and Brevibacterium aurantiacum under aseptic conditions. For each cheese and each cheesy medium, concentrations of FFAs with odd-numbered carbons, except for 9[ratio ]0 and 13[ratio ]0, did not change over time. For long-chain FFAs, concentrations varied with the given cheese part (rind or core). K. lactis produced only short or medium-chain FFAs during its growth and had a minor influence on caproic, caprylic, capric, and lauric acids in comparison with G. candidum, the most lipolytic of the strains used here. It generated all short or medium-chain FFAs (4[ratio ]0–12[ratio ]0) during its exponential and slowdown growth periods and only long-chain ones (14[ratio ]0–18[ratio ]0) during its stationary phase. Pen. camemberti produced more long-chain FFAs (14[ratio ]0–18[ratio ]0) during its sporulation. Brev. aurantiacum did not generate any FFAs. The evidence of links between specific FFAs and the growth of a given microorganism is shown.

A holistic approach of a mould cheese ripening is presented. The objective was to establish relationships between the different microbiological and biochemical changes during cheese ripening. Model cheeses were prepared from pasteurized milk inoculated with Kluyveromyces lactis, Geotrichum candidum, Penicillium camemberti and Brevibacterium linens under aseptic conditions. Two cheese-making trials with efficient control of environmental parameters were carried out and showed similar ripening characteristics. K. lactis grew rapidly between days 1 and 6 (generation time around 48 h). G. candidum grew exponentially between days 4 and 10 (generation time around 4·6 d). Brevi. linens also grew exponentially but after day 6 when Pen. camemberti mycelium began developing and the pH of the rind was close to 7. Its exponential growth presented 3 phases in relation to carbon and nitrogen substrate availability. Concentrations of Pen. camemberti mycelium were not followed by viable cell count but they were evaluated visually. The viable microorganism concentrations were well correlated with the carbon substrate concentrations in the core and in the rind. The lactose concentrations were negligible after 10 d ripening, and changes in lactate quantities were correlated with fungi flora. The pH of the inner part depended on NH3. Surface pH was significantly related to NH3 concentration and to fungi growth. The acid-soluble nitrogen (ASN) and non-protein nitrogen (NPN) indexes and NH3 concentrations of the rind were low until day 6, and then increased rapidly to follow the fungi concentrations until day 45. The ASN and NPN indexes and NH3 concentrations in the core were lower than in the rind and they showed the same evolution. G. candidum and Pen. camemberti populations have a major effect on proteolysis; nevertheless, K. lactis and Brevi. linens cell lysis also had an impact on proteolysis. Viable cell counts of K. lactis, G. candidum, Pen. camemberti and Brevi. linens were correlated with the environmental conditions, with proteolytic products and with carbon substrate assimilation. NH3 diffusion from surface to the cheese core during ripening was highly suspected. Interaction phenomena between microorganisms are discussed.

Flavour generation in cheese is a major aspect of ripening. In order to enhance aromatic qualities it is necessary to better understand the chemical and microbiological changes. Experimental Camembert-type cheeses were prepared in duplicate from pasteurized milk inoculated with Kluyveromyces lactis, Geotrichum candidum, Penicillium camemberti and Brevibacterium linens under aseptic conditions. Two replicates performed under controlled conditions of temperature (12 °C), relative humidity (95±2%), and atmosphere showed similar ripening characteristics. The evolutions of metabolite concentrations were studied during ripening. The volatile components were extracted by dynamic headspace extraction, separated and quantified by gas chromatography and identified by mass spectrometry. For each cheese the volatile concentrations varied with the part considered (rind or core). Except for ethyl acetate and 2-pentanone, the volatile quantities observed were higher than their perception thresholds. The flavour component production was best correlated with the starter strains. During the first 10 days the ester formations (ethyl, butyl and isoamyl acetates) were associated with the concentrations of K. lactis and G. candidum. The rind quantity of esters was lower than that observed in core probably due to (1) a diffusion from the core to the surface and (2) evaporation from the surface to the chamber atmosphere. G. candidum and Brev. linens association produced 3 methyl butanol and methyl 3-butanal from leucine, respectively. DMDS came from the methionine catabolism due to Brev. linens. Styrene production was attributed to Pen. camemberti. 2-Pentanone evolution was associated with Pen. camemberti spores and G. candidum. 2-Heptanone changes were not directly related to flora activities while 2-octanone production was essentially due to G. candidum. This study also demonstrates the determining role of volatile component diffusion.