The boundary layer thickness on a compressor blade suction surface increases rapidly under a adverse pressure gradient and even separates from the blade surface. This paper proposes a novel method for developing the slot inside the blade, with the inlet of the slot located at the leading edge of the blade and the outlet located at the suction surface, using the momentum of the incoming flow to form a high velocity jet to control the boundary layer on the suction surface. For a plane cascade with a diffusion factor of 0.45, the effects of the main slot parametres (such as the shape of the slot and the positions of the slot inlet and outlet) on the flow in the slot, the flow field and the aerodynamic performance of the cascade were investigated with a numerical method. When the aerodynamic performance of cascades with slotted and unslotted blades was compared, it was found that a reasonable slot structure can effectively inhibit the development of the boundary layer on the blade suction surface and greatly improve the aerodynamic performance of the cascade. Based on the influence of the slot parametres of the above cascade, the slot of a plane cascade with a diffusion factor of 0.60 was designed. The numerical calculation results show that the slotted cascade with a diffusion factor of 0.60 outperformed the slotted cascade with a diffusion factor of 0.45. This result showed that the higher the cascade load, the greater the performance improvement from slotting. Furthermore, the unslotted and slotted cascades were tested, and the test results agreed well with the calculations. The aerodynamic performance of the slotted cascade was better than that of the unslotted cascade, which verifies the accuracy of the calculation method and the feasibility of blade slotting for suppressing the development of boundary layers on suction surfaces and reducing flow loss.

The rotating instability in a contra-rotating axial flow compressor is investigated by experiments. Twenty-four pressure sensors were installed on the casing to capture the unsteady flow in the rotor tip region simultaneously. A double-phase-locking technique suitable for the contra-rotating compressor was proposed to characterise the static pressure contours of the rotor tip. The mean and root-mean-square pressure contours indicate that rotating instability occurs before the rotating stall happened, and the rotor tip clearance vortex is located upstream of the rear rotor leading edge plane before stall. Fourier spectrum shows that rotating instability and rotating stall both happened under the stall condition, and the frequency band of rotating instability does not change with the flow rate. In the front rotor, the frequency of rotating instability is half of the blade passing frequency. It is verified that the modal estimation method can be implemented by using the average azimuthal phase velocity, which significantly reduced the number of pressure sensors required. Modal estimation results show that each peak of the rotating instability frequency band corresponds to a unique dominant circumferential mode. By optimising average azimuthal phase velocity, an improved modal estimation method is obtained, which can further improve the reliability of the modal estimation results.