Illite diagenesis in Tertiary and Mesozoic shales in the Bergen High area, northern North Sea, was studied using mineralogic, isotopic, and computerized thermal modeling techniques. The Tertiary shales are dominated by smectite, with lesser amounts of illite, kaolinite, and chlorite. At present burial temperatures of >70°C smectite is absent, and the shales contain abundant lath-shaped illite which yields a mixed-layer illite/smectite (I/S) X-ray powder diffraction (XRD) pattern. Transmission electron microscopy (TEM) indicates that the illite laths increase in abundance and thickness with increasing depth; XRD patterns indicate a progressive increase in the illite component of the I/S. The deepest samples were found to contain long-range ordered (R=3) I/S, which showed platy particle morphology with the TEM. K-Ar ages of most of the <0.1-μm-size illite separates imply that illitization was a relatively brief event affecting a thick sequence of sediments during late Cretaceous to early Paleocene time (65–87 Ma); however, measured ages were affected by trace levels of detrital Ar contamination and do not represent the true age of diagenesis.

Several methods of quantifying Ar contamination were used to correct measured ages to obtain a reasonable estimate of the true age of diagenesis. The corrected ages are imprecise due to uncertainties in quantifying the levels of sample contamination, but generally suggest a Paleogene (38–66 Ma) period of illitization. In contrast, simple kinetic models of smectite-illitization suggest much younger ages of diagenesis (0–40 Ma at the Veslefrikk field; 0–60 Ma at the Huldra field). The timing of the diagenesis and the morphologic aspects of the authigenic illite suggest that illite precipitated before late Tertiary compaction and resulted in a decrease in fluid permeability. Low trapping efficiency of early Tertiary sediments, vertical escape of warm fluid from the Brent sandstone, and high heat flow may have promoted illite diagenesis in the shales prior to deep late-Tertiary burial.

During an electron microscope study of the weathering of granite from southern New South Wales, Australia, an assemblage of minerals including florencite and rhabdophane was discovered replacing apatite. Light rare earth elements released from allanite early in weathering apparently combined with P released by leaching of primary apatite to form secondary phases exhibiting a range of morphologies and compositions. Chondrite normalized fractionation patterns La > Nd > Sm > Ce; La > Ce > Nd ≥ Sm and La = Sm = Nd > Ce were identified. The rare earth elements were present in very small crystals and aggregates of secondary minerals (< 10 μm) and coexisted with clays and secondary Fe-Ti oxides. The weathered granite was enriched about 6 to 10 times in all rare earth elements except Ce relative to fresh granite if the abundances were corrected for apparent enrichment due to reduction in density. The rare earth elements were probably derived from higher in the weathering profile, possibly by destruction of florencite and rhabdophane in very intensively weathered rock. Ce remained relatively immobile during weathering, probably due to its oxidation to Ce4+.

Illite/smectite (I/S) and illite samples that appear to be 1Md polytypes on the basis of the lack of diagnostic reflections can be resolved as partly either 1M or 2M1 or both by either vapor solvation in ethylene glycol for 40 to 80 hr at ambient temperatures or for 4 hr at 80°C, or by heating to 375°C for 2 hr. If samples are so treated, a distinct narrowing of the I/S 003/005 peak occurs and diagnostic hkl reflections are revealed. These treatments, however, do not seem to affect diagnostic polytypic peak intensities, but rather the adjacent background. We propose that the 1Md term be restricted to its original definition—the disordered polytype associated with only the 1M ordered polytype. For illites in which disorder exists with a mixture of polytypes, the generic term Ad (disordered group A micas) should be used. Correct polytype determination of illitic material is significant because it reveals thermal history of the sediments and allows greater understanding of the depositional and diagenetic history of sedimentary basins.

Aqueous Al passes from octahedral to tetrahedral coordination over a narrow pH interval, or threshold. This interval is 5.5–6.5 at 25°C and shifts to lower pH as temperature increases. The concentration of aqueous tetrahedrally coordinated Al is a quasi-step function of the solution pH, and, by the mass-action law, so should be the amount of tetrahedral Al incorporated by a silicate that crystallizes from the aqueous solution. Qualitative support for this prediction (which applies to quartz, opal-CT, kaolin-group minerals, pyrophyllite, micas, chlorites, and other low-temperature silicates) comes from the very topology of equilibrium activity diagrams and from several pairs of associated waters and authigenic silicates from weathering, hydrothermal, and diagenetic environments. The uptake of tetrahedral Al also depends on the aqueous concentrations of monovalent cations and silica, and on the mineral's structural constraints.

Solid solution of tetrahedral Al in halloysite in turn produces the characteristic bent or tubular crystals of this mineral. This genetic link between aqueous chemistry (mainly pH), tetrahedral-Al uptake by a low-temperature silicate, and the mineral's crystal morphology may operate also in other silicates.

A kaolinite-pyridine intercalation compound was prepared using hydrated kaolinite as an intermediate. Hydrated kaolinite having a basal spacing of 10 Å was treated with pyridine to form a well-ordered intercalation compound having a basal spacing of 12.0 Å. Infrared spectroscopy indicated the presence of hydrogen bonding between the hydroxyls of the kaolinite and the pyridine. 29Si nuclear magnetic resonance spectroscopy with cross polarization and magic-angle spinning revealed that intercalated pyridine affected the environment of silicon. The mono-substituted pyridine derivatives were also intercalated with hydrated kaolinite. On the basis of the basal spacings of the intercalation compounds and the stabilities of the derivatives between the layers, the pyridine appeared to be in an approximately perpendicular position, with the nitrogen facing the gibbsitic sheets.

Mn-substituted iron oxides were synthesized by coprecipitating Fe(NO3)3 and Mn(SO4) solutions with NH4OH, adjusting the suspensions to pH 4 or 6, and then keeping the suspensions at 55°C for 62 days. The Mn mole fraction of the final products ranged from 0 to 0.3. X-ray powder diffraction patterns showed that goethite and hematite formed in each Fe-containing system. Groutite formed in systems having initial Mn mole fractions ≥0.35. Only manganite and hausmannite formed in the pure Mn systems. The oxalate-soluble Fe in the samples increased as the Mn mole fraction increased and was slightly larger for the pH 6 series.

For samples that contained the largest Mn mole fraction, the b and c dimensions of the goethite unit cell were shifted toward those of groutite, and the b and c dimensions of the groutite unit cell were shifted toward those of goethite. Assuming the Vegard rule holds for the unit-cell c dimension, the goethite accommodated a maximum Mn mole fraction of 0.34, and the groutite accommodated a maximum Fe mole fraction of 0.31. The unit-cell dimensions of hematite did not vary systematically with the mole fraction of Mn in solution, probably because little Mn substituted into the hematite structure.

The interaction between N-methyl 8-hydroxy quinoline methyl sulfate, a drug that absorbs erymathogenic near-ultraviolet radiation, and smectite was studied by X-ray powder diffraction (XRD) and adsorption and desorption techniques. From the adsorption studies, (1) the amount of the drug adsorbed by Na-smectite increased with the pH of the solution to pH 6.5 and then decreased as the pH was further increased; (2) the maximum amount adsorbed at pH 6.5 was 102 meq/100 g of clay; and (3) the maximum amount of drug adsorbed, according to the adsorption isotherms at pH 4, was close to the cation-exchange capacity of the smectite (80 meq/100 g). The XRD studies showed that the drug molecules were adsorbed in the interlayer space of smectite and that cation exchange was the chief mechanism responsible for these interactions. The results of the adsorption-desorption cycles of the drug by smectite showed that this clay is a good support for this compound. In addition, an alternative method was developed to obtain the intercalation compound to avoid the standard method of exchange by impregnation. The method consisted of grinding a mixture of the drug with the clay. The characteristics of the complex thus formed were similar to those of the complex formed by exchange at pH 4 to 7.

To gain insight into the pharmacological properties of the intercalation compound studied, its capacity for absorption of visible and near-ultraviolet light was investigated. The diffuse reflectance spectrum of the complex showed intense absorption bands, absent or weak in the spectra of the pure drug or the untreated clay, at 250, 290, and ~390 nm.

Layer charge and cation-exchange characteristics of weathered biotite isolated from a Gray Luvisol in Saskatchewan showed that this product was a high-charge vermiculite. Cation-exchange capacity (CEC) of the sand-size (100–250 μm) weathered biotite particles from different horizons, as determined by a 30-min Ca/Mg exchange, was low (23–71 meq/100 g). Increasing the exchange period to 24 hr increased the CEC to 33–95 meq/100 g for samples from the solum horizons and to 155–163 meq/100 g for samples from C horizons. The free oxide coatings on the mineral particles in the solum horizon samples apparently prevented the exchange cations from entering the interlayers. Removal of free oxides followed by 24-hr exchange sharply increased the CEC of these samples to 105–155 meq/100 g. Oxidation and loss of structural iron resulted in lower octahedral-cation occupancy (2.4–2.6 per half unit cell), suggesting a transition of the trioctahedral biotite to dioctahedral vermiculite. X-ray powder diffraction and high-resolution transmission electron microscopic analyses of alkylammonium-exchanged samples from the sand fractions of all horizons and magnetic separates of the coarse clays showed a linear increase in the d-value of the vermiculite with increasing chain length of the cations. The linear relationships suggest a paraffin-type arrangement having a uniform and high layer charge (0.70–0.76 per half unit cell in the sand-size particles; 0.80–0.84 in the clay fraction). The empirical relationship between tilt angle (α) and the layer charge density for paraffin-type structures, as suggested by Lagaly and Weiss, cannot be used for accurate layer-charge determination. Based on experimental evidence, a straight line relationship between the tilt angle and layer charge is suggested. The layer charge values show no marked variation within the profile and agree well with those calculated from the chemical composition. The repotassified layers of vermiculite in the sand-size weathered biotite particles did not respond to the Ca/Mg exchange, but were expanded by the alkylammonium cations; in contrast, a pure biotite standard (Bancroft, Ontario) of same particle size was unaffected by either treatment.

Hydrotalcite-like minerals, containing Mg2+-Al3+-Xn− (Xn− = NO3−, Cl−, SO42−, or CrO42−), Zn2+-Al3+-NO3−, or Zn2+-Cr3+-NO3− ions, were intercalated with Co(CN)63− by an anion exchange method. For most of the minerals examined, the degree of anion exchange was 79–90%. X-ray powder diffraction patterns of the ion-exchanged samples revealed two peaks at about 8° and 11°2θ (CuKα radiation) attributable to reflections from expanded and non-expanded interlayers, respectively. The intensity of the peak at about 8°2θ was a linear function of the degree of anion exchange. The amount of hexane adsorbed onto the anion-exchanged sample increased linearly with the increase in degree of anion exchange. From these results, anions near the edge of the interlayers appear to have been preferentially replaced by Co(CN)63− at a low degree of anion exchange, whereas those at some distance from the edge were replaced only at a high degree of anion exchange. The adsorption capacity of the Co(CN)63−-exchanged sample for hydrocarbons was: hexane ≃ 2-methylpentane ≫ cyclohexane > methylcyclohexane. The adsorption of chain hydrocarbons and cyclic hydrocarbons was different.

The Porters Creek Formation is mined as an absorbent clay in Illinois, Mississippi, Missouri, and Tennessee. The absorptive properties of the Porters Creek Formation are due to the high content of smectite which constitutes >50% of the minerals present. Analyses of 220 samples of the Porters Creek collected in Illinois, Missouri, and Tennessee indicate that the smectite content is highest on the western side of the Mississippi embayment and that the kaolinite content is highest on the northeastern side. The major influx of detritral clays appears to have entered the embayment from a large river on the northeast side. A major control of the distribution of clay minerals during the time of Porters Creek deposition was differential flocculation of kaolinite, illite, and smectite, as evidenced by the numerous syneresis cracks on bedding planes in the area of greatest kaolinite content. Estimates of the smectite, illite, and kaolinite contents suggest both horizontal and vertical variations among these clay minerals. In certain localities the oxidation of pyrite has created acid conditions, which apparently were conducive to the formation of authigenic halloysite.