Petroleum geologists always need to deal with large gaps in data resolution and coverage during reservoir characterisation. Seismic data show only large geological structures, whereas small-scale structures and reservoir properties can be observed only at well locations. In the area between wells, these properties are often estimated by means of geostatistics. Numerical simulation of sedimentary processes offers an alternative method to predict these properties and can improve the understanding of the controls on reservoir heterogeneity. Although this kind of modelling is widely used on basin scale in exploration geology, its application on field scale in production geology is virtually non-existent. We have assessed whether the recent developments in numerical modelling can also aid petroleum geologists in the interpretation of the reservoir geology.

Seismic data, well data and a process-response model for coastal environments were used to characterise the Lower Cretaceous oil-bearing Rijn Field. Interpretation of seismic and well data led to a definition of the structural setting and the depositional model of the Rijn Member in the area. From the sedimentological interpretation the sea-level history could be estimated, which is the one of the most important input parameters for the process-response model.

Application of the process-response simulator to the Rijn Field resulted in approval of the depositional model. The output was presented in a 2-dimensional north-south profile, which corresponds very well to the well logs along this section. The results demonstrate that numerical simulations of geological processes can be very useful as a tool to explore many likely geological scenarios. While it cannot be used to supply a unique solution in many cases, it forms a helpful guide during reservoir characterisation to find an optimal scenario of the controls on deposition of the Rijn Member, which contributes to the understanding of the inter-well reservoir heterogeneity.

Drained coastal peatlands are a source of greenhouse gas (GHG) through abundant CO2 release caused by aerobic peat degradation. Published rates of CO2 fixation and CH4 release for natural peatlands suggest that areas of peat formation are a (small) net source of GHG emission because the radiative effect of emitted CH4 exceeds the CO2 uptake by the vegetation. It is shown here that wetland restoration of reclaimed peat areas in the western Netherlands leads to a reduction of GHG emission because the expected increase in anaerobically generated CH4 release is much smaller than the decrease in aerobically produced CO2.

A widespread, slumped, redeposited, uppermost Cretaceous chalk interval, up to 60m thick, immediately below the Cretaceous-Tertiary (K-T) boundary, recognised in oil company boreholes across the central North Sea and a major hydrocarbon reservoir, we re-interpret as the result of a single, catastrophic event caused by secondary effects related to the bolide impact at Chicxulub. A thin, dark clay bed immediately above the redeposited chalks, we suggest correlates to the outcropping, Iridium rich, Danish ‘Fish Clay’, rapidly deposited after the impact. Physical effects on sea-floor sediments, caused by the K-T bolide impact, have not previously been interpreted in the North Sea.

All Dutch rift basins that formed during Jurassic and Early Cretaceous extension have been inverted during the Late Cretaceous and Early Tertiary. Several inversion pulses occurred more or less simultaneously in all basins. Analysis of vitrinite reflectance data, in combination with fission track and fluid inclusion data show that the magnitude of uplift and erosion generally did not exceed 2 km. Inversion was strongest in the Broad Fourteens, Central Netherlands and West Netherlands basins. The direction of maximum compressive stress was generally not at right angles to the pre-existing fault trends, and resulted in transpressional movements. Within the NW-SE striking basins, dextral strike-slip movements can often be interpreted, which is consistent with a general N-S to NNW-SSE direction of maximum compression related to Alpine structural events. Where no Zechstein salt is present, trends of flower structures formed through reverse reactivation of pre-existing faults. Where the Zechstein salt is thick, re-activated faults could not breach the salt, and a broad uplift of the post-salt succession resulted, while faulting below the salt caused acceleration of halokinesis. In areas where the Zechstein salt was thin, and where the offsets of reverse faults exceeded the thickness of the salt, impressive thrusts with the Zechstein salt as detachment horizon developed. The later Tertiary inversion pulses did not affect all basins, and caused broad basin uplift in the West and Central Netherlands basins while individual faults were no longer reactivated. It appears that due to crustal thickening during the first inversion pulses the crust could become stabilised such that further compression could only be accommodated by broad basin uplift.

The diversity of morphological features of Mesozoic inversion structures in NW Germany as representatives of inversion structures in northern Europe is presented and their origin analysed and geologically dated. The particular role of salt in inverted basins and the re-shaping of pre-existing salt structures during the inversion act is demonstrated and the term ‘salt wedge’, a Zechstein salt intrusion into salt layers within the Triassic sedimentary pile, introduced. The leading theories on inversion (continent-continent collision, re-activation Variscan features) are discussed and discarded, but no new comprehensive theory was developed. The impact of inversion on HC prospectivity of sedimentary basins is debated and proposals for future interdisciplinary research are made.