We present a three-dimensional code for the optimization of energy storage, heat deposition, and amplification in square-shaped laser slabs and multi-slab laser amplifiers. The influence of the slab dimensions, slab face and edge reflectivities, pump parameters, and operating temperature on amplified spontaneous emission and stored energy has been investigated. The multi-slab and single-slab configurations are compared, analyzing in detail the influence of the absorption cladding for the suppression of amplified spontaneous emission radiation.

In this paper, we extend our previous work of classical over barrier ionization (COBI) model to study the multiple-ionization and mean charge state of noble gases colliding with heavy ions at energies close to the Bragg peak region ranging up to some hundreds of keV/amu. The method we report is in good agreement with experimental data and offers the advantage of very small computation time. Therefore, this model will be extremely helpful to be included in numerical codes to calculate the charge state distribution in plasma.

The high power microwave (HPM) synthesis method is presented in this paper for gigawatt level. The gigawatt level HPM could be synthesized from two separate input wave-guides according to the coupled-wave and orthogonal polarization theory. The synthesizer is used by two back to back circular wave-guides. The main channel is the circular wave-guide connected to the output port, which transmits horizontal polarization TE011 mode. The operating bandwidth is only limited by the barrier wave-length λc of circular wave-guide. The sub-channel transmits vertical polarization TE011 mode and the operating bandwidth is up to several hundred MHz. The energy of sub-channel could be coupled into main channel through continuous long-slit coupling structure. The synthesizer can be analyzed using numerical simulation method, which focuses on the power capability. The simulation results indicate that the transmission efficiency of the main channel is above 99%, the coupling efficiency of the sub-channel is above 96%, which also validates the reasonability of synthesizer design. At the same time, the prototype of synthesizer is designed and the HPM experiment system is established. The transmitting and coupling efficiency are both greater than 95% in cold test condition and they are also greater than 90% in gigawatt class test condition, the power capability of the synthesizer reaches about 1.2GW. The test results validate the feasibility of synthesizer for gigawatt class HPM.

In fast ignition of inertial confinement fusion, hot electron beam is considered to be an appropriate energy source for ignition. However, hot electrons are divergent as they are transporting in over-dense plasma. So collimating the hot electrons becomes one of the most important issues in fast ignition. A method to collimate hot electron beam by external magnetic field is proposed in this paper. The external field can be generated by compressing a seed magnetic field at the stage of laser-driven implosion. This method is confirmed by particle-in-cell simulations. The results show that hot electrons are well collimated by external magnetic field from magnetic-flux compression.

Evolution of longitudinal electrostatic wakefields, due to the propagation of a linearly polarized super-Gaussian laser pulse through homogeneous plasma has been presented via two-dimensional particle-in-cell simulations. The wakes generated are compared with those generated by a Gaussian laser pulse in the relativistic regime. Further, one-dimensional numerical model has been used to validate the generated wakefields via simulation studies. Separatrix curves are plotted to study the trapping and energy gain of an externally injected test electron, due to the generated electrostatic wakefields. An enhancement in the peak energy of an externally injected electron accelerated by wakes generated by super-Gaussian pulse as compared to Gaussian pulse case has been observed.

Laser light trapping in cavities in near-critical density plasmas is studied by two-dimensional particle-in-cell simulation. The laser ponderomotive force can create in the plasma a vacuum cavity bounded by a thin overcritical-density wall. The laser light is self-consistently trapped as a half-cycle electromagnetic wave in the form of an oscillon-caviton structure until it is slowly depleted through interaction with the cavity wall. When the near-critical density plasma contains a preformed cavity, laser light can become a standing wave in the latter. The trapped light is characterized as multi-peak structure. The overdense plasma wall around the self-generated and preformed cavities induced by the laser ponderomotive force is found to be crucial for pulse trapping. Once this wall forms, the trapped pulse can hardly penetrate.

We investigate the influence of the initial size of the proton layer on proton acceleration in the interaction of high intensity laser pulses with double-layer targets by using two-dimensional particle-in-cell code. We discuss the influence of proton layer initial sizes on the cut-off energy, energy spread, and divergence angle of proton beam. It is found that Coulomb explosion plays an important role on the proton cut-off energy. This causes the cut-off energy to increase for increasing proton layer thickness, at the expense of energy spread. The proton divergence angle reaches a peak value and then falls again with increasing the width. Proton divergence angle grows with target thickness. It is found that there is an optimal thickness to obtain the narrowest energy spread, which may provide an effective method (change the size of proton layer) to obtain high quality proton beams. This work may serve to improve the understanding of sheath field proton acceleration.

A new inverse Compton scattering scheme for production of high-energy Gamma-ray sources is proposed in which a Giga-electronvolt (GeV) electron beam is injected into a thermal hohlraum. It is found that by increasing the hohlraum background temperature, the scattered photons experience kinematic pileup, resulting in more monochromatic spectrum and smaller scattering angle. When a relativistic electron beam with energy 1 GeV and charge 10nC is injected into a 0.5 keV hohlraum, 80% of the scattered photons have energy above 0.5 GeV.

We study the problem of the radiation pressure acceleration of ions and the formation of plasma jets, driven by a high-intensity circularly polarized laser beam normally incident on thin plasma targets. We use an Eulerian Vlasov code to solve the one-dimensional relativistic Vlasov-Maxwell equations for both electrons and ions. We consider the case of a high density plasma with n/ncr = 100, where ncr is the critical density. Three cases are studied with different target thicknesses, to investigate the physical processes involved when decreasing the target thickness from several electron skin depths down to the order of one skin depth. The results show a more important acceleration of the ions when the thickness is decreased. Although we observe in all cases a neutral plasma jet ejected from the back of the target, the evolution of the system which leads to the formation of this neutral plasma jet is different in the three cases considered. In each case, this evolution will be studied in details. Also, a leak or ejection of electrons from the back of the target is observed in the thinnest case treated (thickness of the order of the skin depth), before the formation of the neutral plasma jet, a regime called leaky light sail radiation pressure acceleration. The absence of noise in the Eulerian Vlasov code allows an accurate representation of the phase-space structures of the distribution functions.

In this paper, we are presenting the microwave emission results of a vircator that emits its radiation lying well-within the microwave range of electromagnetic spectrum viz 4–8 GHz and the energy needed per shot is as low as 25 Joules only. In this reported experiment, the pulse forming line is charged to a voltage of 160 kV and the measured diode voltage is 50 kV in the experiment. The primary energy is nearly 50 Joules only and hence the energy efficiency of the high voltage pulse transformer and pulse forming line combination for the given experiment is nearly 50%. The experiment is the first of its kind in establishing (experimentally) the low voltage operation of a conventional vircator, which has a planar cylindrical cathode and stainless steel mesh anode, for the microwave emission purpose. Moreover, because of the low voltage and low energy operation we could operate the whole system in repetitive mode and we could achieve as high as 4 Hz operation with this device. Interestingly, the current density of the velvet cathode used in the present experiment is nearly 300 A/cm2 in the present reported set of experiments. One interesting observation emerging out from the present experiment is that in the low voltage operation of the vircator the beam acceleration potential is relatively low and hence the axial velocities of reflexing electrons (trapped between cathode and virtual cathode) is also limited and far less than 1.8 × 108 m/s and hence with small anode cathode gaps like that of 3 mm, which is the case of present experiments, it becomes feasible to achieve radiation frequency of 4–8 GHz from the vircator.

A new two-step approach for frequency conversion of laser radiation towards hard X-rays is developed and examined experimentally. Fast electrons are produced in a form of thin jets at the first stage, as an intense femtosecond laser pulses impinges on a micrometer water target. In the second stage the accelerated electrons hit a secondary metal target and generate characteristic K-shell radiation with a duration down to sub-femtosecond. It is shown that counter propagating laser radiation experiences very strong up-shift with up to 6 × 103 times of fundamental frequency by reflection from the electron jets.

High speed framing camera (HSFC) could be used to capture the image of the electron beams generated by the intense electron-beam accelerator (IEBA), and it is useful to visualize the evolution of discharging and plasma generation phenomenon. So an overview of the application of HSFC on the IEBA is presented. First, we introduce the synchronization problem of HSFC and IEBA, and a synchronization trigger system which could provide a trigger signal with rise time of 17 ns and amplitude of about 5 V is presented. Second, an imaging system based on IEBA, HSFC, and the synchronization trigger system is developed, and it can be used to image the developmental process of plasma in the output vacuum chamber of IEBA and to measure the electrical parameter of IEBA and electrical trigger signal in real time. Furthermore, the imaging system is used to investigate the developmental process of the electron beam of the A-K gap in vacuum under 180 nanosecond quasi-square pulses. It is obtained that the short A-K gap is closed prematurely under long pulse operation with plasma expansion velocity of about 6.25 cm/µs and the light emission in the A-K gap region has the characteristics of “re-ignition” with light duration time about 3800 ns. At last, the discharging process of surface flashover channel of poly-methyl methacrylate (PMMA) insulator with gap spacing of 170 mm in vacuum under nanosecond quasi-square pulses is studied by the imaging system, and the change of luminosity is analyzed during the surface flashover process.

The role of self generated magnetic fields in the transport of a heat wave following a nanosecond laser irradiation of a solid target is investigated. Magnetic fields are expected to localize the electron carrying the heat flux but at the same time are affected in their evolution by the heat flux itself. We performed simultaneous measurements of heat wave propagation velocity within the target and magnetic fields developing on the target surface. These were compared to results obtained by numerical magneto-hydrodynamic modeling, including self-generated B fields. The comparison shows that longitudinal heat flow is overestimated in the simulations. Similarly, but most notably, the radial expansion of the magnetic fields is underestimated by the modeling. The two are likely linked, the more pronounced radial drift of B-fields induces a rotation of heat flux in the radial direction, and corresponding longitudinal heat flux inhibition. This suggests the need for improving present modeling of self-generated magnetic fields evolution in high power laser-matter interaction.

The irradiation of thin films by intensive subpicosecond laser pulses with nanosecond prepulse is accompanied by a number of various physical processes. The laser beam transmissions through the film as well as the re-emission flux on both sides of the film plasma have been evaluated by simulation for Al and CH2 materials. It has been demonstrated that the thickness of the film can be chosen to cut off the long nanosecond prepulse whereas the main pulse is transmitted through the plasma. Thus, thin films can be useful for the laser contrast improvement in experiments with different targets.

Nevertheless, the laser energy transformation into the soft X-ray radiation on the back side of the shielding film plasma can reach up to 7% of the incident intensity for the Al film and result in strong preheating of the target. At the same time the re-emission flux produced by a CH2 film is an order lower than that in the case of Al film. The shielding of an Ag bulk target by Al and CH2 films is simulated and discussed.

This paper is devoted to the question of the conversion of nuclear energy into the energy of coherent optical radiation. The two possible ways to convert nuclear energy into laser radiation are discussed: direct and combined nuclear pumping. The concept of using laser gas active media capable of working with both direct and combined nuclear pumping is considered. The results of an investigation by Kazakh scientists on nuclear pumped lasers active media on bound–bound atomic transitions are presented.

This paper presents an investigation for excitation of ion acoustic wave and resulting stimulated Brillouin scattering in a collisionless plasma due to presence of a laser beam carrying null intensity at center (hollow Gaussian beam). In presence of ponderomotive nonlinearity, the pump beam get focused and affects the back stimulated Brillouin scattering process. To understand the nature of laser plasma coupling, a paraxial-ray approximation has been invoked for the propagation of the hollow Gaussian beam, ion acoustic wave, and stimulated Brillouin scattering. It is observed from the result that self-focusing and back reflectivity reduces for higher order of hollow Gaussian beam.

The results of the experimental studies of the high-power e-beam accelerator producing six radially convergent electron beams are presented. The studies are aimed to increase the energy of the electron beam transported through the foil into the gas-filled chamber by using the rod-shaped current returns in the diode at small inter-electrode gaps. Installation of these rod current returns shields the periphery regions of the diode from the current field in the central part thus reducing the field at the diode edge. The inter-electrode distance, the shape, and the sizes of the cathodes are chosen by taking into account the magnetic field reduction in the diode. It is shown that in such type of the diode the electrons impact the foil almost normally to its surface, and the electron beams enter the output windows completely. Such type of the diode allows increasing the efficiency of the electron beam energy transfer into the gas by 30%.

Multi-coaxial relativistic backward wave oscillator that generates the beating wave of high power microwave pulse driven by a single accelerator and a single guiding magnet system is presented. Making use of the coaxial annular cathodes that can synchronously produce three annular beams at one shot, the average power of 5.88 GW consisting of two frequency components 9.0 and 9.7 GHz is obtained under the diode voltage and current 724 and 19.57 kA, corresponding to the conversion efficiency 41.5%. The conversion efficiency and the beating frequency are considerably stable with the diode voltage. The coaxial transmission supporter developed from our previous experimental research is employed to conductively connect the coaxial structure and to incoherently combine the microwave pulse of two frequencies with little reflection. It is found that the equipotential connection of the coaxial structure modifies the field distribution in the diode structure to facilitate the operation of the coaxial annular cathodes. The coaxial cathodes of different lengths are proved to be efficient at depressing the space charge effect in order to prevent the explosive emission of the inner cathode from being shielded by the outer annular beams.

Nuclear fusion in ultra-dense deuterium D(-1) was reported previously to be induced by 0.2 J pulses with 5 ns pulse length, ejecting particles with energies in the MeV range. The ns-resolved signal from D(-1) to two in-line collectors at up to 1 m distance can be observed directly on an oscilloscope, showing particles with energies in the range 1–20 MeV u−1. They are probably mainly protons and deuterons in the form of neutral ultra-dense hydrogen H(-1) fragments. Electrons and photons give only small contributions to the fast signal. The observed signal at several mA peak current corresponds to 1 × 1013 particles released per laser shot and to an energy release >4 J assuming isotropic formation and average particle energy of 3 MeV. This corresponds to an energy gain of 30 in the process. A movable slit close to the laser target gives lateral resolution of the signal generation, showing almost only fast particles from the point of laser impact and penetrating photons from the plasma outside the laser impact point. The observation of multi-MeV particles indicates nuclear fusion, either as a source or as a result.