A Nd:YAG laser oscillator Q-switched and mode locked via a nonlinear mirror based on stimulated Brillouin scattering (SBS) and aided by an acousto optical modulator (AOM) has been realised. A rate equation model and a round trip model are used to describe the longitudinal mode dynamics. Parameter variations of the nonlinear SBS mirror and the loss modulating AOM in the resonator are investigated with regard to their effect on the pulse duration and spectra of the pulses.

Electron acceleration by a short high-current relativistic electron bunch (EB) in plasmas at three characteristic densities is studied by particle-in-cell simulation. It is found that if the EB is appropriately matched to the background plasma, the blowout space-charge field of the EB can accelerate the trailing bunch electrons at very high energy gain rate. This high energy gain, as well as the large-amplitude wakefield, the turbulent small-scale electron plasma waves, and the formation of large current peaks, are studied. The evolution of the EB, its blowout field, and other related parameters are shown to be self-similar.

We report spectrally resolved X-ray scattering data from shock compressed foils illustrating the feasibility of X-ray Thomson scattering experiment on a sub-kilo joule laser system. Sandwich targets consisting of CH/Al/CH were shock compressed using ∼1 ns laser pulses. Separate 270 ps laser pulses were used to generate an intense source of Ti-He-α (1s2-1s2p1P) radiation which was used as a probing source of 4.75 keV photons. The spectrum of scattered photons was recorded at a scattering angle of 82° with a CCD fitted spectrometer using a PET crystal in von-Hamos geometry. Although spectral resolution was used to separate the scatter from any background, the resolution was limited by source broadening. The relative level of scatter at different times in the sample history was measured by varying the delay between the shock driving beams and the back-lighter beams. We have compared the scatter spectra with simulations based on two different models of the L-shell bound-free contribution.

We generate self-phase-stabilized pulses by difference-frequency generation of a hollow-fibre broadened supercontinuum followed by two-stage optical parametric amplification. This system allows the production of broadband pulses widely tuneable in the near-IR wavelength region. Energies up to 0.2 mJ with 15 fs pulse width are demonstrated. These characteristics make this source suitable as a driver for attosecond pulse generation.

A thorough analysis of the electromagnetic instabilities encountered in the beam plasma interaction physics shows that the most unstable modes are not the ones which are usually studies. We characterize these most unstable modes and determine the patterns they create.

We perform systematic investigation of a new method for generating high-order harmonics, using ablation as the nonlinear medium. We place emphasis on clarifying the pump laser conditions for optimum harmonic yield. For this purpose, we use the Ti:Sapphire laser beams of the advanced laser light source (800 nm wavelength, 360 mJ total energy). We have independently varied the intensity of the prepulse (which creates the plasma ablation) and the intensity of the main pulse (which generates the harmonics), and studied their influence on the harmonic intensity. We show here that the presence of doubly ionized atoms in the ablation, created either by a strong prepulse intensity or by irradiating the main pulse, will suppress harmonic generation.

We have designed a compact solid compressor by stimulated Brillouin scattering (SBS), which consists of two right angle prisms and a fused silica glass block. A 13–16 ns Nd:YAG laser pulse has been temporally compressed to 1 ns or less phase conjugation pulse in a fused-quartz and fused-silica glass at four different wavelengths. Maximum reflectivity of SBS was 90–95% without damage. The brightness of the compressed pulse was about ten-fold higher than that of the incident pulse. Damage-free operation using fused quartz glass as a better phase conjugation material could lead to the construction of a more compact, laser-diode-pumped, and all-solid-state laser system.

We propose the use of Focused Ion Beam/Scanning Electron Microscope (FIB/SEM) devices for the analysis of ablation results. Ablated samples have been obtained by irradiating an Al planar target with an optically smoothed iodine laser working at 0.44 μm. The interpretation of FIB images shows the high potentiality of the technique.

We present a series of experimental results, and their interpretation, connected to various aspects of the hydrodynamics of laser produced plasmas. Experiments were performed using the Prague PALS iodine laser working at 0.44 μm wavelength and irradiances up to a few 1014 W/cm2. By adopting large focal spots and smoothed laser beams, the lateral energy transport and lateral expansion have been avoided. Therefore we could reach a quasi one-dimensional regime for which experimental results can be more easily and properly compared to available analytical models.

Scattering of energetic electron and proton beams by cold matter is significantly different from the scattering of these particles by plasma, which may be either highly ionized or dense strongly coupled plasma. This is due to the difference in the shielding of the target nuclei between the two cases. Quantitatively, we treat the problem by means of the Bethe Moliere multiple scattering theory and the version of this theory for plasma as derived by Lampe. We propose to use this effect as a plasma diagnostic tool, utilizing monoenergetic, well-collimated electron or proton beams produced either by femtosecond laser plasma interactions or by accelerators. The effect is first illustrated for simplicity, by calculating the widths of the angular distribution of scattered particles interacting with the extreme cases of very hot fully ionized carbon, and iron plasmas, and comparing these results to the corresponding cold material. The more relevant case of electron scattering from partially ionized iron and carbon plasmas covering the entire range from a cold to a completely ionized target is also dealt with here. This paper brings up and highlights the difference between scattering by plasma and by cold material in light of the recent proposals to employ particle beams for various fusion applications.

A low energy pulsed X-ray source with 17 J electrical input energy has been constructed based on the vacuum spark configuration triggered by the pseudospark electron beam. With such a low input electrical energy, the frequently studied X-ray emitting vacuum spark plasma is not obtained. Instead, this configuration gives rise to a point-like electron beam-target pulsed X-ray source at the tip of the anode. Emission of X-ray is observed during the pre-breakdown phase. The X-ray spectrum is dominated by the characteristic line emission of the anode material. The total X-ray energy emission from the source can be estimated by assuming it to be a monochromatic point source. It is found to have an X-ray production efficiency of 0.1%, giving an average X-ray dosage of 18 mGy per pulse. X-ray radiography of small biological sample is demonstrated to illustrate a potential application of the present X-ray source.

Laser-produced plasma (LPP) devices are being developed as a light source for the extreme ultraviolet (EUV) lithography applications. One concern of such devices is to increase the conversion efficiency of laser energy to EUV light. A new idea based on the initiation and confinement of cumulative plasma jet inside a hollow laser beam is developed and simulated. The integrated computer model (HEIGHTS) was used to simulate the plasma behavior and the EUV radiation output in the LPP devices. The model takes into account plasma heat conduction and magnetohydrodynamic processes in a two-temperature approximation, as well as detailed photon radiation transport in 3D Monte Carlo model. The model employs cylindrical 2D version of a total variation-diminishing scheme (for the plasma hydrodynamics) and an implicit scheme with the sparse matrix linear solver (to describe heat conduction). Numerical simulations showed that the EUV efficiency of the proposed hollow-beam LPP device to be higher than the current standard devices.

The effect of arbitrary shapes of the two fluid interface on Richtmyer-Meshkov (RM) instability is investigated. It is seen that deviation from sinusoidality in the geometrical shapes has interesting influence on the overall growth rate. In the linear theoretic domain the RM instability may be actually reduced for suitable geometrical shape of the interface. The figures given demonstrate this aspect. This result is important in designing ICF target and also gives an idea to tailor laser pulse for optimum stability of RM modes.

With the aid of an infrared thermograph technique, we directly observed the temperature variation across a bulk copper specimen as it was being ablated by multiple femtosecond laser pulses. Combining the experimental results with simulations, we quantified the deposited thermal power into the copper specimen during the femtosecond laser ablation process. A substantial amount of thermal power (more than 50%) was deposited in the copper specimen, implying that thermal effect can be significant in femtosecond laser materials processing in spite of its ultrashort pulse duration.

The interaction of high-intensity laser pulses with matter releases instantaneously ultra-large currents of highly energetic electrons, leading to the generation of highly-transient, large-amplitude electric and magnetic fields. We report results of recent experiments in which such charge dynamics have been studied by using proton probing techniques able to provide maps of the electrostatic fields with high spatial and temporal resolution. The dynamics of ponderomotive channeling in underdense plasmas have been studied in this way, as also the processes of Debye sheath formation and MeV ion front expansion at the rear of laser-irradiated thin metallic foils. Laser-driven impulsive fields at the surface of solid targets can be applied for energy-selective ion beam focusing.

Stochastic instabilities are studied considering the motion of one particle in a very high intensity wave propagating along a constant homogeneous magnetic field, and in a high intensity wave propagating in a nonmagnetized medium perturbed by one or two low intensity traveling waves. Resonances are identified and conditions for resonance overlap are studied. The part of chaos in the electron acceleration is analyzed. PIC code simulation results confirm the stochastic heating.

The effects of multiple pulses of a CO2 laser with energy of 2.5 J and pulse duration of 200 ns on the surface morphology of ion irradiated CR-39 is investigated in light of the modification in its track registration properties. For this purpose, a CR-39 was exposed by a CO2 laser generated hydrogen, argon, cadmium, air molecular ions (N2 and O2, etc.), high energy (300 KeV) proton beam from Cock Croft Walton accelerator, and α (5 MeV) from 0.5 μCi Pu239 source. The registered tracks were enlarged after 6 h of 6.25 N NaOH etching. These etched detectors were then exposed to different number of CO2 laser shots. The etched detectors were then analyzed by a computer controlled optical microscope (Lexica DMR series). It was observed that even a single shot of CO2 laser, irrespective of the registered ions tracks, can change the track registration properties of CR-39, and can remove the vaporization resistant skin present on the polymer (CR-39). A significant change in track density and track shaping regardless of the ions is observed. At the outside of the focal area, the ion density of different registered tracks is compared graphically before and after laser irradiation. Laser ablation of unexposed CR-39 is also done with multiple pulses CO2 laser. In this regard, the coherent and non-coherent structures, diffraction patterns, circular fringes with corrugations and ripples, droplets, chain like structures with cluster formation, chain folded crystallites, and hole drilling were observed. The irradiation induced ablation of the polymer is of great importance in electronics industry, lithography, etc.

This article appeared in Volume 24, Number 3, Pages 421–425.