The density distribution of inhomogeneous dense deuterium-tritium plasmas in laser fusion is revealed by the energy loss of fast protons going through the plasma. In our simulation of a plasma density diagnostics, the fast protons used for the diagnostics may be generated in the laser-plasma interaction. Dividing a two-dimensional area into grids and knowing the initial and final energies of the protons, we can obtain a large linear and ill-posed equation set for the densities of all grids, which is solved with the Tikhonov regularization method. We find that the accuracy of the set plan with four proton sources is better than those of the set plans with less than four proton sources. Also we have done the density reconstruction especially for four proton sources with and without assuming circularly symmetrical density distribution, and find that the accuracy is better for the reconstruction assuming circular symmetry. The error is about 9% when no noise is added to the final energy for the reconstruction of four proton sources assuming circular symmetry. The accuracies for different random noises to final proton energies with four proton sources are also calculated.

Quasi-monoenergetic electron beams of energies 12 MeV to over 200 MeV are generated from both nitrogen and helium gas targets with 7TW laser pulses. Typically nitrogen gas interactions lead to electron bunches in the range of 12 to 50 MeV varying from shot to shot. Helium gas leads to higher energy electron bunches from 25 to 100 MeV. Occasionally exceptionally high energy bunches of electrons up to 200 MeV are observed from nitrogen and helium. Initial full two-dimensional simulations indicate the production of 20–30 MeV electron energy bunches for the typical interaction conditions as the electrons are injected from wave breaking in the plasma wake behind the laser pulse and injected into the strong electric field gradient propagating with the optical pulse. This is consistent with the experimental observations from the majority of shots. Pulse compression during propagation in the high density plasma does not allow the threshold conditions for the full bubble regime to be reached. However, the electric acceleration field in the wakefield cavity is still sufficient to lead to the formation of a bunch of electrons with an energy peak in the range of 20 to 30 MeV. In order to explain the occasional high energy shots most likely a lower density channel created by the laser prepulse may occasionally form a natural low density electron guide channel giving ideal conditions for acceleration over much longer lengths leading to the high energies observed.

We focus attention on the combinations of swiftly growing electromagnetic instabilities (EMI) arising in the interaction of relativistic electron beams (REB) with precompressed deuterium-tritium (DT) fuels of fast ignition interest for inertial confinement fusion (ICF). REB-target system is taken neutral in charge and current with distribution functions including target and beam temperatures. We stress also the significant impact on modes growth rates (GR) of mode-mode coupling and intrabeam scattering. Collisional damping is documented at large wave numbers in terms of inverse skin depth. A quasi-linear approach yields lower GR than linear ones. One of the most conspicuous output of the linear analysis are three-dimensional (3D) broken ridges featuring the largest GR above k-space for an oblique propagation w.r.t initial particle beam direction. The given modes are seen immune to any temperature induced damping. Those novel patterns are easily produced by considering simultaneously Weibel, filamentation and two-stream instabilities. The behaviors persist in the presence of smooth density gradients or strong applied magnetic fields. Moreover, in the very early propagation stage with no current neutralization in the presence of large edge density gradients, REB demonstrate a characteristics ringlike and regularly spiked pattern in agreement with recent experimental results and previous simulations.

Two basic ways to amplification of spontaneous emission in the soft X-ray region are described. The first is based on the electron-collisional recombination pumping scheme, which uses recombination of fully stripped ions into hydrogen-like ions to create (in the case of sufficiently fast cooling) a population inversion on energy levels belonging to the Balmer-alpha transition. We test this scheme on nitrogen, for which the lasing wavelength is 13.4 nm. The second way to amplification of spontaneous emission is based on the electron-collisional excitation pumping scheme: this uses for creation of population inversion a fast excitation of Ne- or Ni-like ions. However, for wavelength below 15 nm it is necessary to use Ni-like ions of some metal vapors. Feeding metal vapors into a capillary is difficult, and if being fed they deposit on the capillary wall and significantly reduce the capillary lifetime. That is why we prepare metal vapor plasma in a capillary with liquid wall – by wire explosion in water. For slowdown of the plasma-channel expansion a local-water-compression by linearly focused shock wave is being developed.

We analyze the results of a recent experiment performed at the PALS laboratory and concerning ablation pressure at 0.44 µm laser wavelength measured at irradiance up to 2 × 1014 W/cm2. Using the code “ATLANT,” we have performed two-dimensional (2D) hydrodynamics simulations. Results show that 2D effects did not affect the experiment and also give evidence of the phenomenon of delocalized absorption of laser light.

This paper is devoted to investigations of laser energy transfer into solid targets with respect to the focusing lens focal point position relative to the solid target surface as obtained at the PALS laser facility. The third harmonic of the PALS laser beam with energy ~90 J and pulse duration ~250 ps (FWHM) was used for irradiation of two kinds of targets made of Cu: a slab and a 3.6 µm thick foil. The focal point of the beam was located either inside or in front of the target surface, and care was taken to ensure the same laser spot radii in both cases (250 µm). It was demonstrated that these two opposite focal point positions give rise to significantly different laser-plasma interactions: with either depression or maximum of the laser intensity distribution in the center of the beam, respectively. It was also verified that the focal point position inside of the target is favorable for plasma jets creation, whereas the opposite case is more effective for acceleration of flyers.

This paper deals with the study of propagation of electromagnetic wave in a rectangular waveguide filled with an inhomogeneous plasma in which electron density varies linearly in a transverse direction to the mode propagation. A transcendental equation in ω (microwave frequency) is obtained that governs the mode propagation. In addition, an attempt is made to examine the effect of density inhomogeneity on the energy gain acquired by the electron (electron bunch) when it is injected in the waveguide along the direction of the mode propagation. On the basis of angle of deflection of the electron motion we optimize the microwave parameters so that the electron does not strike with the waveguide walls. Conditions have been discussed for achieving larger energy gain. The plasma density inhomogeneity is found to play a crucial role on the cutoff frequency, fields and dispersion relation of the TE10 mode as well as on the acceleration gradient in the waveguide.

Interactions of cone targets with different shapes with laser pulses are studied numerically. Two important parameters which characterize the laser-cone interaction in 2006 are introduced, which are cone angle and ratio of laser spot and cone tip. By changing these two parameters, energy coupling from laser to electrons is controlled. Some fraction of high energy electrons generated at side wall and cone tip are not freely propagating out from the target, but confined around the cone tip due to the disturbed electric field.

In order to restrain the prepulse of a high energy fluence diode, a flash-over switch made of a nylon cylinder was inserted in between the cathode stalk and the cathode. Secondary prepulse technique was developed to lower the flash-over voltage of the switch. It was found that the surface resistivity of the nylon insulator changes considerably after each shot and this resistivity on the order of 107 Ω/m is most suitable for a 20-mm long flash-over switch to operate stably at a lower flash-over voltage.

The plume images of the laser produced silver plasma in the absence and presence of 0.45 T transverse magnetic field has been investigated under vacuum ~10−4 torr and in air. An Nd:YAG laser (1.064 µm, 1.1 MW, 9 ns) with intensity ~1012 Wcm−2 was used to generate plasma. A CCD image capture system was used for plasma imaging to explore the plume. A magnetic probe was employed to measure the variation in internal magnetic field of plasma with as well as without 0.45 T external transverse magnetic field. The X-ray emission from plasma in both the cases (with and without B field) was also monitored using two PIN photodiodes filtered with 24 µm Cu and 24 µm Al. The plume images in both the cases were then correlated with the time resolved soft X-ray emission. It was found that the self generated magnetic field of the plasma increases in the presence of magnetic field. Plume images reveal that the confinement of the plume takes place in the presence of magnetic field both in the cases of air and vacuum. Jet and spikes like structures were also observed due to plasma instabilities. Lobe formation in the plume at latter stages of plasma evolution was more prominent in air than under vacuum. X-ray emission signals exhibited an enhancement in the emission under transverse magnetic field. An increased rate of recombination due to high density as a result of plasma confinement across the applied magnetic field was found to be the main reason behind emission enhancement.

Laser interactions with mass-limited targets are studied here via numerical simulations using our relativistic electromagnetic two-dimensional particle-in cell code including all three-velocity components. Analytical estimates are derived to clarify the simulation results. Mass-limited targets preclude the undesirable spread of the absorbed laser energy out of the interaction zone. Mass-limited targets, such as droplets, are shown here to enhance the achievable fast ion energy significantly due to an increase in the hot electron concentration. For given target dimensions, the existence is demonstrated for an optimum laser beam diameter when ion acceleration is efficient and geometrical energy losses are still acceptable. Ion energy also depends on the target geometrical form and rounded targets are found to enhance the energy of accelerated ions. The acceleration process is accompanied by generation of the dipole radiation in addition to the ordinary scattering of the electromagnetic wave.

We study the generation of high-order harmonics from plasma plume, by using the 20 TW, 10 Hz laser of the Advanced Laser Light Source (ALLS). We perform detailed studies on enhancement of single high-order harmonics generated in laser plasma using the fundamental and second harmonic of the ALLS beam line. Quasi-monochromatic harmonics are observed for Mn, Cr, Sb, Sn, and In plasmas. We identify most of the ionic/neutral transitions responsible for the enhancement, which all have strong oscillator strengths. Intensity enhancements of the 13th, 17th, 21st, 29th, and 33rd harmonics from these targets are demonstrated using the 800 nm pump laser and varying its chirp. We also observed harmonic enhancement from some targets for 400 nm pump laser. Using Mn plume, we demonstrated the highest harmonic photon energy (52.9 eV) at which enhancement has been observed (17th order, λ = 23.5 nm).

The use of laser-accelerated protons as a particle probe for the detection of electric fields in plasmas has led in recent years to a wealth of novel information regarding the ultrafast plasma dynamics following high intensity laser-matter interactions. The high spatial quality and short duration of these beams have been essential to this purpose. We will discuss some of the most recent results obtained with this diagnostic at the Rutherford Appleton Laboratory (UK) and at LULI - Ecole Polytechnique (France), also applied to conditions of interest to conventional Inertial Confinement Fusion. In particular, the technique has been used to measure electric fields responsible for proton acceleration from solid targets irradiated with ps pulses, magnetic fields formed by ns pulse irradiation of solid targets, and electric fields associated with the ponderomotive channelling of ps laser pulses in under-dense plasmas.

The aim of the reported research is to contribute to investigation of new processes and methods interlinking nuclear and laser-plasma physics. With respect to requirements of nuclear experiments at medium-size high-power lasers, the selection of proper candidates for studying the excitation and decay of low-lying nuclear states is reviewed. An experimental approach to the identification of low-energy nuclear transitions is discussed, simple estimates of the 181Ta excitation yield in the laser-generated plasma provide a theoretical basis for planning future work. First tests and results of the experiments at the laser facility PALS are presented.

The impact of nano-structured surfaces on particle generation from ultrashort intense laser produced plasmas is presented over an intensity range of 1015–1017 Wcm−2. The nano-structured surface evidently produces hotter plasma but does not lead to the generation of hotter ions, a counterintuitive result based on present understanding of plasma expansion mechanism. Although the total ion flux and energy is more in the case of structured surfaces, the average energy of the projectiles is found to be lower than that from polished surfaces. The nano-structured surface shows preferential enhancement of lower energy ions and an intensity dependent divergence of the ejected particles.

A nanosecond pulsed Nd-Yag laser, operating at an intensity of about 109 W/cm2, was employed to irradiate different metallic solid targets (Al, Cu, Ta, W, and Au) in vacuum. The measured ablation yield increases with the direct current (dc) electrical conductivity of the irradiated target. The produced plasma was characterized in terms of thermal and Coulomb interaction evaluating the ion temperature and the ion acceleration voltage developed in the non-equilibrium plasma core. The particles emission produced along the normal to the target surface was investigated measuring the neutral and the ion energy distributions and fitting the experimental data with the “Coulomb-Boltzmann-shifted” function. Results indicate that the mean energy of the distributions and the equivalent ion acceleration voltage of the non-equilibrium plasma increase with the free electron density of the irradiated element.

Survival of the production target in successive experiments (with a repetition rate of 1 Hz) over an extended period of time is one of the key problems encountered in designing the Super-FRS (Superconducting Fragment Separator) at the future Facility forAntiprotons and Ion Research (FAIR). Because of the difficulties involved in construction of a liquid jet metal target, it is highly desirable to employ a solid production target at the Super-FRS. However, with the high beam intensities that will be available at the FAIR, the production target may be destroyed in a single experiment due to high specific energy deposition by the beam in the target material. The level of specific energy deposition can be reduced to an acceptable value by increasing the beam focal spot area. However, the spot size is limited by requirements of achieving good isotope resolution and sufficient transmission of the secondary beam through the system. The resolving power of the fragment separator is inversely proportional to the X-dimension of the focal spot whereas the transmission depends on Y-dimension only. It has been previously shown [Tahir et al., 2005c] that an elliptic focal spot with appropriate dimensions, will fulfill the above two conditions simultaneously and will also have a large enough area to reduce the specific energy deposition to an acceptable level for certain beam intensities of interest. In this paper we present numerical simulations of thermodynamic and hydrodynamic behavior of a solid graphite target that is irradiated by 1 GeV/u uranium beam in the intensity range of 1010 –1011 ions per bunch with a bunch length = 50 ns. These simulations have been carried out using a three-dimensional computer code, PIC3D, that includes elastic-plastic effects. This theoretical work has shown that up to a beam intensity of 1011 ions/bunch, one can employ a solid target while for higher intensities the target will be destroyed due to thermal stresses induced by the beam. It has also been found that a circular focal spot leads to minimum thermal stresses as it generates minimum pressure gradients compared to an elliptic focal spot, for the same specific energy deposition. Moreover, the stress level increases with an increase in the ellipticity of the focal spot. It is therefore recommended that one should use a circular focal spot for lower intensities provided that the criteria for isotope resolution and transmission are fulfilled.

A microscopic eikonal theory based on photon wave mechanics is established. The diamagnetic (solid state) field-plasma interaction is shown to play a central role in the theory, and this interaction enables one to introduce a massive transverse photon concept. This quasi-particle enters the eikonal theory in manner similar to the one in which the classical point particle enters Newtonian Mechanics in the Hamilton-Jacobi formulation. When the spatial fluctuations in the stationary-state plasma density are of importance the microscopic eikonal theory becomes a spatially nonlocal theory, and the nonlocality, originating in the coupling of longitudinal and scalar photons to the massive transverse photon, extends over near-field distances.